Why can t NOKIA e63 go online

You try this way.

Connection Type: GPRS (GPRS preferentially by default, GPRS is recommended to be changed to GPRS) GPRS Settings: There are four options after entering here, namely APN, username, password, and waiting time, here you only need to set APN, username and password are empty, and the waiting time is 180 by default.

APN is set to: CMWAP

CSD Setting: This option does not need to be set.

After the settings are complete, press the left soft key to save, then go back to the previous menu to select the setting, and select "Start".

China Mobile MMS (GPRS) Basic Settings2007-01-26 PM 05:15 Main parameters to be set:

1) Connection name: China Mobile MMS (GPRS).

2) Data bearing mode: GPRS

3) Access Point Name: CMWAP

4) Username: None.

5) Password: None.

6) Identification: Ordinary.

9) Connection Security: Off.

10) Connection Type: Permanent.

1.Go to the interface of "Wireless & Network" through the main menu.

2.Hook Mobile Network.

3.Go to "Mobile Network Settings".

4.Hook "Enable always-connected mobile data" on.

5.Click on "Access Point Name" and you will find only two options: "CMNET" and "CMWAP".

6.Click on the "Menu" button, select "Reset to Default", and select CMNET (the dot after it turns green).

7.Go back to the previous level.

8.This is the most critical, I don't tell him yet, after you set the network as a CMNET access point, after opening the mobile network, click on the "**" on the home page of the mobile phone, click **, then a hidden menu will appear, click on "mobile phone information", slide to the last item "DNS", and change the display of DNS to: allowed, you can.

I'm here to eradicate illiteracy! China Unicom 3G literacy.

This requires setting up a network access point, also known as an APN setup. Specifically, the main menu - Tools - Settings - Connections - Access Points, press the option, select "Add Access Point", and fill in the corresponding interface as follows:

Connection name: This is whatever you want, it's just a name, you yourself know that this is a 3G access point, mine is written 3G, it is recommended not to write Chinese.

Data bearer mode: group data.

Access point name: 3GWAP (this must not be wrong, it doesn't matter if it is case-) Identification: Normal.

Nothing else is left to chance.

At this time, press the option again, select the "Advanced Options" inside, and fill in the following content in the corresponding interface:

Network type: IPv4

**Port Number: 80

Nothing else is left to chance.

This is the 3G access point setting is OK, in the future, when using Internet software, such as QQ, there is an access point option in the menu after opening QQ, select the access point you set is OK.

If the access point is not set, select UMTS as the network mode, create a new access point with the name of 3GNet or 3GWAP, and select these two access points to access the Internet.

In addition, although E63 supports 3G, the previous version of E63 does not support HSDPA high-speed network (that is, it is commonly called, so its **speed is estimated to reach 60K S, I heard that the current E63 seems to support HSDPA, **speed up to 200K S).

Hello, mine doesn't have this situation, and you don't need any special settings, you can change the access point and try it. However, even if China Unicom3G Xiaosan's Internet speed is not very fast,Browsing the web is even slower than mobile 2G card,**The speed is about 40k s,No way,Hardware configuration is not good!

Yes, it needs to be set, and the network mode should be right to choose umts, whether the network signal in your area is not good enough.