How to renovate the old wardrobe and how to maintain the wooden furniture?

Refurbishment of wall-embedded wardrobes should be carried out depending on the wear and tear. The following is an introduction to several common wear and tear situations and solutions for embedded wall wardrobes. First:

The original fireproof board is warped. In this case, the original fireproof board can be removed and the new fireproof board can be re-pasted. Second:

The original Polaroid plate is warped. In this case, the process of shoveling first and then re-pasting is also adopted. Third:

The original plywood surface became old. Revarnish can be repainted, which is cheap but not effective; Or brush white hand sweep paint, the effect is very good, but **slightly expensive. Fourth:

The original veneer is getting old. In this case, it can generally only be re-sanded and painted with the same type of paint as before, but the effect is not very obvious. Wooden furniture can easily lose its luster if it is not maintained regularly.

Dusting furniture is the most basic care work. Use a soft cloth dipped in some spray (Bilizo) along the grain of the wood to dust the furniture, but do not wipe it with a dry cloth to avoid scratching the flowers. Daily protection is also very important, as much as possible with a mat under the hot plate to prevent the soup stock from spilling, staining or damaging the tabletop.

Try to avoid exposing furniture surfaces to corrosive liquids, alcohol, nail polish, and lacquer removers. When solid wood furniture is used in a drier environment, artificial humidification measures are more necessary. Such as:

Wipe down furniture regularly with a soft cloth dampened in water. And every six months to a year, the furniture should be waxed regularly. It is best to wax furniture with paste-like wax, and the old wax should be wiped off with mild, non-alkaline soapy water before waxing.

When furniture is scratched or needs to be repaired, the easiest remedy is to use a cotton ball or paintbrush to apply shoe polish of similar color to the surface of the furniture; If you remove the water stains on the surface of the furniture, you should spread clean absorbent paper on the water traces, press it on it with a heating iron, and you can also use salad oil and toothpaste to apply, and then wipe it dry and wax; To remove white marks, the best way is to apply a cloth dipped in soot mixed with lemon juice or salad oil, dry and wax.

Anti-rust lubrication and maintenance of hinges or hinges to prevent rust from affecting the appearance, and the switch is quiet and smooth.

Well-known wardrobe brands such as Senge use hinge grease for doors and windows from Tiger Head Hotolube. Colorless and transparent, good adhesion, good durability, food-grade safety certification, suitable for household use. There are 130 grams of tubes in the hedge.

When using, apply directly to the hinge or hinge, and switch it on and off a few times. The maintenance interval is half a year.

Do not use lubricating oil and regular butter on hinges and sliding door slides, as the lubricating oil will be lost quickly. Regular butter will have a harmful smell that is not good for the human body.

1. Old wooden cabinets can be refurbished with paint, which is the most commonly used way to renovate. 2. You can also renovate the wallpaper, which is much simpler than the first method. Related knowledge popularization:

1. There are many types of paint renovation, including primary color renovation, color renovation, and color change renovation. Primary color renovation, which needs to be based on the age of the wardrobe to decide whether it needs to be doxxed, after doxxing we need to carry out a thorough polishing, and then we can repaint the original color for primary color renovation. 2. Additive color renovation, for example, the color of the wardrobe becomes old and not bright after a long period of use, at this time, you can carry out additive color renovation, we can deepen the color directly on the basis of the original paint color, and then apply varnish for protection.

3. Change the color and renovate, for example, the wardrobe has been used for too long, the color is tired of seeing, and you want to change the color to see, which needs to be changed and refurbished. Color change and renovation are more complicated, and it has to go through steps such as removing grease stains, scraping oily putty, sandpaper sanding, oiling color, and brushing varnish. 4. If you feel that painting is complicated and troublesome, then we can directly use the method of pasting wallpaper to renovate, which is particularly simple.

Solid wood furniture is a type of furniture that is durable, but it will also leave traces of time after a long period of use. At this time, the owner needs to renovate and maintain the solid wood furniture. However, how to renovate solid wood furniture when it is old?

What are the maintenance methods? Let me introduce you!

1. Dentation treatment.

Solid wood furniture has a dent, you can first wipe the dent with a damp cloth, after a while to see if it swells due to water absorption, if there is no change, you can put a wet cloth on the furniture, and then iron it with an iron at low temperature to make the recess swell, and then smooth it with fine sandpaper.

2. Scratch treatment.

Scratches are a common problem on solid wood furniture, and it is also the main reason why solid wood furniture becomes mottled, when we find that there are scratches on the surface of solid wood furniture, you can apply a layer of cod liver oil on its surface, and wipe it after a day, simple and convenient.

3. The topcoat falls off.

Rub once or twice with half a cup of water and 1 4 vinegar, or with alcohol, toilet water, or tea dipped in a soft cloth, and then wipe the floor wax again. At the same time, this method can also remove the traces of whitening on the paint surface.

Fourth, daily cleaning.

Wood has the characteristics of thermal expansion and contraction, easy to be corroded, etc., so when wiping solid wood furniture, it is good to wipe it with a wet fine rag, and it must not be washed with hot water, alkaline water or disinfectant water, so that the residual temperature or chemicals will destroy the paint on the surface of the furniture, and the gains outweigh the losses.

5. Daily maintenance.

Solid wood furniture should not be placed in places that are too wet, too humid, too high in temperature, near vents, radiators, etc. In normal times, the dragging of furniture should also be minimized, so as not to affect the internal structure of solid wood furniture and cause unnecessary losses.

The above are the five key points of solid wood furniture renovation and maintenance that I brought, I don't know if it will help friends who are preparing for furniture renovation?

1. If the painted furniture is contaminated with dust, you can wrap the wet tea residue with gauze and wipe it, or scrub it with cold tea, which will make the furniture particularly smooth and bright.

2. Use a clean rag to soak it in the expired milk that cannot be drunk, and then use the rag to wipe the table and other wooden furniture, so that the effect of removing dirt is very good, and finally wipe it again with water. If the wood furniture is burned by matches, etc., you can first return it to wipe it with half a lemon, and then wipe it with a soft cloth soaked in hot water. Finally, use a dry soft cloth to quickly dry and polish it, and it will return to its original state.

3. Mix the same amount of white wax and hot water to wipe the surface of the furniture, and then rub it vigorously with a soft cloth. This method is suitable for the maintenance of mahogany furniture and the cleaning of other furniture contaminated with ink. Rattan furniture has been fouled for a long time, which not only affects the appearance, but also is very unhygienic, but it cannot be brushed with ordinary detergents so as not to damage the rattan.

The best way to do this is to scrub with salt water, which not only removes the stain but also makes the rattan soft and elastic.

Use 120 grit coarse sandpaper to polish the damaged area, and rent a vertical filial piety to remove all the wood wax oil or paint on the solid wood.

Use 240 mesh fine sandpaper or finer sandpaper to polish until the hand is very delicate to the touch, and there are only small fine marks. It is best to sand along the wood grain.

You can wipe the dust with a damp towel and dry it naturally. Wipe off dust and dust.

Give the furniture an environmentally friendly water-based wood primer, water-based paint with water as a thinner, and there are few harmful substances in the manuscript, so after drying.

Water-based wood topcoat. Apply every 2-4 hours, each time the surface should be dry and placed in a ventilated place. If dust falls on it, beat it off with sandpaper.

<><How to renovate old wooden furniture?

1. Make preparations

1. Spread newspaper on the floor first, then open the doors and windows to ensure adequate ventilation. Place the wooden furniture to be painted on the newspaper. Before you begin, wear a mask and gloves. Suspicion.

2. Use a screwdriver to remove the hardware on the furniture. If you're going to paint a chest of drawers or dresser, remove the hardware on it before you begin. This has two advantages: one is to ensure that the paint is not brushed on the hardware; The second is to replace the hardware with new or complete painting.

3. Use glue joint agent (putty) to repair notched, holey, and dented notches. Use a putty scraper to scrape off any excess glue and allow the glue to dry.

4. Use sandpaper to polish the surface of the furniture. This is done to remove protective varnish or paint from the surface of wooden furniture, making it easier for the primer to adhere to the furniture. If there is an unevenness in the area where the grout is applied, it should also be sanded fully with sandpaper, so that the place where the grout is applied is flush with the rest of the furniture.

5. After sanding the surface of the furniture, use a clean coarse cloth to gently wipe it to remove the residue and make the surface of the furniture clean and tidy. If desired, you can use a mild detergent and then dry the surface of the furniture with a cloth.

2. Start priming and brushing

1. If you want the furniture to look uniform in color, apply a layer of primer. Gently apply a primer to the surface of the wooden furniture with a paint brush and roll with a roller. Paint brushes are used to brush edges, corners, and hard-to-reach areas; Roll a large, uniform area with a roller that does not have a wavy shape.

Wait for the primer to dry before painting.

2. After the primer is dry, polish the surface with a bucket of fine-grained sandpaper. Sanding with sandpaper allows the paint to adhere better to the primer.

3. Start painting, first with a roller, then with a paint brush. If possible, roll the evenly with a foam roller and then repaint it evenly with a paint brush. Pay special attention to which rollers can't be brushed, such as corners.

Wait for the paint to dry and check to see if there are any unpainted pins.

4. If necessary, brush another layer of paint. According to professional paint craftsmen, one layer of primer and paint is not enough to produce a professional effect, wait for the first coat to dry (preferably overnight, at least 6 hours), and then brush the same paint again with the above method.

5. Brush protective paint (optional). Once the paint is dry, apply varnish or sealant to avoid nicks and scratches. This also adds a slight sheen to the furniture.

6. Wait for the paint to dry and the painting work will be over!

Dear, I am glad to answer for you the renovation methods of old log furniture are as follows:1Gasoline 2Water 3Rubber water 4Sandpaper 5Brush 6Paint 7Cloth.

First, use coarse sandpaper to polish it first, don't polish too much at the corner, and try to keep the original shape of the furniture. 2. Wipe the polished powder clean with a soft cloth dipped in water. 3. For the first time to brush the paint, first use a brush to dip a small amount of paint in the paint bucket, from top to bottom, from left to right, corners and hidden places should also be rented and brushed.

Fourth, the furniture is dried, and the furniture that has been painted is placed for four or five hours, and the paint is allowed to dry naturally, waiting for the paint to dry. Fifth, polish again, after the paint is dry, take the fine sandpaper and polish it again. Polishing the uneven area flat, so that it is easy to brush the oak paint again later.

Sixth, the second time to paint, here need to pay attention to the paint is too thick, can be properly added rubber water to neutralize and dilute. Continue to dry and sand. Paint it a third time.

Wait again to dry.