The house is all electricity, how to renovate it to save electricity?

If you want to save, it is nothing more than "open source and reduce expenditure".

1. Open source is to provide additional power** (or avoid electricity);

2. Throttling is to replace old equipment with more energy-saving and efficient equipment to reduce energy consumption.

Common approaches to open source:

1. The use of wind energy, solar energy, where there is a flow of water, can use water energy, the simplest is to drive the electrical equipment after power generation, among which the use of light energy is the simplest, and the technology is relatively mature;

The most common ways to throttle:

1. The main electrical equipment of housing is concentrated in refrigeration, heating, shower, and kitchen equipment, so whether it can be throttled should be adapted to local conditions, such as nearby stream water and well water, you can use water air conditioning to replace the traditional air conditioning using compressors, which greatly reduces electricity consumption; Heating is mainly to insulate the house to make the wall more insulated, and then try to use a solar water heater (which also basically solves the shower problem) to heat, and then heat the room; Kitchen equipment can consider the use of solar cookers, natural gas, biogas can also replace electricity;

2. The house should use natural lighting as much as possible, and the lamps and lanterns should use energy-saving lamps such as LED as much as possible.

Finally, it is necessary to develop good habits and pay attention to turning off the electricity after daily use to save energy.

If you want to save electricity in your house, the best thing is to use energy-saving equipment. Energy-saving equipment is used for both electric appliances and appliances, and it is best to install a photovoltaic power emitting panel on the roof.

The house is all electricity, you can buy some inverter electrical equipment, so that you can save more electricity, you can also turn off some unnecessary ones, such as not turning on the fan when turning on the air conditioner, which can also play a role in saving electricity.

Hello, the electricity in the house is normal, the decoration is normal, the laying is indicated, and the reduction of household appliances can save electricity, thank you.

The house is all electricity, if you want to renovate to save electricity, try to use some electrical products that are more economical and energy-saving, such as TV, air conditioner, refrigerator, etc., all use the kind of first-class energy-saving, so that you can save electricity.

I think you may just change all the lights to energy-saving lamps, and then some air conditioners use smaller wattage, so that you can save electricity bills.

The house is all electricity, how to transform can save electricity, this power saving has little to do with the transformation, the main thing is to replace the high-power electrical appliances in the house, or replace some bulbs with energy-saving bulbs, and pay attention to saving electricity when you usually use it.

The house is all electric, and the lights can be converted into energy-saving lamps. This is more power-efficient.

If you want to save electricity, you must not use more household appliances, you use less, and naturally the store will not use a lot, you can also choose natural gas.

If you want to renovate the electricity of the newly built house to save some electricity, you can reduce some sockets and plugs, and then do not use some high-power electrical appliances, which can save electricity.

If the house has electricity, you want to renovate, you can omit, you can change it to two, if you use it at home, you can reduce the power a little, or urgently use energy-saving lamps.

The house is all electricity, and if you want to save more electricity after the transformation, you can do the work of opening up and saving money by yourself, which can better achieve the effect of environmental protection and power saving.

How to remodel the house can save electricity. Then you use energy-saving and environmentally friendly materials and use solar panels on the exterior walls and roofs as much as possible. Insulation materials for walls. This saves power.

You make a comprehensive control cabinet at the coffee table that can control the whole house, and the lamps, sockets, air conditioners, and TVs in each room, bathroom, and kitchen are divided into separate control loops, so that you can directly turn off the control switch in the electrical circuit when not in use.

The first consideration for electricity in the house is safety, not how to save electricity, you can choose low-power appliances.

If you want to save electricity, it's best to install all of them, and then the LED energy-saving ones, and the other one is solar. Compare power saving.

The house is all electricity, if you want to save electricity, you have to turn off the power at hand, if you run out of use of an appliance, then turn it off.

If you live at home, if you want to save electricity, you can choose LED lights, because the amount of LED lights is comparative, and it is also more energy-saving.

The house is all electricity, if you want to renovate to save electricity, then you use energy-saving, which is more energy-saving.

Judging by your description, this is impossible, as long as you use household appliances, it is impossible to save electricity if you don't steal electricity, unless you use less appliances.

You can increase the power saving, and the monthly electricity bill will be reduced.

The houses are all chained, and if you renovate and save practice, I think you can buy those power-saving appliances again.

If you want to save electricity, you can use this kind of power-saving electrical appliances directly.

Then you can only choose more energy-saving appliances, so that you can save some electricity.

The house is all electricity, how to renovate can be lightning, I have to renovate, try to use the better quality of the line, it is easier to use.

If you want to save electricity, many of your appliances will not work, and the electricity bill will not be expensive.

In this case, you should ask the electrician, because they know him better, they are more professional, and they will definitely tell you how to save electricity.

The electrical equipment used in this is not a lot of words, and it is not particularly power-consuming, as long as you pay attention to it and use less.

The transformation of the store can also save electricity, and it is recommended that you follow the law of power saving.

Hello, the electric transformation bracelet of my friend's house may only be more proficient in solar energy, and it cannot be transformed, and the system cannot be installed in the end. Hmmm,

Hydropower renovation is a hidden project, which is very important in the decoration process, so it must be paid attention to.

Waterway renovation. Before the bathroom is renovated for water and electricity, it is necessary to keep the position of the hand basin, toilet, washing machine, shower and water heater. If necessary, you can also add a small kitchen treasure under the hand basin. Once the location is set, don't change it easily, and it is time-consuming, laborious and expensive to go back and forth.

Before the renovation of the kitchen, the location of the washing basin and kitchen treasure should be booked. It is necessary to install a kitchen treasure in the kitchen, it is very convenient to use hot water when washing dishes in winter, and it is convenient to use hot water in five minutes.

Circuit modification. Before the modification of the circuit, the location of the switch socket should be determined. The position should be in line with our daily habits, and the position of the socket should be set aside a few more in case of emergency; Also consider the location of household appliances, network cables and ** cables that you usually use at home.

Comprehensive renovation of water circuits.

Before the renovation of the water circuit, it is necessary to let the decoration company enter the site to actually measure it, and observe it again, and you also have a spectrum in your heart to know the specific cost of the transformation. Before the water and electricity transformation, it is necessary to hand over the installation position with the cabinet and kitchen appliance installers. Guaranteed to be foolproof.