What should I do if the network is disconnected at a fixed time and the router is disconnected at a

Hello askerThank you very much for your question.

When the 24 hours are up, it will be disconnected again", is it 24 hours from the start of each dial-up to the Internet, or is it disconnected at a fixed exact time?

If it is the former, it should be a problem with your router's WAN settings, or it may be caused by the heat dissipation of the router or the poor performance of the router itself, or it may also be the following problem.

If it's the latter, I'm sorry to tell you that this is a hard restriction on the local operator of ADSL access to prevent the use of the ADSL service to set up web services, and there is no way on your side except to keep complaining about this operator

Supplement: You can ask some nearby friends who use the ADSL** service as you do to see if they have the same problem with this timed disconnection as you.1If they also have, then ask the latter reason you encountered above, the same method as above.

2.If they don't, but you have this situation alone, then, the reason is the former, the same is true for single access to the modem, you can eliminate the problem of the router, the key point of the problem is: the cat and the PC side settings, the troubleshooting of these two devices, it is recommended that you use the "swap method", they are used interchangeably with other identical devices, you can quickly find out the problem device, and then this problem can be solved.

Summarizing the supplementary description of your problem, the judgment is as follows:

Excluding cats and PCs, the maximum possible is:

This is a hard restriction on the local operator of ADSL access for you, the purpose is to prevent the use of ADSL resources to privately set up web services (involving economic and legal issues), which should have clear terms in the ADSL service contract provided to you by the operator, but some local operators implement it strictly, such as using this method, every 24 hours after dialing in to force the line to be disconnected, and some local operators are lax, for the time being, because each disconnection is not long, If you don't have a special need, I personally recommend not to pay too much attention to this matter, if you are particularly concerned, the only way is to keep complaining about the ADSL service of this operator, :-

Also, you can ask some nearby friends who use the ADSL** service like you to see if they have the same problem with this timing disconnection as you).

End, the problem is solved, and if in doubt, asker continues.

There should be an idle disconnection time in the router's WAN configuration (WAN) for you to take a look. Change it to 0 or keep it on.

Don't use routing, that's how telecom breaks you off voluntarily Some places will use this very dirty means in order to prevent users from hanging up, it seems that the telecom in your place is like this, bear it, brother, no way, if you have experience, you can sue telecommunications, and if you don't win, you don't know.

The reasons are as follows: 1. During the peak period of network use, the network is slow and leads to the loss of the Li Peng line.

2. There is a problem with the router configuration, and the router needs to be reconfigured.

Solution: There is a reset button behind the router to eliminate the router and press and hold it for five seconds, and the indicator light on the router panel will be off and then on again, and you can reset the setting.

Router drops at a fixed time every night Reason:

Cause 1: During peak network usage hours, the network is slow and the connection is dropped.

Cause 2: Router configuration is faulty and the router needs to be reconfigured.

Reset Router Method:

Method 1: There is a button [RESET] button on the back of the router, press and hold for 5 seconds, and the indicator light on the router panel will be off and then on, which means that the settings have been reset.

Set up router dialing:

The IP and DNS settings of the computer are automatically obtained.

1. Open the browser - enter the general router address is this or view the login information on the back of the router) Enter the route - enter the user name and password, (the default is generally admin).

2. In the [Setup Wizard], select [PPPoe Dialing] (some are ADSL Dialing), enter your Internet username and password according to the prompts, and save.

3. In [Network Parameters] --WAN Settings], select [Normal Mode], and select [PPPoe Dialing] in the three options of [Connection]. The next step is to select [Auto Connect], Save, and Exit.

Reason 3: Router hardware is damaged.

Workaround: Replace the router with a new one.

If the broadband network is disconnected at a fixed time, you can view and solve it in the following ways:

1. Whether you enter the router and make relevant settings, whether it is an IP address assigned by DHCP, the rental period is generally 1———2880 minutes, the rental period is shorter, or other time restrictions, set up no time limit, automatic connection;

2. Check the logs of the router, which can provide a reference to help analyze the cause of the problem. ；

3. If you can't find the reason, click the reset in the route, restore the factory settings, and then log in to the route again.

Hello, I have seen your question, I am sorting out the answer, in order to give you an accurate answer, you need to consult a lot of information, the waiting time may sometimes be a little long, please be patient for a while, I will reply as soon as possible, thank you!

1.Open the Control Panel",Many people can't find the control panel of the win10 system in**,The method is very simple,In the lower left corner - right click - the familiar control panel can appear。 2.

Go to the control panel, click on the upper right corner, select the view as a large icon, and find the device manager. 3.Find the network adapter, select the network card to which you want to connect locally, right-click, and select Properties.

4.Above the title bar, switch to Power Management and uncheck "Allow the computer to turn off this device to save power". Click OK.

5.You can also right-click the network connection icon in the lower right corner of the computer, open the Network and Sharing Center, left-click the network to enter the network connection settings, select Properties--Configure, and enter the same settings as before.

1. See if there is any impact on the task plan.

2. Firewall upgrade may cause disconnection, check it.

3. Try to reinstall the system.

4. Check the model settings to see if there is any expiration date like the router.

Try a different antivirus.

It feels like the problem should be with telecommunications.

Hit ** again, or ask them to change the port for you in the computer room.

Addendum: I still recommend that you redo the system or restore the backup. In this case, the problem should be with the system.

Using a computer is a learning process.

So don't give up trying!

It is estimated that the number of people who go online during this period is relatively large or the network department is stable.

The router is broken or not set up properly.

It's a very simple problem.,It's likely to be a MAC address problem.,Call a person from the network company you installed to deal with it for you.,Pay attention to tell him all your situation.,Let him help you solve it.,Anyway, we don't charge door-to-door service fees here.,I don't know what you guys do.。 It's not a hassle to fight, once and for all, how good it is.

If there is a network outage at a fixed time every day, it is due to two reasons:

The first reason: this is the router has been attacked by DDS, the other party knows the IP address of your router, so the use of DDS attack software on the computer, set up a fixed time to attack your router, so that the router data traffic is blocked, so that the network is blocked, or even interrupted, so the network is disconnected, when this period of time passes, the software does not attack, and the network returns to normal. In general, in this case, you can only press the restart of the router to restore the router to its factory value, then turn off the power, and re-plug the network cable, then plug it back in, and turn on the anti-DDS attack on the router, lock the IP and MAC address of the network card, you can effectively prevent this attack.

The second reason: the system has also been attacked, the Trojan has entered your computer, the Trojan has also set a time period, when the set time, the virus is automatically activated, and then specifically attacks the network port, which causes the network to be unable to enter the computer's network card, and the network is naturally disconnected. Generally, in this case, you can only reboot the computer, press F8, enter the safe mode, in the safe mode, use QQ butler to fully disinfect the virus, and some also use antivirus software, such as Kingsoft Antivirus, 360 antivirus software, antivirus, after the virus, restart the computer OK.

In this case, the address lease period is generally expiring, and it is best to bind the IP address in the router or local network to solve this situation, so that the network will not be disconnected in the future, and if you use tools such as WIF wizards, then you need to set the sleep time in these tools.

If the router needs to support Internet access, take TPLink WR886N as an example, perform the following steps:

1. Open the browser, enter, enter;

2. Enter the router password and click OK.

3. Click Internet Control - Quick Settings;

4. Enter the host IP access you want to restrict;

5. Set the port limit in this step.

6. Set the allowed time according to the demand;

7. Give the rule a name and click Done.

Hello, you said that this situation is generally caused by carrier lines, cats, routers, etc.

1 Check the crystal head of the lower network cable, the crystal head of the ** line, whether there is aging and rust, if it does not work, it will be redone, or it will not have an impact.

2 The cat has been left open for a long time, it is very hot and hot, it is recommended to place the cat in a ventilated place as much as possible, and do not overlap with the router. so as not to overheath the temperature. It's really not good to recommend changing a cat with good performance (I hit ** to go to telecom, free to change).

3 Several computers share the network, because the router is too poor, others use P2P to watch movies, etc., it will drag the router to death, restart the router will be better, the long-term solution is to change to a better enterprise-level router.

4. The operator's computer room is far away from your home, beyond the ADSL distance, line failure, etc., then ask them to measure the signal strength and line situation (sometimes two lines, one can be connected to the Internet if one is broken, but the network speed is slow, easy to drop, ordinary people can't find it).

Please find the problem from the above points, I hope it can help you!!

I don't understand hi me, I can teach you to analyze and solve it step by step!!

Whether to drop it, or how long to drop. You can call** to ask customer service, it may be system maintenance.