Just made the system and can t install anything I don t know what the reason is

It's so simple. Just turn the service on and you're good to go.

Reinstall the following again, if it still doesn't work, it is estimated that it is the installation disk in addition to the problem.

It is recommended to reformat the other disk and install the system after the system is suspected.

Was it prompted when installing? Did you format all the disks?

Reinstall the system and check the hard drive before installing the system.

Under Windows 2000:

Step 1: Click Start > run, enter the cmd command, and enter it in the pop-up cmd command prompt window.

msiexec unregserver" command to stop the Windows Installer service.

Step 2: **Windows Installer Service Installer Package, Windows 2000 NT System Installer Package is "Installer Package is""Windows XP integrates the latest version of Windows Installer.

Step 3: Right-click on the file and click on the "Install" option, then right-click on the file and click on "Install".

Step 4: Enter the "msiexec regserver" command in the cmd command prompt, so that the windows installer service is launched, and the problem is solved after restarting the windows 2000 system.

Note: Do not reboot the system during the installation of the two INF files, and can only be restarted after all operations are completed, in addition, if the system is installed with "Rising Virus Firewall" and "Rising Network Firewall", it is recommended to turn off the Rising Firewall during the operation.

Under Windows XP system:

Step 1: Write a file using Notepad that reads as follows:

windows registry editor version

imagepath"=-

imagepath"=hex(2):25,00,53,00,79,00,73,00,74,00,65,00,6d,00,52,00,6f,00,6f,00,\

74,00,25,00,5c,00,53,00,79,00,73,00,74,00,65,00,6d,00,33,00,32,00,5c,00,6d,\

00,73,00,69,00,65,00,78,00,65,00,63,00,2e,00,65,00,78,00,65,00,20,00,2f,00,\

Then save the file as ".".reg" format to double-click the file to import its contents into the registry.

Step 2: Restart the computer into safe mode (press the F8 key when starting), then click Start > Run, enter the cmd command, enter "msiexec regserver" in the pop-up cmd command prompt window, and finally restart the system.

Possible reasons why Windows Installer can't configure Windows to run on this computer hardware:

1. The most likely cause is a system-driven conflict, which is the main cause of these errors.

2. The second is the problem caused by disk partitioning, which is usually that there is no correct disk under the windows installation package.

Fix it with a 360 system first aid kit and then reinstall it and you can solve it.

May generally be missing. .NET library file.

It's you again (you look to see if there's something wrong with your network).