What are the precautions for making a partition in the bathroom?

Updated on home 2024-07-14
6 answers
  1. Anonymous users2024-02-12

    Be sure to pay attention to the water stains and dirty things in the corners, in fact, you should also pay attention to the water stains on the wall, and you must deal with the problem of hygiene, otherwise it may smell very bad in the later stage, and if you don't clean it, the home will look very sloppy.

  2. Anonymous users2024-02-11

    We must pay attention to the hygiene, and secondly, we should also pay attention to the problem of isolated water stains, and we must deal with some subtle corners, because if you don't deal with it well, there may be an unpleasant smell, and you should also pay attention to the cleanliness of the glass, otherwise it will look sloppy, so that you can make a partition, otherwise there will be a lot of trouble, and it will be difficult to clean in the later stage.

  3. Anonymous users2024-02-10

    The partition in the bathroom can not only save space, but also effectively separate dry and wet, which is very practical. Next, I will explain to you the precautions for the installation of sanitary partitions.

    1. After laying floor tiles and wall tiles, then make a sanitary partition wall: When decorating the bathroom, the floor tiles and wall tiles should be paved first, and then the sanitary partition wall should be customized according to the actual required size. It should be noted that sewer pipes and floor drains must be installed before laying floor tiles, and at the same time, it is necessary to consider the possible errors on the upper and lower walls, and customize the glass door according to the actual size to install and use.

    2. Consider the water repellency of the door frame threshold: consider whether the glass partition of the bathroom has a door rental frame that can block water, if there is no special shirt type hand-mounted door or sill stone, the general threshold stone should be higher than the ground, otherwise the shower water flows out from under the door, and the purpose of dry and wet partitioning cannot be achieved, which is easy to cause inconvenience. It should be noted that you should never use the slide, because the water and dust in the slide are difficult to clean, and it will stink after a long time.

    3. Hand rods should be installed on the side of the bathtub: the bathtub in the bathroom is a place where the whole family members need to take a bath, and there are water, shower gel and other risk factors in the bathroom that are easy to cause slipping, for the sake of safety, it is recommended to install a hand rod on the side of the bathtub as much as possible, especially if there are elderly and children at home, it is necessary to pay more attention to this detail.

    4. The glass door should be made of organic or tempered glass, and the glass door of the shower room should be made of plexiglass or tempered glass.

  4. Anonymous users2024-02-09

    Glass partition is a more common practice at present, and its advantage is that it can effectively isolate the water vapor in the shower room with good sealing, and it can also prevent heating leakage when taking a bath in cold weather. Moreover, the transparency of the glass itself makes it visually not cramped. If the bathroom area at home is okay, you can also build half a wall in the bathroom to make a partition.

    To do this, we need to open a niche in the wall, which is also more convenient for our daily toiletries, and you can also put clothes in it, hang dry towels and other things.

    Solid walls are generally suitable for large bathrooms to form independent partitions that are easier to take hygiene, because the glass partition is relatively more complex than the wall. If the bathroom at home does not separate dry and wet, then after each bath, the entire floor and the toilet are splashed, which is more cumbersome to take care of. The partition of the bathroom, in fact, is also a problem that is more commonly faced by renting in the society and today, because in the past, our houses were relatively large, and the area in the bathroom was also relatively large, and we would also separate the shower place from the toilet place.

    Glass full partition, which means that it is completely separated from the bathroom, belongs to an independent space, but the premise is that this requires a relatively large bathroom, the general partition material is glass, and the building materials market has corresponding materials, including the pre-service of door-to-door measuring tape. Using a shower curtain as a partition is the most convenient and cheapest way to use it for bathrooms of all shapes. Many bathrooms with dry and wet separation will have partitions to assist in the design, even if some bathrooms do not have dry and wet separation, you can also design a perfect space for dry and wet separation if you use partitions skillfully.

    Sanitary partition walls are used in every house, which saves space and is beautiful and generous. There are enough styles to match any effect you want, but it is still difficult to achieve the ultimate effect, and the shape of the glass partition is indeed irreplaceable.

  5. Anonymous users2024-02-08

    Waterproof partition in the bathroomIt is used in many places, and now more and more families are using it when they are decorating. How can the toilet partition be practical and easy to take care of, now share the relevant materials and steps about the bathroom waterproof partition!

    1. Sanitary partition materials:

    1. Sanitary partition material 1: moisture-proof board.

    The moisture-proof board is to add a certain proportion of moisture-proof particles in the production process of the substrate, which is made by high temperature and high pressure, which is suitable for humid environments, and the degree of expansion of the section of the moisture-proof board when exposed to water is greatly reduced. It is made of wood fiber and special moisture-proof agent, and is molded at one time by high temperature and high pressure. All mechanical properties, physical properties, and surface bending characteristics meet the requirements of the German industrial standard DIN with excellent quality, which is the best choice for bathroom partition materials.

    2. Sanitary partition material 2: PVC board.

    PVC board is a board made of PVC as raw material with a honeycomb mesh structure with a cross-section. It is a kind of vacuum blister film, which is used for the surface packaging of various panels, so it is also known as decorative film and adhesive film, which is used in many industries such as building materials, packaging, and medicine.

    3. Sanitary partition material 3: tempered glass.

    Tempered glass belongs to safety glass. In order to improve the strength of glass, tempered glass usually uses chemical or physical methods to form compressive stress on the surface of the glass, and the surface stress is first offset when the glass bears external force, so as to improve the bearing capacity and enhance the wind pressure resistance, cold and heat resistance, impact and so on.

    4. The fourth material of sanitary partition: metal material.

    For example, the sanitary partition of metal materials, in addition to being waterproof, the sanitary partition of this kind of material has other advantages. Like what. Light weight, energy saving, easy to install, maintain and strong performance;

    High strength, good stiffness, not easy to deform, large load; Even if it is impacted by external forces, it retains its shape and is not easy to change. It also has the advantages of good sound insulation, heat insulation, moisture-proof, fireproof effect, non-toxic and environmental protection.

    5. The fifth material of sanitary partition: man-made plate partition.

    There is no need to close the edge of the integrated molding, it can be chamfered, beautiful and generous, no edge bending is seam treatment, and the appearance is the same as the whole with the hardware accessories with novel shape.

    6. The seventh material of sanitary partition: composite board partition.

    Light weight, buried and easy to be damp degumming or corrosion, aluminum or stainless steel edge strip treatment, easy to deform and oxidize, easy to invade and expand and corrode by water vapor, doors, door posts, partitions need to leave seams or metal edges, the overall effect is poor. The advantages are lower cost, poor durability, and fast maintenance and obsolescence.

    7. The eighth material of sanitary partition: plastic partition.

    Plastic material, waterproof, but not resistant to high temperature, not scratch-resistant, easy to deform and pollute, plastic or aluminum edging, no overall feeling, poor texture, easy to deform, few color choices.

    Second, the steps of waterproof partition in the bathroom:

    1.substrate treatment;

    2.paint blending;

    3.Apply thinly multiple times;

    4.After the surface is dry, the lower closed water test is done;

    The above is the information provided about waterproof partitions, I hope it can help you.

  6. Anonymous users2024-02-07

    This kind of shower room is fashionable, but its size is generally fixed, and it is not suitable for non-standard products, and it needs to be equipped with a suitable chassis, soft lines, unique model, and good looks, but it is also more expensive, and the arc shape is a polygonal bathroom partition for families with the elderly. Generally speaking, when making sanitary partitions, it is most reasonable to use a rectangular method, and if there is not enough space, then a curved structure or a polygonal structure may be used. The dryness of the bathroom is guaranteed, but the family gets up early to go to the toilet and washes to avoid the trouble of queuing.

    At this time, you can consider the separation of three types and isolate the toilet separately, which can make the use of each functional area more convenient.

    However, the difficulty of realizing the "four-style separation" is relatively large, and it is also the most ideal solution, but in reality, if the "three-style separation" can be realized, it is also a relatively good plan to talk about the ants, that is, the handwashing station area, the toilet area, and the bathing area The advantage of the three opaque is that the privacy is strong, and the installation of opaque partitions in the bathroom can improve the utilization rate of the toilet - for example, an opaque partition is installed between the toilet and the sink, and these two functions can be used at the same time.

    Wall partition is a traditional partition method, but wall partition should pay attention to decoration and avoid tacky. The wall partition is generally suitable for a larger bathroom, which is equivalent to dividing the entire bathroom into two and formally dividing it into two rooms. From the perspective of beautifying the indoor environment, the use of glass partitions in the bathroom can bring a transparent visual sense to the whole space, and the bathroom will look more refreshing and concise.

    The solid wall partition made of brick will be more flexible in shape.

    Shower room partition. Install a shower room directly in the bathroom, you can achieve dry and wet separation, which is very convenient. Similarly, it also has certain requirements for space, and a bathroom that is too small may not be achievable.

    Japan's four-style separation is indeed very convenient and practical, but it also does not match the domestic living habits or space! The biggest reason is that our bathrooms may not have that much area.

Related questions
11 answers2024-07-14

withTempered glassBetter, this material is more waterproof. >>>More

19 answers2024-07-14

1. Glass partition.

Glass partition is a small sanitary partition method that is more popular today, there are different types of semi-open glass partitions, frosted glass partitions, curved glass partitions and other different types on the market, glass partitions have the advantages of waterproof and mildew-proof, it looks simple and generous, and it is easy to clean, and the installation of glass partitions in small bathrooms looks more spacious, but when we choose glass partitions, it is best to choose tempered glass, which will have a higher safety factor. >>>More

10 answers2024-07-14

I think it's a bit important to renovate the bathroom, first of all, waterproofing. Waterproof is very important, in fact, when many bathrooms are found in reality, in fact, waterproofing must be done, if you don't do waterproofing, you have to go downstairs, downstairs to find you, you have to re-knock what to do again, it takes more time and energy, so waterproof is must be done, because the bathroom is different from other places, the bathroom has a shower room, the location of the shower room, waterproof must be done, if you leak downstairs, you hate that thing very much. Therefore, if the bathroom is renovated, this waterproofing must be done. >>>More

15 answers2024-07-14

The bathroom is dry and wet separation, which is a problem encountered in most decorations. The advantage of wet and dry separation is that it is both hygienic and tidy and has a private space, making full use of the space in the bathroom. I think the partition is made of glass. >>>More

11 answers2024-07-14

When we decorate the house, we have attached great importance to the decoration of the bathroom, because our bathroom is not only used more daily, but also is a particularly dirty place, not only that, we often have to take a bath and wash in the bathroom. Therefore, how to decorate the bathroom is a more important place in the whole house, if we want to make a shower partition in the bathroom, how do we need to do it, then what kind of ** does it generally cost? <> >>>More