Where is the Fox hatchback air conditioning filter replaced

Install the air conditioner filter element as follows:

1.Wait for the car's engine to cool down (so as not to get burned), open the passenger door, and change the air conditioning filter to sort out a position.

2.Under the co-pilot, the shell of the crisper box was removed, and there were two yellow buttons that could be unplugged with a single hand press.

3.After taking out the shell, there is a vertical outer cover on the inside, and it can be easily removed by holding the switches on both sides by hand, but pay attention to the installation order, and install it back as it is.

4.Take out the shell.

5.At this time, you can see the old air conditioner filter, press the outlet wire, you can twist the air conditioner filter while pulling out, don't worry about not being able to take it out, the filter is very flexible.

6.After taking out the old air conditioner filter, you can start the car, turn on the air conditioner and blow the air outlet. Then you can put the new cabin filter back in as is.

7.Before installing, squeeze the air conditioner filter in the middle, and after installing it, pull it a few times to return the air conditioner filter to its original shape. Then the two enclosures are installed and the whole job is done.

Hello Classic Focus on the right side of the accelerator pedal is four Phillips screws that can be replaced, and the new Focus is removed in the co-pilot to remove the fuse box trim on the left side of the fuse box, which is a clip that can be removed by hand.

The Fox air conditioning filter is located behind the co-pilot glove box of the vehicle, after removing the glove box, there is a cover plate on the rear bellows, and the filter can be replaced after opening, the specific operation steps are as follows:

1. Remove the upper screws of the glove box.

2. Remove the lower screws of the glove box.

3. Pull outward and take out the glove box.

4. Open the bellows cover.

5. Pull out the internal filter element.

6. Replace the new filter cartridge and glove box in reverse order.

Precautions for operation:

1. The filter element has a direction, do not install it in reverse.

2. Tighten the screws and fix the glove box to avoid the glove box falling when driving.

Old. Driver's accelerator pedal. Neighborhood. ** Remove the co-pilot safety box.

Focus' air conditioner filters are an eternal pain in the hearts of all mechanics.

Fox's air conditioner filter designer is really talented, super talented.

The cabin air filter is basically in three places, open the hood, and see if the black strip under the wiper has a place to detach.

If you don't open the co-pilot armrest box or under the armrest box Just these three places It is recommended to go to the repair shop It is very difficult to change If you don't understand, you will break the handrail box If it is under the handbox, the posture is very uncomfortable Leave it to the professionals! ~

It's really not in the place on the first floor that my friend said. The Focus's climate filter is under the driver's feet, to the right of the accelerator pedal.

It is a black rectangular lid that is placed vertically. There are 4 Phillips screws on it.

If you disassemble it, it is better to have a ball handle cross and a long cross. Otherwise, the accelerator pedal will get in the way.

If it's a Focus, then you need to remove the accelerator pedal and replace it.

You'll have to lie on the main driver's mat to change.

I'm sad that I've been forced to change one word today, and that's pain.

Next to the cab accelerator pedal.

1.There is a black plastic plate on the upper part of the co-pilot's foot, and there are two telescopic cards on the board to break it to get the board off.

2.Then remove the negative pole of the battery, then remove the body computer, and remove the fixed body computer rack (two 12 screw caps).

3.Then remove the board on the left side of the co-pilot's left foot, there are four screws, and then take it down.

To remove the accelerator pedal before getting it out, on the side.

Professional maintenance next to the accelerator pedal in the main cab of the blower is estimated to be difficult to disassemble.

Next to the accelerator pedal in the cab, there is a long black lid that you can see when you open it.

You can find the cabin air filter according to the steps below.

1. Wait for the car engine to cool down (so as not to get burned), open the co-pilot door and move the co-pilot seat to the end. Sort out the location of the air conditioner filter change.

2. Remove the shell of the fresh-keeping box under the driver of the vice-suspect, and there are two yellow buttons, which can be pulled off as long as you press it with your hand.

3. After taking out the shell, there is a vertical outer cover on the inside, and you can easily take it off by holding the switches on both sides by hand, but you should pay attention to the installation order, and install it back as it is.

4. Put the outer cover out well, and pay attention to the installation direction when installing.

5. At this time, you can see the air conditioner filter, press the outlet wire, you can twist the air conditioner filter while pulling out, don't worry about not being able to take it out, the filter is very flexible.

How to replace the Fox cabin filter.

When the car's engine cools down, open the front passenger door and remove the fuse box casing underneath the front passenger. There are two yellow buttons that can be removed by pressing your hand. When the case is removed, there is a vertical cover inside, which can be easily removed by holding down the switches on both sides by hand, and the old empty filter cartridge can be seen.

Press the outlet wire, twist the air filter, pull it out, and place the new air filter back in its original position. Functions:1.

The empty adjustable frame is attached to the casing to ensure that unfiltered hollow bend air does not enter the compartment. 2.It can separate empty solid impurities such as dust, pollen, and abrasive particles in the air.

3.It can adsorb empty moisture, soot, ozone, odor, carbon oxides, SO2, CO2, etc. in gas; Hygroscopic and long-lasting.

4.It can prevent the car glass from being covered with water vapor, so that the driver and passengers can see clearly and drive safely; It can provide fresh air for the cab to prevent drivers and passengers from inhaling harmful gases and ensure driving safety; It can effectively sterilize and deodorize. 5.

It can ensure that the air in the cab is clean, does not breed and bores bacteria, and creates a healthy environment; It can effectively separate solid impurities such as empty dust, core powder, and abrasive particles in the gas; It can effectively intercept pollen and ensure that drivers and passengers will not have allergic reactions and affect driving safety. Note: Air filters can easily accumulate a lot of dust.

Use compressed air to blow off the floating dust. Never wash with water, otherwise it can be easily discarded. The activated carbon filtration function in the air conditioning filter will be reduced after a period of use, please go to the 4S shop to replace the air conditioning filter.

The Fox air conditioning filter is located behind the co-pilot glove box of the vehicle, after removing the glove box, there is a cover plate on the bellows on the rear beam surface, and the filter can be replaced after opening, the specific operation steps are as follows:

1. Remove the upper screws of the glove box.

2. Remove the glove box or bend the lower screws.

3. Pull outward and take out the glove box.

4. Open the bellows cover.

5. Pull out the internal filter element.

6. Replace the new filter cartridge and glove box in reverse order.

Precautions for operation:

1. The filter element has a direction, do not install it in reverse.

2. Tighten the screws and fix the glove box to avoid the glove box falling when driving.