Just bought a new car, what should I pay attention to during the run in period?

For many friends who have just bought a new car, they will always hear their family and friends say: "The car can't be ...... during the run-in period."Even veteran drivers may be very different from the advice given by 4S. So, what should a new car pay attention to during the run-in period?

Today, I will give you a science popularization.

1. After each power on, you should wait until the oil lamp, preheating lamp, etc. go out before ignition, and turn off all power-consuming functions such as audio, air conditioning, and lights before turning off the ignition.

2. Minimize the probability of running long distances during the run-in period (2000km), and the continuous working time of the engine will increase, which is easy to cause wear and tear of the parts and prolong the life of the car.

3. The engine speed should not exceed 4000 rpm during the run-in period, and generally not exceed 3000 rpm.

Fourth, try not to drive fiercely and step on the floor oil during the run-in period, and at the same time do not use sudden braking, because emergency braking will not only impact the braking system, but also increase the impact load of the vehicle chassis and engine.

Fifth, after our car starts cold, we should first warm up the car for 3 minutes, wait for the water temperature gauge pointer to start to rise to a close to normal level before starting the car, and do not drive on the road without heating the car.

7. Try not to drive at full load during the run-in period, which will increase the load on the body and power system.

What should I pay attention to during the run-in period when I just bought a new car? Newbies get to know it.

Be sure to warm up before you start.

The so-called preheating is actually to give the engine a sufficient lubrication time, especially for turbocharged models, and the preheating time is recommended to be at least one minute or more.

2.Start smoothly and accelerate slowly.

After the engine is ignited, the car should be warmed up first, and if the acceleration or braking is very difficult, it is easy to bridge the automobile-related parts.

3.The engine speed should not be too high.

4.Don't hold one gear for long periods of time.

When driving, it is necessary to shift gears flexibly, so that each gear can be run in, and the best way to increase the coordination of parts of the gearbox is to run a sedan quietly in different road conditions.

5.Do not drive with heavy loads.

The load of the new car on the engine will increase, the greater the load, the damage will be serious, the lighter the car during the run-in period, the better, the first 100 kilometers are best to drive without load.

6.Do not brake unless necessary.

Emergency braking will produce shock loads on the chassis and engine of the car, so try not to slam on the brakes.

7.Do not drive for long periods of time at the beginning.

At the beginning of running-in, don't let the new car drive for too long or run long distances, start-stop is the best way to run-in.

8.Don't change the oil early.

Generally speaking, the original engine oil of a new car is a special oil for car running-in. Special oil has the advantages of low viscosity, strong heat dissipation, strong oxidation resistance, cleaning effect, etc., and some models also deliberately add abrasives to assist in running-in.

2. Operation guidance after running-in.

1. Run at high speed.

"Pull the highway" means that after the new car has passed the run-in period, it is necessary to drive on the highway. This is done to allow the pistons and camshafts in the engine to try to work quickly for the first time, and also to allow the gears in the gearbox to try to rotate at high speed for the first time, so that the bite between the parts is smoother.

2. Other precautions.

After the running-in period, the performance of the vehicle has reached a good driving state, but in daily driving, it is still necessary to pay attention to the status of the instrument, such as whether the fault light is lit, whether the water temperature is normal, etc.

<> "Run-in period refers to the initial driving stage of the new car or overhaul of the reed sail, generally 1000 1500 kilometers, is to ensure that the parts are fully contacted, friction, adaptation, the basic mileage. So what should I pay attention to during the run-in period of a new car?

After buying a new car, you should try to avoid sudden braking, because it will always cause the braking system to be shocked, and it will also affect the chassis and engine.

Drive at a uniform speed as much as possible, if it is a domestic car, the speed per hour is about 40-70 kilometers is appropriate, if it is an imported car, the mileage is within 1000 kilometers, and the speed of Qi Jin should not be higher than 80% of the maximum speed.

During the run-in of a new car, do not pull heavy objects, and try to avoid the vehicle being fully loaded. If it is fully loaded for a long time, it will increase the load and lead to increased wear.

Start the engine correctly, be sure to wait for the end of the self-test before starting it with the key, not all at once. The first key to the run-in of the new car is to monitor the various signal lights of the dashboard at any time, and the unknown fault display must be dealt with immediately.

Simple engine running-in, the engine assembly has been adjusted at low speed and high speed, so some cars are called zero kilometer running-in. However, for the power system of the car, not only the engine, but also many aspects, it is recommended to run in well.

The first is not to run at high speed too soon. Specifically, the speed of each gear (recommended) in the first 2500 kilometers should not exceed: 20 miles in 1st gear, 40 miles in 2nd gear, 60 miles in 3rd gear, 80 miles in 4th gear, and 100 miles in 5th gear.

The main purpose is to make the new clutch engagement smooth, the gearbox gears are well engaged, and the power output is smooth. But be careful, don't always run in a certain gear.

Nowadays, more and more people are buying new cars, in addition to making a variety of decorations for new cars, do not ignore the problems to pay attention to during the run-in period of the new car, because this will affect the fuel consumption and service life of your car in the future. And some new car owners hearsay that pulling high-speed, running long distances and other behaviors are likely to cause great damage to the new car. What is the break-in periodFirst of all, let's introduce what the break-in period is, so that you know why the break-in period is so important for the car.

Before the assembly of the car, each running part is processed separately, and there are geometric deviations when processing the parts, so after assembly, some running parts will be in direct contact locally, and the lubricating oil is difficult to enter the friction surface, resulting in early wear. The run-in period is to grind off this part of direct contact within a certain period of time, which is called the run-in period. The run-in mileage of new cars is generally 1000 km to 3000 km.

The run-in period has a great impact on the service life and fuel consumption of the car, because the wear and tear during the run-in period will cause scars on the surface of the parts, and the rough scars will increase the friction resistance, and the scars will also accommodate metal filings, oil sludge and other particle-containing debris, which will continue to expand the wear and tear in the movement, and eventually cause failure, so the run-in quality determines the life of the vehicle. Emergency braking is taboo in 6 taboos during the run-in period: emergency braking not only impacts the braking system in the running-in, but also increases the impact load of the chassis and engine, and it is best not to brake urgently within 300 kilometers of the initial drive.

Do not overload: If the new car runs at full load during the run-in period, it will cause damage to the parts. Therefore, within the first 1000 kilometers, the general load capacity should not exceed 75%-80% of the rated load.

Avoid running long distances: If the new car runs long distances during the run-in period, the continuous working time of the engine will increase, which is easy to cause wear and tear of parts. Avoid driving at high speeds:

There is a speed limit during the run-in period of the new car, the domestic car is generally within 40-70 kilometers, the imported car is generally within 100 kilometers, when the throttle is fully open, the speed can not exceed 80% of the maximum speed, and pay attention to the engine tachometer and speedometer while driving, to ensure that it works at medium speed. Under normal circumstances, the engine speed should be 2000-4000 rpm during the run-in period. Do not change the oil too early:

The initial oil of the car is a special lubricating oil for the run-in period, which requires low viscosity, good heat dissipation, superior cleaning and oxidation resistance, and some car factories have also added abrasives that are conducive to running-in, so the oil during the run-in period only needs to be changed according to the time specified by the manufacturer, and should not be replaced too early. Avoid starting without hot car: the new car must be warmed up before starting, the so-called preheating is actually to give the engine a full lubrication time, especially turbocharged models, must be warmed up before starting, and the lubrication time should be at least one minute or more.

Have you remembered the maintenance of the run-in period of the new car shared by Nanjing Automobile**? I believe it will be helpful to you!

What should I pay attention to during the run-in period when I just bought a new car? Newbies get to know it.

When a new car is in hand, there is a problem that many car owners are very concerned about, that is, the run-in period. I always hear a lot of old drivers say that the run-in period is very important for the vehicle, and the run-in can be used more smoothly in the later stage of the vehicle, and the power can be played better, and the run-in is not good, the car is always uncomfortable to drive, and the run-in period has such and such precautions, so that novice drivers do not know how to drive.

There is also a saying that the current car has been run-in before leaving the factory, and there is no need to run in, and there is no need to open anything. The current new car has indeed been pre-run before leaving the factory, and the manufacturing process itself is constantly improving, which is much finer than the previous vehicle.

However, no matter how perfect the manufacturing process is, and then run in in the early stage, it is impossible to polish the various parts to be very smooth, and there will always be some frizzy places, and these subtle unevenness still needs to be smoothed during the use of the vehicle. In addition, the vehicle engine is composed of many parts, and these parts also need to be slowly run in in the work to achieve the degree of mutual fit. Therefore, the current new car still needs to have a run-in period.

Of course, the current run-in period is really not as much as before, as long as you don't brake too often, press the accelerator or intentionally increase the speed when driving normally. Usually driving, the normal speed will not be too fast, basically will not exceed 100 kilometers, if there is really a need to run high speed, maintain 120 yards of uniform speed driving for new cars is no problem, do not have to be too entangled in speed, but also not faster, one is that the engine run-in has not been completed is really not good, the other is that speeding is both a violation and unsafe, even if it is not in the run-in period, do not do it.

What are the precautions for a new car?

You don't need to pay too much attention to details, as long as you drive normally, don't brake too often, slam on the accelerator, and drive very fast.

I ran 3,500 kilometers on the 4th day of my new car, and the whole journey was at high speed. Now the car is tens of thousands of kilometers. A car that has always been very worry-free.

As long as you drive normally, don't brake too often, press the accelerator hard or deliberately increase the speed. Also pay attention to go to a regular 4S shop for routine maintenance.

Do not accelerate suddenly, do not brake suddenly, and operate according to the vehicle manual.

Try not to run long distances, don't drag gears, the gear must be hung up one gear at a time, don't worry, you must let the gear run in well, the most important thing is to change the oil frequently, and you have to rely on your own maintenance in the future.

The new car runs in to grasp the fuel consumption, and the run-in is good, and the drive is smoother and fuel-efficient.

First of all, you can't violently manipulate the car, and you can't drive it around.

Don't change gears too often and remember to accelerate too hard.

Do not brake too often, press the accelerator throttle, or deliberately increase the rev during normal driving.

Hello: 1, for the new car must not let the engine run at full load, it will consume the engine life, keep it within 2000-3000 rpm, try not to exceed 3000 rpm.

2. Do not run too far during the run-in period to cause the engine to overheat and affect the life, when refueling, refer to the oil instructions or the oil cream cover has a hint of how much oil to add, for example: with No. 92 gasoline you add No. 95, No. 95 you add No. 92 will cause the engine to be weak in the future.

3. Don't add any additives.

Hope it helps!

1.Do not exceed three-quarters of the maximum speed;

2.Do not accelerate, slow down or drive at full load;

3.Avoid driving on bad roads.

The running-in period has a great impact on the service life and fuel consumption of the car, and the above matters should be paid attention to during the running-in period.

For new cars, the run-in period is still more important, and may even be related to the future performance and use status of the car. But for the run-in period, there are still many friends who don't know much, so how should the new car be run-in? Do you need to pull the high speed when the new car is running-in?

First of all, the run-in period of the new car is generally 1000 km - 3000 km, in the run-in process, the brake, engine, gearbox, chassis and other parts of the new car will have small errorsIt is necessary to make them fully run at different speeds, so that the coordination between parts can be more coordinated, and the car will drive more smoothly. The so-called high-speed pulling is not simply increasing the speed of the car, but the meaning of pulling up the speed, that is, to ensure that the speed of the engine reaches a relatively high level. Generally speaking, it is not necessary to do this during the run-in period of the new car, because there is a certain error in the deployment of various components of the new car, if the speed is rashly increased, it will only lead to high load work of the engine, and there may even be excessive wear of the cylinder wall and piston ring, affecting the sealing effect, and there may also be carbon deposits.

Secondly, although the method of pulling the speed is not suitable for use in the run-in period, it is still very necessary。Generally speaking, the owner will choose to pull the high-speed after the run-in period, because in this case, the degree of cooperation of various components has reached a relatively balanced state, and the safety of the high-speed is also relatively high. Therefore, the run-in period of the new car generally does not need to pull the high speed, but needs to use each gear as evenly as possible, so that each gear of the transmission can be run-in, which is the most correct way.

Finally, there is the question about cruise controlDuring the run-in period of the new car, it is indeed necessary to avoid using cruise control for a long time. This is mainly because in the process of normal driving, the speed and speed range of the car fluctuate relatively largely, which is more conducive to the run-in of the car. However, if the cruise control is turned on, the speed of the car is fixed, and the fluctuation of the speed in this case is very small, which does not have any benefit for the run-in of the new car.

To sum up, there are still many problems that need to be paid attention to in the run-in period of the new car, and if the owner does not operate correctly during the run-in period, it may also have an impact on the later use of the car.