Is the ISO system displayed by the USB flash drive display not a valid image file?

If it's not the official version, like what depth, the system home, these three parties make system images, you can decompress the ISO image file, get the GHO file, and then install it, if there is no GHO file, then there should be a direct installer such as setup, and you can install it in one step by clicking on the installation file.

The image file that is not displayed is valid - in which software?

The most convenient and effective way is this:

1. Start PE on the U disk.

2. Run, load the ISO file.

Third, after loading, it becomes a hard disk partition (read-only), and directly manipulates its Chinese files!

Fourth, according to the ISO type, select: 1. Install the system; 2. Ghost recovery system installation.

This is the ghost image installation tool.

If it's an original image, there are tools that can be installed in the PE generally.

It means that there is still no valid image file on your computer, which is the best system. First of all, when the computer can access the Internet normally, the image file is stored in a non-system disk, or it can be stored when making a U disk. That's it.

It may be that the format is not supported. What kind of format did you choose?

Enter the PE installation system and click the ISO file prompt, the file you selected is not an ISO image file, it is caused by the wrong setting, the solution is as follows:

1. First of all, you need to prepare a USB flash drive boot disk, then connect to the computer, restart the computer, press the current system's boot shortcut key when the boot screen appears (most computers are F8 or F11), and then choose to boot from the USB flash drive.

<>6. At this time, the ISO file has been selected, no need to make any settings, just click "OK".

Enter the PE installation system and click on the ISO file.

The prompt is that the file you selected is not an ISO image file and is caused by a setting error, and the solution is as follows:

1. First of all, you need to prepare a USB flash drive boot disk, then connect to the computer, restart the computer, and press the startup shortcut key of the current system when the boot screen appears.

Most computers are F8 or F11) and choose to boot from a USB stick.

2. After entering PE, click "Start - Disc Tool - Virtual Optical Drive".

<>6. At this time, the ISO file has been selected, no need to make any settings, just click "OK".

Close the software and turn it back on.

1.Prepare 1 USB flash drive (the capacity depends on the system to be installed: Win XP needs a minimum of 1G, Win7 needs a minimum of 4G, Win8 and Win10 need a minimum of 8G);

2.On a normal computer that can access the Internet and has no viruses, follow the steps below to make a system installation USB flash drive:

Plug in the USB flash drive;

In Disk Manager, set the primary partition of the USB flash drive (if there is no need to create the primary partition first) as the active partition and format it as the FAT32 file system;

3 To the computer where the system needs to be installed:

Plug in the USB flash drive; There are two ways to operate after powering on:

One is to enter the BIOS and set the USB flash drive as the first boot, then save and restart (all motherboards can);

The second is to select Boot from USB flash drive in the boot menu (applicable to current mainstream motherboards).

As for which key (or key combination) to press to enter the BIOS or boot menu, each motherboard is different, you need to look at the screen prompt or refer to the motherboard manual when turning on the computer.

Start installing the system, format the system partition when selecting the installation location, and then proceed with the installation.

If you don't have any important information, format it all and reinstall it.

Dare to ask the landlord, what is a hard disk installer?