How to deal with the automatic shutdown of the GAC Toyota Camry when waiting for the red light

The landlord, waiting for the red light to turn off may be caused by too much carbon in the volume of the electronic throttle, there should be no other faults, you can clean the throttle body after the test observation. Too much carbon in the throttle volume will cause the vehicle to be difficult to start, unstable at idle, or stall while driving, which can be solved after cleaning the carbon deposit. For vehicles driving in urban areas for a long time, it is recommended to clean the electronic throttle body every 15,000 kilometers and the injectors every 30,000 kilometers.

If the vehicle is in good road condition and can often drive at high speeds, then the cleaning cycle of carbon deposits can be appropriately extended.

There are several reasons for engine shake:

1. The engine has serious carbon deposits, and the most common car with serious shake is that the fuel injector throttle valve is too dirty or too much carbon;

2. Ignition system problems, check the working conditions of spark plugs, high-voltage wires and ignition coils;

3. The oil pressure is unstable, if the first pressure of the pump is abnormal or the error and poor work of the inlet pressure sensor will cause the body to shake;

4. Aging of engine parts; Excessive carbon deposits in engine emissions absorb carbon from the gasoline of the cold-start injector, which leads to a dilute cold-start mixture and difficulty starting.

Severe idle vibration is generally caused by engine cylinder failure, aging or loose foot rubber, carbon deposits, fuel system failure, etc.

1.Serious engine carbon deposits: Cars always have the problem of carbon deposits, including cylinder carbon deposits, throttle carbon deposits, spark plug carbon deposits, intake carbon deposits, etc.

When the engine has too much carbon deposit, it will affect the ignition energy, air intake efficiency and air-fuel ratio of the car, resulting in the unstable power output of the car, and the phenomenon of idle speed and acceleration jitter appears.

2.Unstable oil pressure: If you have cleaned the engine carbon deposits, cleaned the throttle, replaced the oil gasket and spark plug, etc.

And when idling, you still find that the body shakes, it is recommended that you go to the 4S shop to check whether the oil supply pressure and intake pressure sensor are normal, if the oil pump supply pressure is abnormal, or the intake pressure sensor value is wrong, and the work is not good, it will cause the body to shake.

3.Engine cylinder shortage: Engine cylinder deficiency mainly refers to the engine one or more cylinders are not working properly, which is generally manifested as:

The exhaust fumes coming out of the car are obviously intermittent, and the exhaust pipe shakes violently, and the engine shake can be clearly felt, sometimes accompanied by abnormal noises. This is mostly related to ignition coil failure.

4.Aging of engine parts: Shake in the car is also associated with the aging of the engine feet (also known as claw pads).

The engine foot is actually the shock absorber system of the engine. The engine feet are responsible for absorbing slight vibrations when the engine is running. If there is a problem with the engine base, these vibrations can be transmitted to the steering wheel and cab, causing vibrations at idle.

Solution; The best way is to clean the oil circuit, clean it regularly, there is no specific experience in the research and development parameters of the clean engine from the new car, coupled with the continuous improvement of emission standards, can not adapt to the change of fuel, all manufacturers of the engine are unable to solve this jitter problem in the short term, plus the fuel quality is not very good or the initial fuel of the new car factory is stored for too long, resulting in a rapid increase in the colloidal composition of the oil circuit, which will continue to pollute the fresh fuel and cause no good fuel to participate in combustion in the later stage. The occurrence of excessive carbon deposits is especially common for China VI vehicles. We can only gradually alleviate most of the problems by maintaining clean oil circuits. The use of PNF dope fuel additives can solve the problems caused by carbon deposition.

Hello, it should be caused by excessive carbon deposits, and it is recommended to clean the throttle. Have a great trip. If I can help you, please set it to, thank you!

Hello Just light the fire I hope my answer can be helpful to you, please set to, thank you!

Hello, it should be you in gear and the brakes are loose.

Usually, there are three reasons for the sudden shutdown of the car, one is the failure of the oil circuit, the fuel tank is out of oil or the oil circuit is blocked; The second situation is circuit failure, which may be caused by a power outage due to low voltage during driving, and the ignition is turned off; The third situation is device failure, generally the ignition coil has a problem, which will lead to the sudden shutdown of the car during driving, in fact, any situation we can prevent in advance and eliminate the hidden danger of traffic accidents in time.

Reasons for the sudden stalling of the car while driving:

1. Circuit fault;

2. Flameout caused by short circuit of low-voltage line: intermittent flameout; 3. Device failure: it can start at first, turn off after a while, and then start again, and then turn off again;

4. Oil circuit failure; The gasoline pump was damaged, the oil line was ruptured, the carburetor inlet was clogged, and the fuel tank ran out of oil.

5. There is a problem with the ignition system and the explosion-proof system for engine overheating.

When it is found that after the ignition is turned off, according to the road conditions at the time, if there is no emergency, you can slowly step on the brakes to prevent the tail light, after the speed is reduced, slowly play the direction, drive to the roadside lane, pay attention, the brake should be stepped on all the time, the power from small to large, do not step on it and then loosen, and then go to the pedal, which will lead to the only remaining vacuum is also consumed, and then step on it can not be stepped on, park the car on the side of the road, turn on the four flashing lights, place the tripod, and hit the ** rescue trailer.

In this case, the first thing to check is whether the pressure of the fuel is enough! Also look at whether it is a problem with the high-voltage line.

Summary. Hello, dear. The Toyota Camry stalls during driving because the vehicle engine has too much carbon, which is related to the quality of the oil and the poor sealing of the air door; Ignition system failure, low voltage circuit line connection is not cool, or high voltage line leakage; The starter is seriously aged, the start is weak, and it cannot ignite; The temperature is too low and the viscosity of the oil changes so that the rev is too low to drive the engine to ignition.

Hello, dear. The reason why the Toyota Camry extinguishes several fires while driving is because the vehicle engine has too much carbon deposit, which is related to the quality of the oil and the poor sealing of the air door; Ignition system failure, low-voltage circuit line connection does not stare at the air cool, or high-voltage line leakage; The starter is seriously aged, the starter is weak, and Kaihong can't catch fire blindly; The temperature is too low and the viscosity of the oil changes so that the rev is too low to drive the engine to ignition.

In addition, it is to check the gear, the car's gear is not right, it can also cause no ignition, generally in the P gear or N gear is the correct gear when starting, sometimes the dust regrets the car when it is more careless, put it in other gears, it will naturally cause the phenomenon of not ignition, and if the gear is not correct, it is easy to slow down and cause potential safety hazards.

When the headlight switch of the Toyota Camry car is placed in the case of auto, when parking at night, sometimes after turning off the disadvantage Linghuo switch and taking out the key to open the door, the headlamp cannot be extinguished normally, and you need to enter the car to manually turn off the combination switch.

It is a 2009 GAC Toyota Camry sedan with a range of about 120,000 km, a 40-liter ACV, and a 2AZ engine. User reflected: the car headlight switch in the case of auto, when parking at night, sometimes turn off the ignition switch and take out the key to open the door, the headlight can not be extinguished normally, you need to enter the car to manually close the combination switch.

Inspection and analysis: After repeated test drives, the maintenance personnel finally saw the fault phenomenon described by the user. The automatic lighting system action test was carried out with the fault diagnosticator IT2, and it was found that the system was working normally.

The parts involved in the headlights, the connectors and related wiring were inspected, and no abnormalities were found, and during the inspection, it was found that the car had been in an accident and parts such as the body control unit and the sunlight sensor had been replaced. A closer look at the data flow of the body control unit shows that the door switch on the driver's side sometimes appears abnormal, and the data is displayed as closed when the door is open. When this happens, the headlight control fails.

Remove the door control light switch on the driver's side, and decompose and inspect it, and it is found that the cause of the failure is that the sealing sleeve of the switch is damaged, causing dust to enter the contact part of the switch. Troubleshooting: Replace the driver's side door control switch, troubleshooting.

Photo by Q&A) M5 Xpeng P7 AION V Trumpchi GS8 Xpeng P5 Ideal ONE @2019

Summary. No, the light on the dashboard will turn on when the Toyota Camry is started, indicating that the vehicle has been started.

No, the light on the dashboard will turn on when the Toyota Camry is started, indicating that the vehicle has been started.

You've done a great job! Can you elaborate on that?

A: When the 2008 Toyota Camry starts, the lights on the dashboard are temporarily turned off. This is due to a momentary power outage in the vehicle circuit when the vehicle is started, which causes the lights of the instrument slag cave to go out.

Solution: Shed 1Check the vehicle circuit to ensure that the circuit is working properly to avoid the occurrence of power failure.

2.Check the bulb on the instrument panel to make sure the bulb is of good quality to avoid the bulb going out. 3.

Check the vehicle's battery to ensure that the battery is sufficient, so as to avoid the power failure caused by the insufficient battery power of the chain beam. Personal Tips:1

Regularly check the vehicle circuit to ensure that the circuit is working properly to avoid the occurrence of power outages. 2.Check the bulbs on the dashboard regularly to ensure that the bulbs are of good quality to avoid the situation where the bulb goes out.

When the vehicle is started, there will be a momentary power outage in the vehicle circuitry, which will cause the lights on the instrument panel to go out. At this point, the problem can be solved by checking the vehicle's circuitry, the light bulb on the dashboard, and the vehicle's battery.