What are the water and electricity problems that need to be paid attention to in the decoration of n

Some people have said about materials, so let's talk about construction. The wires should be kept in their entirety and there should be no connectors. Conduit discharge needs to be horizontal or vertical.

Strong and weak wires cannot wear the same tube, the gap between strong and weak electrical sockets should be ensured to be more than 400mm, and the strong and weak wires need to be pasted with aluminum tin foil in the handover part (these are to prevent strong electricity from interfering with the normal transmission of weak signals). The cold and hot water pipes should not intersect, the surface layer should not touch, and it is best to have a gap of about 150mm in the middle. If it is necessary to intersect, it is necessary to add thermal insulation in the middle.

The intersection of hot and cold water pipes will reduce the service life of the water pipes. There is also a bathroom balcony waterproof, generally in addition to the waterproof of the ground, the wall 300mm position should also be waterproof, otherwise the ground moisture will come up, affecting the back of the wall and door cover. Cause mold in the door sleeve and the wall to fall off.

If it is a new wall, the entire wall needs to be waterproofed. In addition, the sewer pipe must be tested before being put into use, whether it is smooth and whether there is any foreign matter blockage.

First of all, you have to have a good choice in the pipes and fittings of the waterway, and you must buy high-quality products, such as Rifeng and Jinde.

In this part of the line, the kitchen, bathroom, and air conditioner should use 4 square lines, which is the national standard.

Then the switch socket elsewhere, the square wire is enough.

The key point is that you need to consider the location of some electrical appliances that will be used in the home in the future, and then direct the power supply to avoid the trouble of using it in the future.

The waterproofing of the bathroom must be done well, otherwise, it will not only be inconvenient for you, but also cause losses to your neighbors!

1. In principle, the direction of water and electricity pipes is horizontal and vertical, and it is best not to connect with tees and 90-degree elbows for wire pipe connections.

2.There can be no connector in the middle of the wire, and the air conditioning line is used as a special line.

3.The elbow of the shower head's spout should be absolutely straight, otherwise it will leak later.

The rest is a big deal.

When renovating a new house, everyone is very interested in home water and electricity engineering. The renovation of water and electricity projects is also a concealed project of home improvement, which is too important. Any small mistake can pose a safety risk to the renovation of the entire new home.

Therefore, the relevant content of the precautions for the decoration of water and electricity in the new house must be strictly observed. Below, let's learn about the decoration and hydraulic strategy of the new house together with the decoration network. Hydropower decoration for new house decoration strategy Hydropower decoration precautions, circuit decoration waterproof precautions, new house hydropower decoration precautions:

The circuit design should take into account all possibilities, usability, and feasibility, and confirm it repeatedly. The flexibility of the circuit is also an important factor. You know, concentrating electrical plugs on one power strip does work better than filling up a wall outlet.

The distance between the socket and the ground is usually 30 cm and cannot be less than 20 cm. If you set up a low cabinet or tatami mat, you can increase the distance from the ground appropriately. At the same time, keep some distance between the short cabinet and the wall.

Otherwise, there is a high chance that the socket will be clogged. Secondly, the optimal distance between the switch and the ground is 130 cm. Precautions for water and electricity decoration of new houses:

The circuit transformation must refer to the actual electricity consumption. That is, if a thermoelectric water heater is installed, the wires must be a standard 4 square millimeters.

Waterway decoration waterproofing precautions, some renovation teams can deceive the owner in some parts, but the pressure test is one of them. If the owner is on site to supervise the pressing, it is possible to observe whether there is a circuit in the "water change valve" of the pump. After the circuit appeared, the actual working pressure pump at work did not seem to have much pressure.

Precautions for water and electricity decoration of new houses: special attention should be paid to electric pressure pumps.

Precautions for newlywed water and electricity decoration: The deep water area is not allowed to be used in the laundry area. If it is installed in a shower room, the deep water leakage can basically meet the demand due to the small amount of sewage.

However, the washing machine drains quickly and disgorges a lot, and deep water leaks slowly, so there is a high chance that the water will overflow.

The installation of cold water pipes requires special attention to the following: the separation between water pipes should reach 15 cm. The fountain degree of the electric water heater is 15 cm in water space, and 10 cm in some cases.

The height of the water nozzle should be consistent. Also, the nozzles of the hot and cold water supply pipes should be kept perpendicular to the wall. The hot and cold water nozzle is 2 cm higher than the wall.

When laying wall tiles, make sure that the water pipe nozzle is 2-3 mm higher than the wall tiles. New house decoration water and electricity strategy, water and electricity decoration precautions.

The above is a summary and analysis of the relevant content of the new house decoration water and electricity strategy. I believe that everyone also knows the importance of precautions for the decoration of water and electricity in new houses. Then pay extra attention during the renovation process. I hope the above introduction can help you.

First, the layout of hydropower.

1. Horizontal and vertical.

It is neat and beautiful, and it is convenient for future maintenance and inspection. But there are also those who say that this is a waste of not only a lot of materials, but also a lot of gas and water, and a lot of water. And there are a lot of corners in this one, and there will be some resistance when you cross it in the future.

2. Point-to-point.

Two points and one line, although not very beautiful, but can also save a lot of money, less corners, can reduce the dead corners, after all, this is a secret project, no matter how beautiful, as long as there is a groove, there will be no problems.

Later on, we also have to drive nails into the walls and floors, so it's easy to puncture wires and water pipes and cause them to leak, so we can't mess things up just because we started with it.

Second, the advantages of horizontal and vertical.

1. It is convenient for the installation of the keel.

Home decoration, water and electricity, decoration, construction are all related, if not sideways, but to cut the floor heating board into different small pieces, so that it is not conducive to thermal insulation, if you want to install solid wood or bamboo flooring, you need to lay the keel, so that it is convenient to install.

2. It is easier to install in the later stage.

"Horizontal and vertical" is the guarantee of the interior designer and decoration company to serve you, the master who installs the smoke machine, air conditioner, wall cabinet and other equipment will make holes in the wall according to the direction of the pipe to minimize the damage to the wires.

3. Later protection pipeline.

4. Pipe connectors.

At present, the water pipes and water pipe connections on the market are all at a right angle of 90 degrees, if the horizontal and vertical degrees of the hydraulic system are not done well, in this way, the canal can not be connected, and there will be some deformation, which has a great impact on the environment.

First of all, the wiring of water and electricity, must be buried in the ground, and must be neatly done, so as not to have problems in the future, and the waterproof test must be done, you can fill the floor with water one night in advance, and observe the water loss on the ground on the second day, and the plug of the power supply must be installed more in case of daily emergencies.

Of course, it is a problem with the lines of water and electricity, and in the process of decoration, the lines must be installed well, and the quality should be the best.

The kitchen must leave more sockets, and the water and electricity decoration must choose a good master, and the specific design should be based on the decoration style and area of your home.

Introduction: When you decorate a new house, you will pay special attention to household water and electricity. Because for a new house, the water and electricity in the home are particularly important.

If you make an accidental mistake, it will bring great danger to the decoration of the new house, so many netizens have questions, what kind of problems do you need to pay special attention to in the process of water and electricity decoration of the new house? <>

First of all, when decorating a new house, it is necessary to turn on electricity, and in the process of powering up, a plug board and the like will be installed, and the power supply can be enabled only on the premise of ensuring that there are no safety hazards. The distance between the socket and the ground should be 30 cm, and if the furniture is relatively low, the distance to the ground can be increased, so that it is convenient to reach it when using it. Secondly, be sure to keep some distance from the wall, otherwise the socket is likely to become clogged.

If you need to install a water heater in the house, the wires must be qualified. <>

As the saying goes, water is the source of life, and it is impossible to do without water, and the first thing to solve in a new house is to solve the problem of water. The deep water area is not allowed to be used in the laundry area, but if it is in the shower room, the sewage will be less, and the deep water leakage can be basically satisfied, but for example, everyone now likes to use the washing machine very much, the drainage speed of the washing machine is very fast, the drainage volume is also very large, and the speed of seepage and leakage is relatively slow, so it is also very likely to overflow the water flow. For the problem of waterways, we must be more careful, once it does not work, then the entire decoration project will be ruined.

For a new house, water and electricity are the most basic decorations. Therefore, we should pay special attention to this aspect, for example, in the bedroom and kitchen bathroom, these must have more security sockets, because the bedroom is now a mobile phone family, and they prefer to lie down and play with their mobile phones, so the distance of the socket should also be appropriate, such as washing machines and water heaters, etc., these are the need to install many sockets, and the kitchen uses more electrical appliances, and the decoration of water and electricity must choose a very good master, and secondly, it should be designed according to the decoration style and area of the new home. Make sure you don't have a problem.

The problem that needs special attention in the process of water and electricity decoration of the new house is that after the decoration is completed, we must check its route, and whether the sewer problem is passed, so that it is the best for us.

The wires that need to be installed in the living room include power lines, lighting lines, air conditioning lines, TV lines, ** lines, computer cables, doorbell lines, etc. The location of the wire needs to be considered in advance, do a good job of reservation, on the edge of the sofa to leave the first line mouth, on the inside of the door to leave the doorbell line mouth, water dispenser, humidifier and other equipment to reserve the power port, in general, the living room should leave at least 5 power line ports.

1. The aluminum-plastic pipe or PZ pipe that is convenient to use in the waterway for the renovation of water and electricity in the new house must be a qualified product that has been inspected and manufactured. 2.For the decoration of new houses, for the water and electricity renovation of the blank house, it is necessary to pay attention to the distribution of pipes in place, and the pipes must be stuck at the corners or where there is a standing faucet, and the pipes must not be loosened.

3.If it is a direct connection of PVC pipes, it is necessary to evenly coat and cover with PC glue, and the glue should be allowed to solidify naturally after coating the interface.

In the practice of construction, we must choose a better master with deeper experience to carry out the construction, water and electricity must be separated for construction, especially in the kitchen or bathroom to do water and electricity, do not set the water pipeline and wire in the same trunking, so that there may be great safety hazards in the later stage, and the layout of water and electricity must also be reasonable, must meet the needs of daily life.

It is necessary to pay attention to the wire casing, the water pipe must be separated from the wire, the layout of water and electricity must be paid attention to, the leakage switch needs to be installed, and the pressure test must be carried out.

First of all, the wires should be sleeved, the water pipes and wires should be separated, whether the broadband line and the strong current socket are separated, the layout of water and electricity, the installation of leakage switches, and the pressure test.