The practice of cloth bags, the practice of hand sewing cloth bags

According to the size of the cloth bag, the material used, and the production method is also different, the easiest way is to sew up the three sides and leave a gap.

The practice of not bringing a child, click on the group to check the production method of this kind of production without a group and the effect of the large group, and you will know whether the effect is good or not.

The practice of hand-sewing cloth bags is as follows:

Material preparation: scissors, needlework, old clothes, shoelaces.

Operation steps: 1. Prepare the raw materials, choose an old clothes that are not used, and use scissors to cut out the favorite graphics in your favorite place.

<>3. Use scissors to cut the two ends of the notch at the other end along the edge to a certain position (subject to the gap that the two bright shoelaces can pass through), press and fold, and sew it with a needle and thread.

4. Cut the prepared shoelaces into two sections, start to pass the shoelaces through the gaps in the bag, and tie the shoelaces at both ends in knots.

5. Thread the other lace through the gap in the opposite direction. With a slight pull, a small cloth bag that slides the keys and can be retracted freely is complete.

The production method of the cloth bag is as follows:

Materials: table pocket cloth (thin body to iron thin cloth lining), inner pocket cloth, 2cm wide webbing, cloth buttons, cotton belt (for buttoning buttons).

1. The table pocket cloth is front-to-front, and the three sides are stitched.

2. If you want to have a depth, you can grab the corner 8cm on each side, and you can cut off the upper corner about 1cm away from the seam after sewing.

3. The front to the front of the inner pocket cloth is stitched on three sides, leaving a gap of about 6cm-10cm on one side.

4. The inner bag should be grabbed with an angle of 8cm.

5. Flip the inner bag and put it into the watch pocket. Alignment, because there is a beautiful pattern on the inside and outside, so put the strap on the inside side and sew it together with the two bags. If there is a cotton tape, don't forget to put it in, and sew it along the edge after putting it away.

6. Flip the whole bag over from the gap in the inner bag. Then sort out the missing book, and use Tibetan seams to stitch the Muzhou macro gap. After tidying up, sew a row of topstitches on the top. It can be ironed before sewing. Nail the button at the end and you're done!

The introduction of the cloth bag:

Compared with other container types, bag-shaped containers have the characteristics of lightweight, foldable preservation, etc., and are widely used in all fields of social life.

Nylon cloth bag is a bag-like container made of nylon as the basic material, due to the characteristics of nylon, nylon bag has the advantages of waterproof, lightweight and tough, reusable and washable. Nylon cloth bags are durable and have a wide range of practical properties, and common shopping bags, backpacks, and thermal insulation bags are all nylon bags.

The bag is made as follows:

1. Prepare a cloth 70 cm long and 25 cm wide, and fold the long side in half.

2. Draw two lines on each edge of the long side, and take the child to sew them along this line.

3. Pay attention to make a mark with a colored pencil at 10 cm or 15 cm from the mouth of the bag, and then make a mark at the centimeter where the mark is in the direction of the mouth of the bag.

4. Then turn the mouth of the bag over to cover the position of the centimeter mouth.

5. Sew a circle on both sides of the centimeter mouth.

6. After sewing, turn the whole bag over and put a rope through the two left openings.

The bag on the left is the first marked at 10 cm, and the bag on the right is the first marked at 15 cm, the effect is different, you can choose by yourself.

Older children in the graduation stage, the fine motor and flexibility of the hand is still developing, sewing things with needles and threads is still not easy for them, if the child has a sparse place after sewing, adults can help make up for it, and adults can help sew it in difficult places.

Origin:

Handbags originated in the early 16th century, when European royalty and aristocrats held balls, and noble ladies and ladies carried rouge and lipstick with them. So they asked the tailor to make them a small and delicate bag, which could only be hung on the wrist. It won't affect their dancing.

What I can't figure out is that the little pocket was called by them at the time"Ridiculous play"。Throughout the ages, we have been inseparable from this"Ridiculous play"。

Jia Siqian (Northern Wei Dynasty) "Qi Min Technique-Sheep Raising": "Qu Mu is the man, and Zhang Sheng is a silk bag; Strain cooked milk and lie down in a clay bottle. "Such as: noodle bags. Packaging bags refer to bags used to pack various supplies, which are widely used in daily life and industrial production.

1. Two pieces of wrapping at the front and back, with pockets below.

2. Fold the two parts by merging the edges. Cut squares in centimeters at the lower corners.

3. Place these parts on the inside of the face and make side sutures, leaving centimeters. Iron and then cut off.

4. Adjust the pockets according to the principles shown in the pattern below, the center of each pocket should be on the side seam.

5. The distance from the bottom edge of the pocket to the square incision at the bottom of the bag is centimeters.

6. Turn the bag inside out, close the bottom together, and make the bottom seam (. Stitch and then cut out.

7. The bottom of the bag is stitched diagonally.

8. There are folds at the top of the bag. Adjust the main part of the bag to the front and make 2 marks sewn from each side: 8 cm and 5 cm stitches.

9. At the same time, adjust the lining to the front and place it on the main part. Combine the edges and side seams.

10. By combining the placed labels, place the folds in the center of the bag and fix them with bead needles. (Note: Both the main body and the lining are placed in the pleats).

11. On the top edge, place a line of centimeters on the edge, fixing the layer and folds.

12. Sew the top cloth strip.

13. Turn the bag over. Tie the top of the bag with a free edge, facing each other.

14. The cloth strip and the bag are aligned and sewn.

15. Cut off the excess cloth strips.

16. Fold the upper edge of the wrapping bag.

17. Determine the position of the installation ring buckle. To do this, measure the top edge of the bag and fold in centimeters bent to the center. Put a dot and circle it.

18. Install the ring buckle.

19. Cut off two 80 cm ropes, put them in the hole, and tie the knot. This completes my tote bag!

1. Take two pieces of cloth, draw a rectangle on the reverse side of one of them, and draw two 16x rectangles on the other cloth.

2. Cut these three rectangles separately, and pay attention to the distance between them and the line drawn 1-2cm.

3. Fold the side of the small rectangle inward twice, fold the second crease for the line drawn before, and sew it with a needle and thread or glue it firmly after folding.

4. The reverse side of the small rectangle is pressed down on the front of the large rectangle, and the lines below, square, and right are aligned respectively, and the number of bits is fixed with a bead needle, and the needle and thread are sewn along the distance from the drawn line to make a pocket.

5. Press the finished pocket down on the front of another large rectangle, align the drawn line, and sew the drawn line from the lower left corner to the lower right corner with a needle and thread, leaving an opening below.

6. Turn the cloth from the opening to the front.

7. Fold the cloth on the storage bag down, take a small piece of rope and fold it in half and hide it in the cloth. The folded flap and the front of the storage bag are sewn with a hidden needle or fixed with glue, and the rope is turned up and glued to the bag.

A bag is a commonly used item for storing or carrying items. To make a bag, you first need to prepare some materials such as fabric, stitching, zippers or buttons, etc.

Step 1: Measure the fabric. Measure the appropriate cloth according to the size of the bag you want and cut it off with scissors. If the fabric used has a pattern or pattern, it needs to be positioned before cutting.

Step 2: Sew the bag. Fold the fabric in half, keeping the inside facing the outside. Use a sewing machine or hand needle to thread the stitches and sew the sides and bottom together.

Step 3: Add zippers or buttons. If a zipper or button is required, it can be sewn onto the bag as needed to roll it out of position.

If you are using a zipper, you need to sew it on both sides of the bag mouth and reverse it to the inside of the bag. Finally, secure the zipper puller in the center of the bag opening.

Step 4: Dispose of the inside of the bag. If you need to add pockets or dividers to the inside of the bag, you can add them when stitching the sides with a void. If you don't need these features, you can skip this step and go straight to the next step.

Step 5: Process the bottom. Turn the bag upside down so that the inside becomes the outside. Keeping the sides open, straighten the bottom and fold the corners of the bottom into triangles and stitch them together.

The above are just some of the steps that have been briefly introduced to making bags, and the specific method of making bags will also vary depending on the shape, size, and material of the bag, as well as different needs. You can learn more deeply by looking at the filial piety frequency or consulting the book tutorials on how to make bags.

If you want to create a unique bag, we can also add some decorative or design elements according to your preferences and creativity, such as sewing beautiful embroidery, drawing patterns or printing your favorite text. These elements will make our bags a unique representation of us and make our lives more interesting and colorful. <>