Can the flash server obtain the customer s hardware configuration information?

Don't even think about it, the difficulty of cracking it is unprecedented, so even foreigners have given up.

Installation Environment:

Before you install Oracle Database, you must specify the requirements for system installation.

1) Hardware Environment:

The hardware requirements for installing an Oracle 10G database are shown in the table.

The speed of the processor and the size of the memory directly affect the speed at which the Oracle runs. Therefore, it is recommended that the higher the hardware configuration, the better. In general, the server configuration should be higher than the client configuration, and the higher the configuration, the faster the installation.

2) Software environment The software requirements for installing the oracle10g database are shown in the table.

1 Hardware environment requirements for installation.

The following describes the hardware environment requirements of Oracle 9i in five main areas.

1.CPU requirements.

The minimum CPU configuration to Pentium 166 is sufficient.

2.Memory requirements.

The minimum memory capacity is 64MB, preferably more than 256MB.

3.Requirements for hard drives.

It is recommended to configure a hard disk with a capacity of 8GB or more.

4.Requirements for optical drives.

It is recommended to use a fast optical drive, with a speed of 16 times or more.

5.Requirements for NICs.

Generally, you can choose 10 100MB adaptive network cards. For more information, please click here.

It's impossible, it's too stuck with 2g.

If you don't want to be too troublesome to set up.

There's a very simple way.

Remotely install a QQ on the server

Then upload the file to QQ on your local computer.

If you set up AD, the DNS server and the DC are on the same server, so the DNS server itself is in the AD domain, so you don't need to join or do other operations to join the domain.

If you need other clients to join the domain, you need to first click on Computer --> Properties --> to change the computer name or domain. As shown in the figure, then the store changes the settings, and changes the name of the group to the domain name of your AD, and enters the account password.

For DNS, you first need to create a forward and reverse lookup zone, set a DNS in the forward lookup zone, which is a local A record, and run ipconfig registerdns locally to register a reverse record.