How to install the EZ1105 driver?

Generally, buying a printer will come with a disc driver, if you don't have it, you will root your model**good,Right click on my computer,Manage --- Device Manager--- your printer will have a yellow exclamation mark to update the driver--- install from the designated location of the list--- select your ** driver.

Not bad, yes, landlord, you have worked hard...

If you want to drive, connect the printer data cable to the computer and open it, the next driver master, drive scan, and the uninstalled device will be displayed, just select the printer item to install.

You have to use a barcode technical engineer to answer for you.

Is your situation that the label is walking, and the ribbon ** shaft does not rotate, resulting in the ribbon not leaving?

If this is the case, it may be that you have set the printing method to thermal mode, and you can change it back to thermal transfer.

There is also a situation where the error is reported when it has been printed, and the ribbon shaft does not rotate after a turn, which is that the ribbon shaft is not stuck in a good position, or it is reversed.

Another possibility is that the above two did not happen, ** axis is rotating, the printer does not report error, the ribbon is not gone, the printed words seem to have a drag, play a few more ribbons to break, this situation is only a little bit left when the ribbon is left, there is no good way to do this, can only replace other models of ribbons, the reason for this failure is that the quality of the ribbon film is poor, the thickness is not enough.

For system problems, it is recommended to reinstall the system. It's troublesome, but it's the best solution

After installing the driver, you also need to install the software, you need to design the label barcode in the software, and then print it out by calling the driver. Provided by Shandong Qingdao Aixun barcode technical team.

When you install it, you will be prompted to install the source program to**, after you install it, click (Start) (Setup) (Printer & Fax), then add the printer, then select the printer, then select Install from disk, and then find the file you saved after installing the driver, the name of the file is (godex.).) and then install it.

You need to install a driver, so we recommend that you use QDRS to check it.

Also choose a lung printer port to see. open port fault--- open port fault.