How to operate the single small speaker of the strolling amplifier?

The audio amplifier wiring ** is as follows:

Tools: amplifiers, audio cables.

The method is as follows: 1. Observe and see if the audio cable is complete behind the power amplifier and audio; If not, you have to go to the hardware store first to buy a section, it doesn't have to be too long, otherwise it will be coiled up and put in the back.

2. The connection of the general audio cable is very easy, find a pair of vices or scissors, and peel off the rubber layer on the outer surface of the audio cable to expose the copper wire inside, which is generally two colors: brass and silver. Troublesome spending time can also be found.

3. Tear off the outer skin, then twist the copper wire a few times by hand to make the copper wire harder, and then see that there are red and black binding posts behind the power amplifier, and the brass-colored red columns; Silver followed by black columns.

4. On the other side, the other end of the audio cable is also connected to the back of the audio, some of the audio is a binding post type, and some are more convenient, it is a buckle type, press down the buckle with your fingers, poke the line in, and then let go, the line is clamped by the buckle so firmly.

5. If it is two speakers, the wires should be connected on both sides of the left and right, that is, the left and right sides should be connected with one line each.

6. Now you can turn on *** and the power amplifier, and you should be able to hear the sound. The following is a description of the buttons on the front panel of the power amplifier, you can find a small flathead screwdriver, plug in the microphone, and slowly adjust the knob while talking, until the sound suits your own sound, and you can listen to it comfortably.

If it is a traditional mixer system, the operation process for unfamiliar environments is as follows: first turn off the power amplifier, and then adjust the level of each audio source equipment according to the mixer meter by 0db, check the meter of each signal, and follow the sound source signal one by one.

The operation method of the single small speaker of the strolling power amplifier is actually the same as that of ordinary speakers, which can be plugged in by active connection or connected by Bluetooth.

If you walk through the power amplifier single small speaker, you need to turn on the switch first, then connect to Bluetooth, and then finally install it. You need to play with all kinds of things, and all kinds of performance need to be debugged before you can operate this thing specifically.

There are small speakers like this, you just need to follow the instructions and plug in the power supply. Then follow the instructions in the manual. Operate.

Edifier type,The small speaker is very easy to operate,Just connect it with the mobile phone,And then adjust the corresponding buttons。

Hello,When you buy a speaker,It will come with a manual,You can also contact the seller,Let him send you an operation**。 Or you can press its buttons casually and find out what its function is.

If you have that small speaker, you have to connect that Bluetooth to copy it.

The operation of a single small speaker is very simple,There are few function keys,Generally, it can be connected to the operating software on the mobile phone。

How to operate a single small speaker with a stroll amplifier, I think if you want to operate a small speaker like this, you can use its manual to take a look at it.

The single display of the walking workshop can be operated.

Why do you go to the store and he will tell you how to do it.

How to operate the single small speaker of the stroll amplifier and listen to the song.

This is simple, there is a manual when you buy it, just read the manual.

The Rambler attack is still operable.

Hello, you follow the step by step instructions on the instructions. Or call the after-sales customer service and they will tell you.

How to operate the single small speaker of the strolling power amplifier generally has an operating manual, you take a look.