Laptop wireless Internet setting problem, have bought a wireless router

Is the wireless router set up If it is not set up first, after setting it up, turn on the computer The wireless network card switch will flash after it is turned on, and then turn on the network or online neighbor Search for the wireless network Search for the point connection out of the dialog box No matter the point is still connected, you can go to the Internet When you connect, there is an automatic connection dialog box below Lay down the ditch So that you can turn on the computer in the future.

You can reinstall the system and wire it to your notebook.

It should be that the route is not set up.

Routes can be set as follows:

The network cable behind the dial-up modem is connected to the access entrance of the wireless router, and the network cable exit after the routing is connected to one of the computers with a network cable.

2.Enter the route from the connected computer (enter in the IE address bar, the user name and password are admin, the manual has), the page prompts the pop-up "Setup Wizard", click Next, select PPPoE mode, next, fill in the account password you dialed, select auto-dialing, save, and it's OK;

If the "Setup Wizard" does not pop up when entering the route, directly click the network parameters on the left - > WAN port setting - > select PPPoe mode - > fill in the account and password you dialed - > select auto-dialing - > save, and you're OK;

Different routers are all similar, all choose WAN->PPPoe-> enter ADSL account password >auto-dial->save).

Start --- run -- enter "cmd" ping router address (usually yes).

nslookup check it out!

What if you don't use the route to open the web page or go to Q directly?

If you want to set the problem, you can check whether the account password of the dialer is correct and whether it is set to automatic dialing in the routing setup wizard.

Does your wireless router have a password? It is recommended that you refresh your wireless network, then find the signal of your wireless router, and then enter the password if you have set it and connect.

In the future, you have to turn on the router first, and then turn on the laptop wireless network card, and the laptop will log in to your router first. Doesn't look for other wireless signals.

Go to Router Settings and reset the pope broadband dial-up connection.

Your router has not been dialed successfully, see if the network cable is not connected.