What to do if there is too much water vapor in the bathroom integrated ceiling

Regarding the problem of how to deal with too much water vapor in the bathroom integrated ceiling, the main reasons for the leakage of the bathroom ceiling are as follows: 1. Damage to the upper and lower water pipes of the upstairs bathroom In the process of discharging the upstairs domestic wastewater to the main sewer pipe through the sewer pipe, if the sewer pipe is damaged, it will flow to the top of the downstairs bathroom through the broken place, and then cause the ceiling to leak; The water supply pipe laid on the wall or ground is damaged, resulting in water leakage; 2. The waterproof treatment of the upstairs bathroom is unqualified or the waterproof layer is destroyed Due to the unqualified waterproof treatment or the destruction of the waterproof layer, the water used in daily life leaks to the downstairs through the cracks of the waterproof layer, resulting in the leakage of the ceiling of the downstairs bathroom; 3. Leakage of water pipes laid in the ceiling Most of the cases occur at the top of the water pipe joint.

The bathroom water vapor can not be dispersed, it is recommended to make a good ceiling seal, the floor slab has water to no problem, I am afraid that your wall waterproofing is not in place, which will cause penetration into the bedroom wall and cause foaming and mildew.

Generally, there will not be a lot of water vapor in the exhaust while taking a shower, or the quality of the exhaust fan is not good, change it to a better one, and if it doesn't work, use two exhaust fans.!

Was it a long time after taking a shower, in the middle of the night? Then it is the result of the cooling of water vapor, it is recommended to make a good ceiling seal, the floor slab has water to no problem, I am afraid that your wall waterproofing is not in place, which will cause penetration into the bedroom wall and cause foaming and mildew.

Some of the exhaust fans are discharged to the ceiling; It's good if you don't go outside, just go outside.

If the gas water heater cannot be discharged, water droplets will form. At the same time, there is a danger of gas.

How can the car or you go can't get out? Nowadays, all gas water heaters are strong exhaust type, and there must be an exhaust pipe channel at the bottom to the outside of your house.

The gas water heater is mainly composed of valve body assembly, main burner, small fire burner, heat exchanger, safety device, etc., and also includes the flue of flue water heater and the strong discharge device of strong discharge water heater. The valve body assembly controls the working procedure of the entire water heater, which includes water valves, air valves, micro switches and ignitions. When installing a water heater, valves should be installed on the inlet pipe, outlet pipe, and gas pipe.

Under normal circumstances, the gas water heater is directly installed near the window, and a flue pipe is used to discharge directly through the window to the outdoors; Some are more particular, make holes in the wall, and then put the flue pipe outdoors.

Therefore, the installation of a gas water heater has little to do with the ceiling.

Yes. The relationship between the water heater and the ceiling is actually the relationship between the smoke pipe and the ceiling. If it's an integrated ceiling, there's no problem.

You can remove a few sheets and install the smoke pipe and then install it. If it is a plastic gusset, it will be troublesome to install the smoke pipe, but it can also be installed by tying the pipe with a rope and pulling it out.

After the paint is finished, leave the last pass, and then install electrical appliances, doors, lamps, ceilings, etc.

If the cabinet is installed, the water heater and range hood are installed and then the ceiling is lifted, if the cabinet is not installed, the water heater must be installed first to determine the location of the range hood.

To be honest, you can install it first, it doesn't matter which one you install first, but it is recommended to install a water heater first and then a suspended ceiling.

So as not to dismantle the ceiling and install the flue, the ceiling will be uneven.

The kitchen and bathroom are relatively close, so you should use a water heater when laying out the water pipes, right? Now the decoration of the kitchen and bathroom is integrated ceiling, and the disassembly and assembly are very simple.

As long as there is water and gas, it can be installed, but the gas water heater chimney is under the ceiling.

The problem of stainless steel hard pipes for smoke exhaust pipes can be solved.

The easiest way is to ask for a new board, draw a circle and cut a regular hole again. If you must solve the problem on the original ceiling, you can use tin tape to make an edge.

If it is not a digression, it is better to leave a gap between the exhaust pipe of the gas water heater and the ceiling. The tight fit is good-looking, but there are minor problems in terms of heat dissipation and safety.

The installation sequence of integrated ceilings and gas water heaters is gas water heaters first, and then suspended ceilings.

When the gas water heater is installed, in addition to the water heater body, the cold and hot water pipes need to be installed, and the smoke exhaust pipes need to be installed, and the ceiling can only be installed after the smoke exhaust pipes are installed.

The smoke exhaust pipe of a gas water heater is at a high temperature when it is working. It's not good to bury it in a kitchen cabinet.

Do not set it up in a suspended ceiling, as it is inconvenient to find leaks.

It is not necessary, as long as the water heater position is reserved, and then the gas water heater exhaust pipe is installed in advance, so as to save the need to disassemble the roof and install this pipe later.

The flue gas pipe of the gas water heater will emit high temperatures, and if it is too close to the gas pipeline, there is a risk of **.

The smoke pipe of the gas water heater is 10 cm away from the gas pipe, and it is installed on the integrated ceiling, so it is also possible. Reserve the pipeline position of the water heater first, and the position of the ceiling to be blocked should generally be installed first. Under normal circumstances, to decorate the kitchen, first install the ceiling, then install the cabinets, and then install the gas water heater, hanging.