How to use BAIC Phantom Speed Powder filtration, how to use the jack on the BAIC Phantom Speed Car

1. If you have an automatic transmission, you will hang D when you move forward, R will be hung when you reverse, and P will be hung when you stop and turn off; The manual gear is hung to D first, and it is pushed to the side, and if you want to increase the gear, push it up, and pull it down if you want to reduce the gear.

2. The manual automatic gearbox is a kind of transmission device that combines the functions of manual transmission and automatic transmission. This technology was developed to improve the economy and handling of automatic transmissions, allowing the timing of shift shifts, which are automatically determined by the computer, back into the hands of the driver, thereby improving the maneuverability of the driver and enriching the driver's experience.

3. The automatic manual transmission is a transmission mode that combines the manual shift and automatic shift of the car. This transmission combines the advantages of automatic and manual transmissions to minimize the power loss of the transmission system. Because the manual transmission can freely adjust the gear and speed according to the driver's subjective wishes, it has a pleasant feeling of driving, full of sportiness and driving fun.

The manual transmission with automatic manual transmission is different from the car with pure manual transmission, although the structure is equipped with a clutch device, but it does not need to be operated by the driver, that is, the automatic clutch. When using a manual transmission, the manual transmission only needs to be dialed to the manual transmission, and the gear can be adjusted up or down as the speed changes. If the speed can't keep up with the corresponding gear, then the gear will automatically be lowered downward; If the speed is higher than the gear you are in, you will need to dial up manually.

There are two kinds of car jacks.

One is mechanical, which is lifted and lowered by rotating the joystick of the handle.

One is oil pressure, which is to shake up and down to lift the jack, and there is an anti-pressure knob for landing. You can loosen it, and you need to tighten the knob to repeat the use of the embedded.

When jacking the vehicle, try to top the stable part that connects the girder. Do not top plastic parts or moving parts.

Take it out and tighten the pressure relief screws on it, I hope it can help you, I wish you a happy life! [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes cover Zen clock solution. 】

Hang d d on forward, hang r on reversing, hang p when parking and turn off (otherwise you can't pull out the key), if you want to manually hang d d on the side to push, if you want to increase the gear, push up and down the gear, manual automatic gearbox manual gear is generally limited by the engine speed, in about 2000 rpm to add the gear, otherwise you can't add it, and r, d gear must be stable to switch between the car to switch, n gear is the neutral short-term parking use, but you must step on the brake or pull the handbrake, there is also an s gear is also a forward gear, It's a sports gear, and the acceleration ratio is faster but relatively fuel-intensive.

Hello. The headlight switch is on the turn signal switch [If the car has a problem, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Yes, the noise will be much less [if you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello, the effect will be good [If you have a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】