Does Zotye T700 have an abnormal sound when playing in the direction?

1. Friction between plastic parts.

Because the steering wheel is usually made of plastic parts, if the temperature becomes colder, the plastic will harden, and there is a natural possibility of friction sound.

2. Abnormal noise coming from the steering wheel.

If the abnormal sound comes from the steering wheel, then the problem is likely to be caused by the airbag hairspring in the steering wheel, remove the steering wheel airbag hairspring and apply some butter to see if it still sounds, if it still rings, replace the airbag hairspring, because the airbag hairspring is damaged. Be careful to remove the steering wheel gently, or unplug the airbag fuse to avoid the airbag from deploying.

3. The ball joint of the steering tie rod is aging.

If the steering tie rod ball joint is aging, then it will cause the steering wheel to shake and make a sound, which is usually replaced by the steering tie rod ball joint and the four wheel alignment after replacement.

4. The abnormal sound emitted by the balance bar.

If it is not the sound of the shock absorber, then check whether the balance bar glue is loose or damaged, the balance bar glue is loose and damaged, not only will it sound when playing in the direction, but also make a sound when crossing uneven roads, and the loose balance bar glue can be solved by adding gaskets, and if it is damaged, it can only be replaced.

5. The plane bearing of the shock absorber makes an abnormal sound.

Just open the front cover to listen to whether the sound comes from the position of the top seat of the shock absorber, so that you can know whether it is the sound of the plane bearing of the shock absorber, the plane bearing of the shock absorber sounds, you can apply some butter on the plane bearing, if it still rings after coating, it can only be replaced.

6. Steering machine failure.

If the abnormal noise during steering is very large, then it may be caused by too large gear clearance between the steering machine and the steering machine, and the steering machine needs to be replaced.

7. Improper tightness or aging of the power belt.

For mechanical hydraulic assistance, if the power belt is not properly tightened or aged, there will be an abnormal sound, adjust the belt tightness or replace the belt.

First of all, when playing in the BAI direction in situ, there are two main parts to listen to the sound of du: one is the sound of the friction between the wheel and the ground, and the other is the sound of the DAO direction helping the system to work. This is normal.

Secondly, the steering wheel of your vehicle is a little to the right, which should first check whether the tire pressure on the left and right sides of the tire is consistent, if it is consistent, it is often a problem with the wheel alignment parameters, which can be solved by doing a four-wheel alignment.

If there is an abnormal sound when playing the direction, think about it, is it a problem with the steering machine? If there is no problem with the steering machine, it should be that the ball head is loose, or there is a foreign object to have such a sound, the best way is to go to the after-sales service, or go to the repair shop to disassemble it to not know what the specific cause is, and then solve it according to the reason.

1. Sounds coming from inside the car.

1.The sound of the snap clip after the turn signal.

If the steering wheel will have this sound after hitting the steering switch, it is the sound of the rebound clip of the turn signal automatic return mechanism, and this sound is normal. There will be a pimple sound when you hit the steering wheel, and there will be three pimple sounds when the steering wheel turns around, because the steering column has three automatic return card positions in a circle, so this sound will appear. As soon as the turn signal is turned off, the sound will disappear.

2.The sound of the direction post dust jacket.

Regardless of the place or driving, as long as you hit the steering wheel, you will hear the sound coming from under the steering wheel, you should check the steering post dust jacket, once the steering post dust jacket lacks lubrication, it will produce a dry friction sound, as long as you apply some butter in the dust jacket, the sound will disappear.

3.The sound emitted by the interference of the airbag hairspring.

When playing the direction, the sound is emitted from the steering wheel, most of this problem is caused by the interference of the airbag hairspring in the steering wheel, remove the steering wheel airbag hairspring and apply some butter to see if it still sounds, if it still rings, replace the airbag hairspring, because the airbag hairspring is damaged.

Second, the sound coming from outside the car.

1.The sound of the flat bearing of the shock absorber.

Hit the steering wheel to hear the sound is made from many outside the car, this may be the sound of the plane bearing of the shock absorber lack of oil, as long as you open the front cover to listen to whether the sound is from the position of the top seat of the shock absorber, so that you know whether it is the sound of the plane bearing of the shock absorber, the plane bearing of the shock absorber sounds, you can apply some butter on the plane bearing, if it is still loud after coating, it can only be replaced.

2.The sound of the glue loosening of the balance bar.

The sound is not emitted from the plane bearing of the shock absorber, it is necessary to check whether the balance bar rubber is loose or damaged, the balance bar rubber is loose and damaged, not only will it sound when playing in the direction, but also make a sound when crossing uneven roads, and the loosening of the balance bar rubber can be solved by adding a gasket, and if it is damaged, it can only be replaced.

Steering wheel. The reasons for the sinking are: 1. Insufficient booster oil, 2. Tire pressure.

If it is too low, the nuclear potato 3, the bearing fit is too tight, and the 4. booster problem can be dealt with according to the actual situation.

1. Insufficient booster oil.

Generally, the feeling of the weight of the direction is relatively constant, if it suddenly becomes very heavy one day, or slowly becomes heavier, it may be that the steering power oil is dirty, it is similar to the engine oil, and it needs to be replaced. Or if there is less oil leakage, then there is less power, so the steering wheel becomes very heavy. In this case, it is necessary to maintain it in time, or to add and change the steering oil.

2. The tire pressure is too low.

If the tire pressure is too low, the area of contact between the tire and the road surface will increase, the friction will increase, and the steering difficulty will increase, resulting in a heavy steering wheel, which is not conducive to driving safety.

3. The bearing fit is too tight.

For each rotation of the Lee's shirt is connected to the system with a rolling bearing.

In this case, the mechanical part and the booster system should be checked, or whether the cavity has leaked oil inlet seal damage phenomenon.

4. Booster problem.

The relationship between the steering wheel and the booster is inseparable, so when the steering wheel becomes very heavy, it is likely that there are some poor circuit contacts or other problems inside the booster system, which should be repaired by the 4th shop.

1.Failure problem of power booster pump: when the pump pressure of the booster pump does not reach the standard value, the heavy phenomenon will occur when using the steering wheel, and the flow control valve needs to be detected. Replacement of booster pumps;

2.If the steering wheel becomes heavier due to the steering engine oil pressure, it needs to be repaired by a professional manufacturer, and it is not recommended that the car owner deal with it by himself;

3.Lack of oil or air in the steering system: When there is air in the steering system of the car, not only the steering is heavy, but also there can be noise during steering, which needs to be dealt with immediately to prevent greater losses; Need to vent air or refuel;

4.Blockage of the oil return filter in the oil storage tank: When the oil return filter in the oil storage tank is not maintained or replaced for a long time, it is easy to cause blockage, which affects the poor circulation of the power assist oil and makes the steering wheel heavy; Replace the filter.

This happens because the air in the steering system is not completely discharged from the system due to an oil leak. If the steering pump is operated in a state of oil shortage for a long time, it can also cause severe wear and tear, which will reduce the performance of the steering system. The repair of oil leakage from the steering pump can be solved by replacing the sealing rubber ring and oil seal, and the assembly must be replaced when it is necessary.

Cars equipped with vacuum power steering will not rotate after the engine is started, unless the booster pump is broken. There is a problem with the power steering power pump of the car, when the car is steering, the torque will be "felt" to the torque of the steering wheel and the direction of the intended rotation, and these signals will be sent to the electronic control unit through the data bus, and the electronic control unit will send action instructions to the motor collapse controller according to the data signals such as the transmission torque and the direction of the proposed rotation, so that the motor will output the corresponding size of the torque according to the specific needs, thus producing power steering.

Summary. Method steps.

1 1 Step by Step Reading.

The left and right turn signals flash at the same time, which is generally caused by pressing the double flashing lights, and turning off the double flashing lights is OK.

1. Accidents occur and other vehicles are alerted;

2. Turn on the double flashing lights when parking on the side of the road to avoid rear-end collision;

3. The car double jump light is commonly known as the car double flashing light, that is, the two turn signals flash together, and there is a button with a red triangle on the dashboard of the vehicle, which can be turned on by pressing it;

4. However, since the double flashing lights have been turned on, the pedestrians and vehicle drivers behind will understand that the vehicle in front may be faulty, and they are already alert, so most models do not have the function of steering priority.

Method Step 1 1 Step by step to read the left and right turn signals flashing at the same time, generally caused by pressing the double flashing lights, turn off the double flashing lights. 1. In the event of an accident, it will cause its blind source to travel to other vehicles; 2. Turn on the double flashing lights when parking on the side of the road to avoid rear-end collision; 3. The car double jump light is commonly known as the car double flashing light, that is, the two turn signals flash together, and there is a button with a red triangle on the dashboard grinding pin of the vehicle, which can be turned on by pressing it; 4. However, since the double flashing lights have been turned on, the pedestrians and vehicle drivers behind will understand that the vehicle in front may be faulty, and they are already alert, so most models do not have the function of steering priority.

Whether the ball head of the steering machine is loose. The rack and pinion inside the steering machine are worn.

In this case, it is difficult for ordinary car owners to distinguish which ones are abnormal noises and which ones are reasonable abnormal noises. Only nearly 20% of the vehicles that went to the repair shop to detect abnormal noises really had problems. In the case of a turbocharged engine, the sound of the rattle and the naturally aspirated engine must be present to produce the sound of friction; After some car owners come into contact with different cars, it is likely that due to their lack of understanding of mechanical knowledge, they mistake reasonable abnormal noise as a vehicle failure.

Therefore, learn to distinguish the abnormal noise of the car and avoid wasting time and energy.

How to identify the sound of a car:

In practice, due to the limitations of working conditions, it is difficult to measure the sound of the car with special instruments, and the sound of the car can only be described and compared with the judgment of the sound in daily life. For example, the "rattle" sound caused by the dry friction of the bearing, and the "click" sound similar to the small hammer hitting the cement floor caused by the excessive valve clearance.

1. Correctly distinguish between normal and abnormal sounds.

The vibration of each mechanism in the work of the car will emit a variety of sounds, but the sound does not mean that the car is faulty, in order to avoid unnecessary disassembly, we must first distinguish between normal sound and abnormal noise. The normal vibration sound of each system component (such as the noise and hunger judgment sound on the engine surface), the impact sound of the gear when shifting, the air intake sound and exhaust sound with gas as the working source, and the gear meshing noise are all rotten and changed from the normal sound. Abnormal noise (abnormal noise) can be divided into slight noise, general noise and malignant noise according to the impact on the performance of the car.

Slight noise, such as the flashover sound of high-voltage electric leakage, the slight loose sound of rolling bearings, etc., the general volume is small, the degree of wear of the parts is not large, and there is no significant change for a long time, and this kind of fault can still maintain the normal operation of the car without repair.

3. When diagnosing the abnormal noise of the car, attention should be paid to creating good auscultation conditions and trying to eliminate the interference of other noises, so as not to affect the accuracy of judgment.

It is best to consciously amplify or reduce the sound, that is, use a screw or other metal rod as a stestological instrument to contact the sound part to amplify the sound, or use a single cylinder fire cut-off to reduce the sound to meet the diagnostic needs. The auscultation site should be kept quiet to minimize human interference.

Summary. Hello dear, Zotye Z500 has an abnormal sound when the steering wheel is played to the right, and there is no abnormal sound to the left. First, if it is a sound coming from under the steering wheel, this is the key to check the airbag oil wire under the steering wheel.

Second, if it is the sound made by the chassis of the vehicle, this situation focuses on checking the outer cage on the right side, and the outer cage is damaged, which is prone to this situation. The third is the phenomenon caused by the aging of the top rubber or plane bearing on the seat of the vehicle shock absorber, and the top rubber and plane bearing need to be checked. Hello, I hope I can help you, I wish you a happy life, good luck, eternal youth, if you have any questions, you can consult at any time, I will reply to you as soon as possible.

Hello dear, Zotye Yinyu Z500 has an abnormal sound on the steering wheel to the right, and there is no abnormal sound to the left. First, if it is a sound coming from under the steering wheel, this is the key to check the airbag oil wire under the steering wheel. Second, if it is the sound from the chassis of the vehicle, this situation focuses on checking the outer cage on the right side, and the outer cage is damaged, which is prone to this situation.

The third is the phenomenon caused by the aging of the top rubber or plane bearing on the seat of the vehicle shock absorber, and the top rubber and plane bearing need to be checked. Hello, I hope I can help you, I wish you a happy life, good luck, eternal youth, if you have a problem about rolling at any time, I will reply to you as soon as possible.

When you hit the right direction, it sounds like you're sharpening iron, but when you hit the left, there is no sound.

The core bearings and half shafts have also been replaced, but the problem is still the same.

Is there such a sound as you lift the car up and hit the direction?

Is there such a sound as you lift the car up and hit the direction? Does it feel like it's inside the cab, or is it the chassis position?

Lift up on the lift to play direction, that doesn't want to run to have a sound.

Then check the plane bearing on the upper seat of the vehicle's shock absorber.

The sound of running is that when the main driver turns to the right, the sound is like grinding iron, and the sound is very loud, like a left turn with a good bend of the pin.

In this case, it is important to check the flat bearings on the upper seat of the shock absorber or to look at the brake pads of the vehicle.

In this case, it is important to check the flat bearings on the upper seat of the shock absorber or to look at the brake pads of the vehicle.

The plane bearing has been checked and there is no problem, but the shock absorption is not in place, and the steering machine that I have ground the brake pads and the brake disc is also replaced.

If you lift the car up normally like this, there should be a sound. Or put on a special flat mopping equipment, and then try it in the same direction.