How to prune the crab claw orchid after flowering to make it bloom again

Crab claw orchid blooms a second time, prune it immediately after flowering, and do not let it bloom a third time.

How to prune the crab claw orchid to make it bloom again:

If there are more than 2 flower buds at the top of the crab claw orchid leaves, pinch off the residual flowers in time after the first flower is gone, so as to save nutrients and let the later flower buds bloom. Good nutrition, the leaves are thick and can leave 2-3 flower buds, if the leaves are a little wilted and thin, leave 1-2, otherwise the nutrition is insufficient, it is difficult to flower.

If the top flowers are finished, pinch the flowers along with the first leaf when the flowers are starting to wilt, and if the lower leaves are also thinner and wilted, you can pinch a few more leaves, leaving the thick and hard leaves in the first position.

After 3-5 days of pinching the leaves, after the wound is dry and healed, you can start to spray potassium dihydrogen phosphate, spray on the front and back sides of the leaves on the top of the mold shot, once in 7-10 days, keep 2-4 hours of light every day, about 1 month, it may reflower.

Crab claw orchid flowering period:

The crab claw orchid blooms in October of each mu year and continues until February of the following year. However, it should be noted that crab claw orchid is a plant that likes sunlight very much, and if it is cultivated indoors, you can use the way to control the light at this time, so as to adjust its flowering period. In addition, crab claw orchids do not bloom all the time, they belong to one stubble after another.

1. How to prune the crab claw orchid when it fails.

2. How to prune the crab claw orchid.

3. How to prune the crab claw orchid after the flowering period.

4. How to prune crab claw orchid? Just remember 1 step, and the flowers will bloom more and more every year.

1.Crab claw orchid will inevitably grow some overly dense stems and leaves in the growth stage, which should be thinned off in time to promote better ventilation and light transmission inside, so as to grow vigorously.

2.At the budding stage, it is necessary to thin the flower buds in time and prune off the overly dense flower buds, otherwise a lot of nutrients will be consumed, which will affect flowering.

3.After the flower fails, the residual flowers should be cut off, and the stem nodes after flowering should be pruned, and 2 to 3 subsections should be cut to promote faster recovery.

4.If it is a crab claw orchid that has been maintained for many years, it should be re-cut again.

<>1. Micro-cutting: The flowering period of a single crab claw orchid is about ten days, and some may fail in three or four days because of factors such as too strong light or high temperature and poor ventilation during the flowering period. Therefore, the flowering period of crab claw orchid mainly depends on the number of flower buds, and the flower buds can continue to bloom, and the flower buds will soon stop blooming.

When each crab claw orchid blooms and fails, we must remove the residual flowers in time to save nutrients and let the buds that are not in full bloom thrive. When picking residual flowers, don't wait until they are completely dry before picking, they can be picked when they are wilted. In addition, do not pick from the place where the flower stalk and the leaf are connected, to prevent the wound from being infected by bacteria, you can leave a small flower stalk to let it dry and fall off on its own.

If the residual flowers are picked in time, the stems that have bloomed will also grow new buds, so that the flowers will continue to prolong the flowering period. So, if your crab claw orchid is in full bloom, remember to check it often and remove the residual flowers in time.

2. Heavy pruning: If the crab claw orchid has passed the flowering period and no new flower buds have grown, it can be re-pruned once to facilitate later growth. There are two main parts of heavy eggplant scissors, one is the comb and cut where the stem is too dense, and the other is the shrink cut where the stem is too long.

Combing and cutting is easier to understand, and the clump trace is that the stem is too dense and cut appropriately. Generally speaking, on a main stem, leave at most two sub-stems, and too many must be removed, otherwise the growth will deteriorate. The so-called shrinking pruning is to cut the flowering stem from the right position, and the length of the general cut is between half and one-third.

After infiltrating and merging crab claw orchids, pruning should be carried out flexibly, combing and cutting a little more if the stems are too dense, and shrunken a little more if the stems are too long. In short, you should decide the pruning intensity according to the plant type of your crab claw orchid, and you can't completely refer to other people's pruning methods. If your crab claw orchid has completely withered now, you can promote flowering after re-cutting and waiting for the wound to grow, potassium dihydrogen phosphate every ten days, more sun and less watering, and a wave of flowers can bloom in spring.

Hello, maintenance is best placed on a sunny and soft windowsill maintenance. Crab claw orchid is a short-day plant, which likes scattered light and avoids scorching sun; Likes moisture, but is afraid of waterlogging. Avoid scorching sun and rain in summer, and warm and sunny in winter.

The suitable temperature of crab claw orchid during the growth period is 18 23, and the flowering temperature is 10 15, not more than 25, so as to maintain 15 is the best, and the winter temperature is not less than 10. Crab claw orchid is a short-day plant, so it can only produce buds and bloom under short-day conditions. (Short-day plants are plants that need to bloom in autumn and winter.)

After flowering every year, crab claw orchid can be properly pruned and compound fertilizer and phosphate fertilizer can be applied once every half month, which is very beneficial for flowering in the next year. In addition, you can put some base fertilizer such as bone meal or phosphate fertilizer when changing the flowering soil, which will also promote more new shoots and more flowering.

1. If it is vigorous, it is not flowering caused by hypertrophy, and the use of nitrogen fertilizer and compound fertilizer should be reduced in time. Because the hypertrophy will be due to the long growth of the crab claw orchid, it cannot form flower buds at the tip of the leaves.

2. Illumination. Crab claw orchid is a short-day plant, if the light is more than 10 hours a day, the plant can not form flower buds, if the light is sufficient during the day, and placed in a bright place at night, so that the long-term light is not easy to form flower buds. Therefore, if you want to make the crab claw orchid quickly destroy and bloom quickly, you must shorten the light for it.

3. Temperature. The most suitable temperature for the growth of crab claw orchid is 15-25, more than 30, the plant will enter a dormant state, below 5, the plant will suffer frost damage. These are all reasons why crab claw orchids do not bloom.

1. Pruning after the flowering period of the crab claw orchid can prolong the flowering period and help the crab claw orchid grow strongly.

2. Use scissors to cut off the withered residual flowers on the stem segments, and cut off the wilted and yellowed stem segments together, and cut off the 2-3 stem segments under the residual flowers.

3. In the bud stage of crab claw orchid, many flower buds will grow on some stem segments.

4. Remove a few in an appropriate amount, otherwise it will affect the nutrients**, and generally cut off the weak flower buds.

5. In the process of growing crab claw orchid, it is necessary to prune in time, pay more attention to observe the plant during maintenance, and appropriately cut off 1-2 excess stem segments.