How do I install and install an optical drive?

To resolve this issue, follow these steps:

1.Open"Registry"(Run: regedit).

2.Find the value of upperfilters under the following registry key:

3.On the menu, click Delete, and then click OK.

4.Find the value of lowerfilters under the same registry key:

5.On the menu, click Delete, and then click OK.

6.Exit"Registry"。Remarks:

After removing the UpperFilters and LowerFilters values, you may need to reinstall a particular program, such as CD recording software, if you notice that the software is missing functionality. If the problem is repeated, please consult the software vendor for help.

7.Restart your computer.

Warning:"Registry"Improper use can cause serious problems that may require a reinstallation of the operating system. Microsoft does not guarantee that it will be able to resolve the cause"Registry"Problems arising from improper use.

use"Registry"You do so at your own risk.

1. Poor contact.

2. After removing the light area, install it again.

Check that the cable is connected.

Find a matching program.

If it really doesn't work, send it to a professional to fix it.

01 First remove the bezel on the front panel of the chassis for installing the optical drive, and then reversely install the optical drive from the front panel of the chassis into the inch slot of the chassis. Make sure that the front panel of the optical drive is aligned with the chassis, and then make gradual and detailed adjustments before tightening the screws.

The optical drive is an important part of the computer to read data files or systems. Especially when the system crashes, the computer cannot boot and the system can only be reinstalled through the optical drive.

To install the cable, the installation steps are similar to those of the hard disk. However, it should be noted that the data cable only uses an ordinary 40-pin IDE data cable, and it is recommended to insert the data cable into the second IDE slot of the motherboard, so that there is no need to set the master and slave jumpers of the optical drive and hard disk.

Both the 40-pin and 80-pin IDE cables have three plugs, one of which is connected to the motherboard IDE slot, and the other two can be connected to the master and slave IDE devices respectively. If you only have a hard drive and an optical drive, it is recommended to connect them to the two IDE slots on the motherboard, which will improve the efficiency of the system and prevent some seemingly inexplicable problems.

Connect the optical drive to the audio cable, insert one end of the audio cable into the audio cable connector on the rear panel of the optical drive in the correct direction, and insert the other end into the socket marked with CD-IN on the sound card. Note that the audio cable connector will be marked with an arrow (usually in the white line).

First remove the front panel of the chassis to install the baffle of the optical drive, then reverse the optical drive from the front panel of the chassis into the inch slot of the chassis, confirm that the front panel of the optical drive is aligned with the chassis, and then start to install the data cable, one of the middle is connected to the IDE slot of the motherboard, and the other two can be connected to the master and slave IDE devices respectively, insert one end of the audio cable into the audio cable interface of the rear panel of the optical drive in the correct direction, and insert the other end into the socket marked with CD-IN on the sound card.

An optical drive is a machine used by a computer to read and write the contents of a CD, and it is also a common part of desktop and notebook portable computers. With the application of multi-** more and more extensive, optical drives have become standard in many computer accessories.