CAD2004 mini version can t be installed

This is caused by the incompatibility between win7 and the lower version of CAD, you can refer to the following I wrote a post, note: I have installed CAD2006 in WIN7, CAD2004 has not been tried.

Briefly tell you a few points:

1.Installing 32-bit Win7 is no different from installing 32-bit XP, except for the interface.

2.Try not to install low-version CAD in Win7, because Win7 has poor compatibility--- although the ads blow well.

3.Even if you can install a lower version of CAD, third-party plug-ins give you a headache, and many of them can't be installed.

4.Win7 can install a virtual XP system, but it is very resource-consuming, slow to run, not recommended.

5.If you are always using a lot of older software, the most correct way is to format the C drive and reinstall the XP. Dual systems are not recommended and are too wasteful of resources.

6.If you don't have to use ACD in Win7, please use a higher version of CAD, such as CAD2010, CAD2011, CAD2012

Hello, the registration code is incorrect or the authorization number is not working.

If you're sure it's okay, it's that the system's registry doesn't.

If you can't solve it,You can try the next cracked version or green version.,I'm now win7cad2004 no problem at all.。

Is your graphics card using an official driver?

Maybe it's a conflict.

CAD2004 is not compatible with W7 system, can only be installed but cannot run It is recommended to use CAD version above 2008

How to send it to you, nothing was left. I'm okay with this, I don't know if you want it.

I can open it, or I'll pass it on to you.

It may also be in conflict with other software on your computer.

Activated?

Or you didn't crack it.

Since it's a mini version, you still want powerful features, don't think about it, let's install a full version. We're all in the door!!

Just run the installation file, nothing special.

Double-click the AutoCAD2004mini application.

Then just click Accept.