There are a lot of ducted exhaust pipes on the top floor on the terrace, can it be cut?

For some sewage pipes suitable for this way. Like the exhaust pipe in the kitchen, there are oil fumes and harmful gases, the exhaust pipe in the bathroom, the dirty air, and the exhaust outlet of the sewer pipe, which is more smelly. By increasing the height, the polluted air is discharged to a high place, and it does not affect the home life of the terrace.

You don't think there are many pipes, and you can't see it, so you can increase the height of the pipe to more than two meters, and then decorate the pipe cleverly into several large trees to connect together, which not only beautifies the terrace environment, but also loses the role of the pipe, and you also let off the bad smell.

<>I think you're too greedy, since there are so many, exhaust pipes, it means that this is a rooftop public platform, not your rooftop terrace. However, for the old house built a few years ago, there will be many pipe exhaust holes on the terrace, and at this time, there will be an idea of whether these exposed exhaust pipes can be cut, because it will affect the aesthetics too much, and it will also affect the use of the terrace.

It is inevitable that water will remain in the insulation layer during construction, and the construction will be knotted in high-rise buildings.

The height of the vent pipe of the sewage pipe needs to consider the problem of air pressure balance. If you change the position, increase the number of elbows, and change the direction of the windward direction, it may cause problems such as poor drainage or odor spreading. Long-term exposure to the roof after bunching, if the water vapor cannot be discharged, the roof will bulge and crack.

Therefore, it is required to have a certain interval of exhaust outlets in the project.

The first thing you should understand is that you are buying the top floor, not the top floor. The roof is the common area of the whole building, and you should not touch these facilities in the public area. Saw, dismantle, how beautiful your terrace is, what it does, other people's poor drainage and exhaust have nothing to do with you, the roof waterproof layer is broken, it doesn't matter and once blocked, in the summer when the temperature is high, the thermal insulation cushion.

After the air expands, there is nowhere to discharge, it will break through the roof waterproof layer, which will also cause the roof to leak, so the exhaust hole on the top floor terrace must not be cut, and it can not be blocked.

Do not cut them, because these pipes are useful, and cutting them may destroy the usefulness of the pipes.

I bought the top floor, and there are many exhaust pipe holes on the terrace, which cannot be cut or removed. Because these exhaust holes are downstairs kitchen flues, bathroom exhaust pipes, sewer pipe vents, roof exhaust outlets, are the outlets for ventilation and smoke exhaust of these pipes, if cut off, water will enter the dust, resulting in pipe blockage, if blocked, it will lead to inability to drain, smoke exhaust, and even roof cracking. These pipes belong to the public facilities of the building, and if they are damaged at will, they will be liable for affecting the normal living and use of neighbors.

No, these exhaust pipes are useful, it is impossible to cut them, and in the end they are still heightened.

No. For the facilities installed on the roof, we try not to dismantle, each pipe has its purpose, and cutting it will affect its exhaust. My personal suggestion was to lengthen these pipes and extend them out of our terrace to meet their exhaust function.

You can't cut it off. For buyers who have bought a terrace on the top floor, seeing a lot of exhaust pipe holes on the terrace, I believe they will have the idea of wanting to cut off, but this pipe plays a great role, it is not allowed to cut it off without permission, and it is not allowed to seal it, if it is not handled well, it will affect the exhaust, smoke exhaust and drainage use of the kitchen and bathroom of the whole building.

It cannot be cut, but it can be beautified. This pipe plays a lot of roles, it is not allowed to be cut off without permission, and it is not allowed to be sealed, if it is not treated well, it will affect the exhaust, smoke exhaust and drainage of the kitchen and bathroom of the whole building.

It cannot be cut off because each pipe has its purpose and cutting it will affect its exhaust.

Of course not, these pipes installed on the top floor are very important, there may be exhaust pipes, ventilation pipes, electric pipes, water pipes, etc., if you cut them, it will cause the floor to lose power, ventilation is not smooth, water pipes leakage and other problems.

It cannot be cut. Whatever the specific use, the developer must have a special purpose for building in this way. If you must cut it, you can consult the property to avoid being fined.

It is not allowed to be cut, because these exhaust holes are downstairs kitchen flue bathroom exhaust pipe and water pipe vent, if the roof exhaust port is cut off dust in, it will cause the pipe to be blocked, which will cause the roof to be unable to drain, smoke exhaust, and will also cause the roof to crack.

I don't think so, because after cutting it, it will affect the normal use, and the property is not allowed.

These exhaust pipes are the exhaust pipes of the kitchen or bathroom, ventilation and ventilation can not be cut, of course, you can beautify them, or consult the property.

It's better not to, the developer still has a certain reason for this design, many houses that are renovated after taking over will have problems, and it will affect the drainage after the change.

It cannot be cut. If it is cut, it may affect the function of the pipe, and it is easy for garbage and dirt to get in, and it is very likely to be blocked. It is better to extend the pipe, so that it does not affect you.

You can't cut it off, and if you cut it off, you're responsible for it, because it's not your household, it's all the exhaust holes of all the residents in your building.

No. Because vents are useful and can be used to vent moisture, they are important for buildings and cannot be cut.

My house is on the top floor, and the kitchen has a sewer exhaust pipe all the way to the top floor, I want to cut this pipe and extend it outside, is it okay?

My house is on the top floor, and the kitchen mold has a sewer exhaust pipe all the way to the top floor, I want to cut this pipe and extend it outside, is it okay? Kiss! Hello, happy to answer your <>

My house is the top floor, the kitchen has a sewer exhaust pipe all the way to the top floor, I want to cut this pipe and extend it out of the outdoors, you can't expand the information, it's best not to change. This ventilation pipe plays a very important dredging role, when each household drains and discharges, it will draw air from this ventilation pipe, and under the action of atmospheric pressure, the dirty water will be flushed into the gutter. If you change it to a thin pipe, it will change the atmospheric pressure of the sewer, when draining, due to the inability to smoothly swallow the sewer air, it will seriously lead to the inability of each household to go into the water, I hope my can jujube help you <> as soon as possible

Do you have any other questions?

Summary. Hello dear. No, these are all common to residents, and if you drain them inside, they will run to other people's homes.

Can the exhaust pipe on the roof drain water in?

Hello dear. No, these are all common to residents, and if you drain them inside, they will run to other people's homes.

Whether the roof is equipped with exhaust holes and exhaust ducts should be determined according to the condition of the insulation layer. If there is water in the insulation layer, it should be installed. If there is no water in the insulation or water is allowed, there is no need to set it up.

If there is no waterproof layer above the insulation layer of the polystyrene board, the insulation layer is allowed to enter the aqueous state, and the water in the insulation layer is discharged through drainage evaporation. Because the open insulation design (commonly known as the inverted insulation type) affects the overall insulation effect, the thickness of the insulation layer is increased by 25% compared with the ordinary insulation layer when designing the insulation layer. If there is a waterproof layer on the warm layer of the polystyrene board, consider whether there is water in the insulation layer before applying the waterproof layer.

If there is stagnant water or high humidity, it is necessary to set up exhaust holes and smoke exhaust channels. Why is there a vent? The previous insulation materials are mainly inorganic materials such as cement perlite, when the water needs to be stirred, in the rainy weather, the water can not be discharged in the insulation layer in a short period of time, with the moisture in the insulation layer, the waterproof layer will drum up, and the insulation performance is degraded, so the moisture is discharged from the insulation layer, and the exhaust channel and exhaust hole are set.

In principle, if the humidity in the insulation is balanced with the atmosphere, there is no need for an exhaust system to exist, it can be sealed, and it is more reasonable to seal than to maintain. Attention should be paid to waterproof treatment when sealing. Some people think that the exhaust hole is set up to prevent rainwater from entering the insulation layer, if the rainwater continues to enter the insulation layer, it means that the waterproof layer has been destroyed, the roof should leak, and the exhaust system is not enough, and it is unreasonable.

Therefore, it is possible to seal the hole according to the condition of the roof. Whether the insulation layer can be flooded without affecting the insulation performance depends on the insulation material and process. If the insulation material itself does not absorb water, and there may be a water gap between the insulation board, the insulation layer and the waterproof layer below, it should also be noted that the frost heave in winter will damage the insulation layer and the floor tile surface layer above.

You can make some decorations on the outside of the exhaust duct, so that it will look much better visually, and it will not feel awkward.

How to say, I personally think that the best way to deal with it is to pack it up and encapsulate it, and finally you can paste tiles on the ship, so that it is not only beautiful, but also can play a certain role in waterproofing.

I bought the roof of the top floor, those exhaust pipes affect the aesthetics, I think you can decorate these exhaust pipes, you can buy some decorations to embellish, or put some greenery around the roof, so that it can both beautify and purify the air, it can be said to kill two birds with one stone.

The exhaust hole is to remove the water vapor in the roof insulation layer and waterproof layer of the roof to prevent the roof from cracking, not to exhaust any toilet exhaust gas, which is a necessary structure in the building. The smoke exhaust pipe is exhausting the fumes.

I bought the roof of the top floor, those exhaust pipes affect the appearance, I think you can use the decoration cabinet to cover up those exhaust pipes, so it is good to deal with, and you can still put things in the cabinet, which is very convenient.

Why can't the roof ventilation tract be removed?

The ventilation ducts of all roofs here refer to a type of pipe that protrudes from the roof and is used to exhaust the gas in the pipes. There are two common materials for exhaust pipes, one is made of PVC and the other is made of cast iron. The diameter of the pipe is generally 110mm and 150mm.

The height varies according to the type of roof, and the common height is 500mm from the ground, and 1800mm and 2000mm from the ground. This type of pipe cannot be cut because it does the following:

The role of the toilet ventilator. The ventilation duct in the restroom serves two purposes.

One function is to ventilate. The function of ventilation is to discharge the gas present in the sewage pipe in the toilet to the outside through the pipe on the roof. Because the density of the gas is generally relatively light, it will be discharged to the outside as the pipe rises.

Another function is to prevent the gas from being blocked during drainage, which will affect the normal flow of water. Because the water squeezes the gas in the pipes as it flows downward, there is a separate ventilation pipe in the bathroom to connect it. After the water squeezes the gas, it is discharged to the outside through another snorkel.

The role of kitchen ventilation pipes. The plumbing in our kitchen at home is generally just a branch pipe indoors, connecting to our vegetable washing basin.

So the kitchen does not have a separate ventilation duct. This pipe is only connected to the roof on the top floor and is used for exhaust. So its function is to remove the gas accumulated in the pipeline.

Ensure that the water flow is normal and reduce the generation of odors.

You can buy some good-looking and delicate stickers and put them around the exhaust pipe.

Summary. It can't be adjusted because it ventilates the bathroom and kitchen.

If it is cut, the roof will crack, causing the roof of the top layer to regain moisture, and it can also cause water seepage on the roof.

Treatment suggestion: It must not be excised, otherwise it will cause many problems.

Lengthen these pipes and move them out of the balcony.

Hope it helps, thank you

There are a lot of ducted exhaust pipes on the top floor on the terrace, can it be cut? Why? How to deal with it?

It can't be adjusted because it ventilates the bathroom and kitchen.

If it is cut, the roof will crack, causing the roof of the top layer to regain moisture, and it can also cause water seepage on the roof.

Treatment suggestion: It must not be excised, otherwise it will cause many problems.

Lengthen these pipes and move them out of the balcony.

Hope it helps, thank you

You can move it out if it's lengthened, right?

It should be ok.