How do you maintain wooden furniture?! I don t know anything

Nowadays, solid wood furniture is generally favored by consumers for its natural and environmental protection. But the maintenance of solid wood furniture is also a problem, bothering many people, the following will teach you a few tricks of solid wood furniture maintenance knowledge.

Solid wood furniture maintenance 1Regularly clean the surface of solid wood furnitureThe surface of solid wood furniture is coated with paint, and the maintenance and maintenance of its paint film is particularly important, once the paint film is destroyed, it will not only affect the appearance, but also further affect the internal structure of the product. Therefore, the solid wood furniture should be kept clean frequently, and the pure cotton dry soft cloth can be gently tried to remove the surface dust every once in a while, and the dust at the corners of the solid wood furniture should be wiped clean with wet cotton silk wrung out of the water, and dried with a clean dry soft muslin cloth.

Solid wood furniture maintenance 2Regular waxing is generally not done every other week to protect the furniture paint and wood, and form a protective film on the surface of solid wood furniture. However, before waxing, be sure to dry the moisture on the surface of solid wood furniture.

Regular waxing not only maintains the solid wood furniture, but also increases his brightness, pay attention to the selection of wax must be cautious and do not use inferior products containing chemical corrosive ingredients.

Solid wood furniture maintenance 3Do not use chemical solvents to decontaminate the surface of solid wood furniture, if there are stains, do not rub them vigorously, and do not use chemical solvents to remove the stains. It is recommended to gently remove the stain with warm tea water, wait until the water has evaporated, apply a little light wax to the original area, and then lightly grind several times to form a protective film.

Solid wood furniture maintenance 4To avoid dampness indoors in humid summer, it is advisable to use thin rubber cushions to separate the parts of furniture that are in contact with the ground, and at the same time keep a gap of 1 cm between the wall part of the solid wood furniture and the wall.

Solid wood furniture maintenance 5Avoid direct sunlight should try to avoid long-term exposure of outdoor sunlight to the whole or part of the furniture, and it is best to place it in a place that can avoid sunlight or use transparent gauze curtains to separate direct sunlight.

Solid wood furniture maintenance 6Moisturizing unreliable moisture The moisture of solid wood furniture cannot be provided by moisture, that is to say, it cannot be simply wiped with a wet rag, but should be used professional Bilizhu furniture care wax, which is more likely to be absorbed by wood fibers, which can prevent wood from drying out and deforming, and at the same time nourish wood, and make wooden furniture regain its brilliance and prolong its service life.

Solid wood furniture maintenance 7Away from the heat source, it is best to place the solid wood furniture about 1 meter away from the heating current in winter, so as to avoid local dry cracking of the wood caused by long-term high baking, and local deterioration of the paint film of the deformation meter.

Wax regularly... Mahogany needs to be maintained.

In fact, it's not so troublesome, if it's a paint surface, don't put the high temperature things directly on it, so as not to make the paint discolored and ugly, and don't let the furniture be exposed to the sun for too long (you need to pay attention to it in summer, everything else is fine) so as not to warp and deform some unstable wood, because you don't know what kind of wood you buy it, don't put it in a humid environment for a long time. Note that the above three items include your furniture for 5 years. If you need other help, please leave me a message.

Furniture is more wooden, the five elements of the fiber model is prosperous, wooden furniture gives people a high-end atmosphere, so wooden furniture has been loved by many people, so how should wooden furniture be maintained? Let's introduce to you how to maintain wooden furniture! Give some help to those of you who have wooden furniture at home!

Wooden furniture and maintenance methods:

1. Pay attention to the cleaning and protection of the appearance of the furniture, should always insist on cleaning, gently wipe off the floating dust on the surface with a pure cotton dry soft cloth every day, every once in a while, use the wet cotton silk to wring out the moisture The dust at the corners of the furniture is finely cleaned, and then wiped dry with a clean dry soft muslin cloth, or it can be coated with a thin layer of high-quality wax after drying, and gently scrub the luster like rubbing leather, which not only maintains the wooden furniture, but also increases its brightness.

2. Do not use alcohol or gasoline and other chemical solvents to remove stains. If there are stains on the appearance of furniture, do not rub vigorously, you can use warm tea to gently remove the stains, and after the water evaporates, apply a small amount of light wax to the original part, and then gently rub it a few times to form a protective film.

3. When cleaning, do not use hard objects for cleaning. Such as brushes and steel wool balls. It is also necessary to pay attention not to let hard metal products or other sharp objects collide with the furniture, and protect its surface from bruises.

4. Wooden furniture should be avoided in a humid environment, if the indoor damp, moisture-proof items should be used to separate the furniture from the ground in contact with the parts of the shed, and at the same time keep the gap between the wall part of the furniture and the wall.

5. Keep away from heat sources. In winter, it is best to place the furniture about 1m away from the heating flow to avoid long-term high baking, which will cause local cracking and deformation of the wood.

6. Try to avoid using oil-based furniture cleaners, so that the surface of the product will be whitened.

7. Please do not place overheated food and rough bowls on the table, so as not to damage the surface of wood products.

After reading the wooden furniture maintenance tips introduced above, is it a further understanding of wooden furniture maintenance? I hope this introduction can help you! If you want to know other related information, please continue to pay attention to this **, more exciting stay tuned!

Solid wood furniture is mainly divided into traditional and modern. Traditional hardwood furniture generally has no lacquer on the surface, just hot wax. Newly produced hardwood or other solid wood furniture is now protected by lacquer or varnish.

The solid wood furniture of our Yipu family is only treated with pure natural wood wax oil cover, which is very healthy and environmentally friendly. There are different maintenance methods for solid wood furniture with different treatments. 

1. Solid wood contains water, and hardwood furniture will shrink when the air humidity is too low, and expand when it is too high. Generally, solid wood furniture has a lifting and shrinking layer during production, but it should be noted that it should not be placed in a place that is too humid or too dry, such as near a high temperature and high heat place such as stove heating, or a place such as a basement that is too humid, so as not to produce mildew or dry cracking. 

2. Solid wood furniture sticks to the oil, residual tea is an excellent detergent, after wiping, spray a small amount of corn flour to wipe, and finally wipe the corn flour. Corn flour absorbs all the dirt that adheres to the surface of the furniture, making the paint smooth and bright. 

3. If the surface of solid wood furniture is white wood paint, it is easy to turn yellow over time, you can wipe it with a rag dipped in toothpaste, and be careful not to use too much force. You can also stir the two egg yolks well, apply them to the yellowed area with a soft brush, and carefully wipe them clean with a soft cloth after drying. 

4. Avoid placing too heavy items on the surface of the furniture for a long time, otherwise the furniture will be deformed. Even if it is a table made of solid wood, it is not advisable to lay non-breathable materials such as plastic sheeting on the tabletop. 

5. The surface of the furniture should avoid friction with hard objects, so as not to damage the surface texture of the paint and wood, such as placing porcelain and bronze and other decorative items to be particularly careful, it is best to pad a soft cloth. 

6. If the floor in the room is uneven, it will cause the furniture to deform for a long time, and the way to avoid it is to use small wooden pieces to flatten it. If it is a bungalow or a low-lying house, the furniture legs must be properly raised if the ground is wet, otherwise the legs are prone to moisture corrosion. 

7. Never wipe solid wood furniture with wet rags or rough rags. Use a clean and soft cotton cloth, add a little furniture wax or wood wax after a period of time, and gently rub it back and forth along the wood grain. 

1. Keep away from heat sources. Generally, the heat resistance of wooden furniture is relatively poor, and too close to the heat source will cause the wood to lose water, resulting in dry cracking and deformation of wooden furniture. Therefore, wooden furniture should be protected from direct sunlight, and at the same time, try to stay away from heaters, heaters, lamps, etc. Mul.

2. Dust removal regularly. Wooden furniture needs to be dusted frequently, as dust rubs against the surface of solid wood furniture on a daily basis. It is best to clean with a clean, soft cotton cloth rather than wiping with a sponge or dishwashing utensils.

When dusting, you should use a soaked and wrung out cotton cloth, because wet cotton cloth can reduce friction and avoid scratching furniture, and it also helps to reduce the adsorption of static electricity to dust, which is conducive to removing dust from the surface of furniture. However, moisture should not remain on the surface of the furniture, so it is best to wipe it again with a dry cotton cloth. Mul.

3. Waxing. Waxing is very necessary, the furniture that is often waxed looks as bright as new, the wax can effectively protect the furniture, and the waxing interval is best not to exceed three months.

1. The furniture becomes new.

Milk can also be used when it expires! Wiping down wooden furniture with a cloth dipped in milk not only removes dirt, but also makes it shine like new. In addition, milk contains a certain amount of oil, so it does have a certain moisturizing and anti-cracking effect on wooden furniture. However, you should be reminded that after this, be sure to scrub it again with clean water, otherwise, you will have the milky smell and stickiness of milk!

2. Eliminate wax marks.

In order to engage in romance, put.

Wax oil drips on the wood.

The furniture is painted, are you annoyed?! Don't scrape with a sharp blade or fingernails, don't think it's so simple, wait until the light is good during the day, use a plastic sheet (the sheet should not be too sharp, to prevent scratching the tabletop) with both hands, tilt forward and the tabletop about 30°, slowly scrape off the wax oil from the front of the body, and then wipe it with a fine cloth.

3. Eliminate scald marks.

Cups, plates, etc., filled with hot water and hot soup are placed directly on the lacquered surface of the furniture, sometimes leaving a circle of white burn marks. Generally, as long as kerosene, alcohol, etc

Wipe with a damp cloth with toilet water or strong tea. If the scald marks are too deep, you can soak the towel in warm water and wring it out, drip a little ammonia, then rub the towel with the palm of your hand to make the ammonia cover the palm, and then gently and quickly pat the burn mark with the palm of your hand, and finally apply a layer of wax. In this way, burn marks can be eliminated.

4. Eliminate abrasions.

If the lacquer surface of the wooden furniture is abrasional and does not touch the wood under the paint, you can use crayons or paints of the same color as the furniture to apply crayons or paints to the wound surface of the furniture, cover the exposed base color, and then use transparent ones.

A thin layer of nail polish is sufficient. Some wooden.

Antique furniture. Precious anomaly, but accidentally wiped off a small piece.

Varnish, it's a pity, I feel incongruous when I look at it. Don't worry, this method can also be used.

5. Eliminate water stains.

Can be covered with a damp cloth.

On the imprint, then use.

The iron carefully presses the damp cloth several times, and the marks will evaporate into moisture when exposed to heat and disappear.

Dust should be removed frequently, as dust rubs against the surface of solid wood furniture every day. It's best to use a clean, soft cotton cloth, such as an old white t-shirt or baby cotton diaper, and remember not to wipe down your furniture with a sponge or dishwashing supplies. Please use a soaked cotton cloth when dusting, because a wet cotton cloth can reduce friction and avoid scratching the furniture, and at the same time help to reduce the adsorption of static electricity to dust, which is conducive to removing dust from the surface of the furniture.

When it is necessary to avoid moisture residue on the surface of the furniture, it is recommended to wipe it again with a dry cotton cloth. When you dust furniture, remove the decorations from the furniture and handle them with care.

In addition to frequent dusting, wooden furniture surfaces are sometimes varnished to remove smudges and small particles to enhance the aesthetics of the appearance. We recommend regular maintenance of your furniture with a special furniture polish. There are usually two types of polishes, one is for furniture with a high gloss finish and the other is for furniture with a matte or low gloss finish.

Also, be sure not to choose polishes that contain silicone, as silicone will not only soften and destroy the coating, but it can also clog the pores of the wood, making repairs difficult.

Although regular varnishing does not harm the coating, we recommend that you only varnish 2 or 3 times a year. Over-glazing can damage the appearance of the coating.

Apply the polish to a clean, soft, white cloth, preferably with natural fibers such as cotton. Please use polish sparingly, as only a small amount of polish is needed to keep it for a longer time. Rub the polish into the furniture in the direction of the wood grain.

Use the other side of the cotton cloth and, if necessary, another soft cloth to wipe off excess polish from the surface of the furniture. *Avoid excessive friction during the glazing process. Excessive friction can actually be detrimental to matte coatings, and in severe cases, can lead to uneven gloss on the surface of furniture.

In order to remove pollutants from the air, fumes from cooking, stains from handling and traces caused by residues from glazing, we recommend using a special furniture cleaner. This solvent also helps to remove excess wax and prepares it for varnishing. Although special furniture cleaners can be used regularly without damaging the coating, we recommend using them only 2 to 3 times a year.

It is recommended that you follow these steps for cleaning: Pour a small amount of furniture cleaner onto a clean, soft cotton cloth. Wipe the surface of the furniture in the direction of the wood grain, then turn the cloth over and wipe it again until all the detergent is removed. Implement proper furniture glazing procedures. Regardless of the type of cleaner used, it's a good idea to test your furniture in small patches in an inconspicuous location before wiping it all down to make sure your furniture paint hasn't softened or even been wiped off all together, and hasn't had any other adverse reactions.

We recommend not waxing your wooden furniture. Waxing is not good for a good finish, wax stains can make the wood coating dull. Markor Furnishings sells furniture with a high-quality finish that doesn't need to be waxed. If there is damage, consult a furniture repair professional.