How to deal with the sewer pipes of the old house renovation

The kitchen and bathroom of the second-hand house often have a lot of old problems because of the long use time, aging pipes, unreasonable structure, etc., so when the second-hand house is renovated, many owners hope to have a big renovation to solve the old problems and make the kitchen and bathroom look new.

So what problems should I pay attention to when renovating a second-hand house?

Renovation of old houses: pay attention to waterproof ventilation second-hand house renovation bathroom is inseparable from water, so waterproof is the top priority of second-hand house bathroom renovation, the original floor tiles of the old bathroom.

After kicking it off, be sure to pay attention to leveling, and then after drying, you must waterproof the ground. In addition, the slope of the floor in the bathroom should be reasonable, and it should be suitable for water to drain from the floor.

Flowed away. However, if the slope is too large in the pursuit of drainage, it will cause the impression of uneven ground and affect the overall effect.

In addition to the renovation of the second-hand house, the ground should be waterproof, the wall should also be waterproof, the original wall of the old bathroom has been waterproof, if the wall of the bathroom is not changed much, you don't need to do it again, but if the change is large or you have to consider redoing it. Generally speaking, the wall around the shower is about a meter high, and the bathtub and the wall are waterproof 30 cm above. If the wall of the bathroom is a non-load-bearing lightweight wall, the entire wall should be coated with waterproof paint.

Toilet in the bathroom.

It is better not to change the location. Because it is likely that the whole building has a sewer line in the same place, and the toilets are changed at will.

location, it is easy to cause poor water flow. Hand room renovation Old house kitchen renovation: space renovation should be careful, second-hand house renovation kitchen one of the key points is the re-planning and layout of the space.

To transform the original layout, it is inevitable to remove some unwanted settings, and newly installed water heaters and range hoods.

Kitchen appliances also need to be reasonably laid out on the original gas pipes.

Key points of kitchen demolition: Kitchen demolition and renovation are the same as the general principle of wall demolition, some places can be demolished, and some places cannot be demolished. There are load-bearing walls in the places where the second-hand house renovation kitchen cannot be demolished.

and gas pipelines. A load-bearing wall is a wall that supports the weight of the upper floor, which is identified by a thick solid line on the drawing. Non-load-bearing walls are generally marked with thin solid or dashed lines on the drawings.

In addition, it can also be distinguished according to the thickness of the wall, and generally the wall above 240mm is a load-bearing wall. Some walls cannot be distinguished in thickness, but they are also load-bearing walls, such as exterior walls and walls shared with neighbours, which are easy to distinguish. Depending on the structure of the house, you can distinguish a load-bearing wall and a frame structure.

The interior partition walls in the house are generally not load-bearing walls. and brick-concrete structures.

In the house, except for the partition wall of the bathroom and kitchen, there are load-bearing walls.

There are strict specifications for the design and installation of gas pipelines for the renovation of second-hand houses, and they must be constructed by professionals. If the owner dismantles and modifies the gas pipeline and seals the gas valve without permission, it is easy to cause gas leakage. When the gas pipeline is encapsulated, it is not easy to detect the gas leakage, and the leaked gas will also accumulate together, once it encounters an open flame, it will cause **, endangering life safety.

Therefore, when the wall of the second-hand house is renovated and the kitchen is demolished, the gas pipeline should be avoided as much as possible.

Then hire a plumber!

In general, plumbers can be competent for all kinds of hydropower transformations. It's just that the sewer renovation may require excavation of the ground, so the amount of work is slightly larger!

The water and electricity of the old house generally have to be renovated, otherwise the water and electricity may break down frequently, especially the sewer blockage, which is even more annoying!

If the old house is on the first floor, the ground must be excavated, and after the water is completed, the ground must be backfilled and hardened, which takes a long time and is uninhabitable. If the old house is above the second floor, it will be simple, but it still has to trouble the residents of the next floor, which needs to be coordinated with others.

In short, the hydropower union will formulate the corresponding construction plan according to the specific situation.

The old renovation is not just about painting the exterior wall, it is mainly for the renovation of the facilities of the community housing and the upgrading of the community infrastructure, including water supply, gas pipes, electricity, parking, etc.

I am happy to answer for you: the replacement method of the old sewer pipe is as follows: 1. Buy a new pair of sewer pipes, for most families, there is no need to buy other accessories, because the damage is generally the place where the water pipe and the washbasin are linked.

2. First dismantle the original water pipe, the water pipe is connected with threads, as long as the water pipe is turned to the spring, it can be removed. 3. After the water pipe is removed, the part that is linked to the pool to be replaced can be thrown away, and the other intact parts can continue to be used, without worrying about the problem of mismatch, because these are standard parts, and the matching rate is 99%. 4. There will generally be some dust deposited in the connection between the pool and the water pipe, and we ensure that the newly installed water pipe will not leak, and we must clean the interface first.

5. Insert the water pipe from the top of the pool, shake it gently, and observe whether the water pipe is tightly connected with the pool. 6. Put the rubber gasket from the bottom of the pool to the water pipe, and push it up along the water pipe to the bottom of the contact pool. How to put the metal nut on the water pipe and tighten it to ensure that the water pipe is connected to the pool, does not shake, and does not leak.

7. Link a section of the plastic water pipe to the bottom of the metal water pipe just installed, and a section of the water pipe to the upper part of the pipe, and the installation work is completed. 8. Turn on the faucet, try the installation results, and check the results.

The renovation of the sewer pipe of the toilet in the old house is to meet the needs of daily life, and also to enhance the sanitary conditions and usage habits of the toilet. Here are some ways to renovate the toilet sewer pipe in the old house::

1.Update the piping material.

The sewer pipes of old toilets may be made of plastic, cast iron, ceramics and other materials, which may have problems such as aging, corrosion, and brittle pipe walls after many years of use. The new pipe materials can be made of materials that are now stronger and more durable, such as copper pipes, steel pipes, new PVC pipes, etc.

2.Improve the layout of sewer routes.

Toilet floors in old houses are usually low and not well designed, and the layout of sewer road lines may be poorly unclogged or difficult to clean, which may lead to sewer blockage and odor generation. Improve the layout of the sewer road, try to avoid the bend of the pipeline, ensure that the drainage is smooth, and the cleaning is convenient.

3.Install the dirt interceptor.

The sewage interceptor is a device set in the sewer pipe, which can effectively filter the debris, sand and gravel in the sewer to ensure the smooth flow of the sewer. After installing the interceptor, it is also easier to clean up.

4.Retrofitting some sanitary facilities.

For some old toilets, the sanitation facilities may not be perfect, and some facilities need to be installed, such as squatting toilets, sprinklers, toilet lids, etc., to improve the level of hygiene and use habits.

In short, the renovation of toilet sewer pipes in old houses is an important project, which requires careful consideration and selection of appropriate materials and devices to improve the sanitary conditions and use of toilets.

It is necessary to renovate the water pipes of old houses, because old water pipes may have problems such as aging, corrosion, and water leakage, which will bring great safety hazards to the health and life of residents. How to carry out the collapse of the water pipes of the old house? Here are some ways to do it:

1.Replace the water pipes.

If the old water pipes are old, corroded, or leaking frequently, then the pipes need to be replaced. In this case, we can choose plastic water pipes, copper water pipes and other materials to replace, which can ensure the quality of the water pipes and prolong the service life.

2.Install water pipe valves.

At the same time as replacing the water pipes, we can also consider installing water pipe valves. In this way, when the water pipe is leaking, we can quickly stop the flow of water by closing the valve, avoiding the waste and loss of water resources.

3.Clean the water pipes.

If the old water pipes are not very old, but there is a problem of water pollution, we can take measures to clean the water pipes. You can use a special water pipe cleaner and put it into the water pipe for cleaning, which can effectively remove impurities and dirt in the water pipe and purify the water quality.

4.Installation of water treatment equipment.

In the process of renovating old houses, we can also consider installing water treatment equipment, such as water filters, water purifiers, etc. This can effectively remove harmful substances such as heavy metals, bacteria, and viruses in the water, and ensure the safety of household drinking water.

In short, the renovation of water pipes in old houses is a very important project that needs to be treated with caution. We must choose the best water pipe materials, and take the means of multi-knowledge banquet to carry out the transformation of water pipes to ensure the health and quality of life of residents.

There may be many problems in the water supply and drainage of old houses, such as aging pipes, blockages, water leakage, sewage backflow, etc., which will not only affect the user experience, but also adversely affect life and the environment. Therefore, the renovation of water supply and sewerage is an indispensable project to ensure the sanitation and health of the living environment. The following are the specific methods and steps for the renovation of the old house:

1. Check pipeline problems.

First of all, it is necessary to check the pipeline problems, including whether the pipeline is aging, clogged or leaking, etc., and professional detection methods can be adopted, such as using a camera to check the internal condition of the pipeline, measuring the flow rate of the pipeline, etc. If there is a problem with the pipeline, it needs to be repaired or replaced in a timely manner.

2. Improve the layout of pipelines.

The layout of the upper and lower sewer pipes in old houses may be crowded and complex, which makes it easy to dredge and repair difficulties. Therefore, it is necessary to improve the layout of the pipes, such as adding drains, optimizing the angle and length of the pipes, etc., to ensure that the pipes are smooth and easy to maintain.

3. Install filters and diverters.

The installation of filters and diverters in the water and sewage pipes can effectively prevent garbage and debris from entering the pipes and causing blockages, and can also separate sewage from clean water to ensure the hygiene and safety of drainage.

Fourth, choose high-quality materials.

In the renovation of water and sewage pipelines, it is necessary to choose high-quality materials, such as stainless steel, PVC, etc., which have the characteristics of anti-corrosion, pressure resistance, corrosion resistance, etc., which can ensure the service life and quality of the pipeline.

5. Increase ventilation equipment.

Adding ventilation equipment to the sewer pipe can effectively prevent sewage backflow and odor spreading, and ensure indoor air quality and household health.

6. Pay attention to waterproof isolation.

In the process of building water and sewage pipelines, it is necessary to pay attention to waterproof isolation, such as waterproof partition walls, waterproof technical measures, etc., to ensure that the water supply and water supply system is effectively isolated from the surrounding environment, and to avoid problems such as cross-infection caused by sewage entering the room.

7. Reasonable arrangement of furniture and decoration.

After the completion of the renovation of water supply and water, it is necessary to reasonably arrange the furniture and decoration, especially in the bedroom and kitchen and other areas with drainage facilities, and use waterproof materials for decoration to ensure the waterproofness and hygiene of the house.

To sum up, the renovation of water supply and sewerage in old houses is a cumbersome and complex project, which requires professional evaluation and careful rock construction to ensure the quality and safety of the water supply and water supply system. At the same time, it is also necessary to increase maintenance and maintenance to prevent the occurrence of problems such as pipeline blockage and ensure the health and safety of the living environment.