The method of tethering the fishing hook line, the correct way to tie the fishing line

Fishing hook is one of the indispensable fishing tackle when fishing, mainly the fishing tackle that hangs the bait to attract the fish, but there are many novice anglers who do not know how to tie the hook, and there is often a phenomenon that the tie is not strong, and there is a tangent, loose hook, running fish, etc. In this regard, this article summarizes some fishing hook tying methods, let's take a look.

Fishhook bolt method one.

This method is commonly known as the Ni's hook method, in which the fishing line is wound around the hook handle about two times and then tightened.

Fishhook bolt method two.

After the line is wound around the hook handle four or five times, one end of the previously reserved line can be tightened through the coil.

Fishhook bolt method three.

Wrap the line from the middle of the hook to the handle, then tighten it to reserve a coil, and then thread one end of the line into the coil and pull it tight.

Fishhook bolt method four.

Wrap the line from the bottom of the handle, then wrap it around a certain number of turns and leave a part of the line to tighten it. It's easier to catch fish in the opposite direction of the hook tip, so try to keep the hook tip outward after tying the hook.

Fishhook bolt method five.

Wrap the line around the hook handle, then set aside a portion of the coil and tighten it.

Fishhook bolt method six.

Tie a hook to a line of the right length, wrap it around the handle five or six times, block it with your fingers when the line slides outward, and then slowly pull the end of the line when it is tightened. The other hook also uses the same tying method, after fixing the hook distance, the double hook is removed and the double strand is knotted, and finally the small circle is tightened.

The above is a summary of the method of tying the hook in this article, there are many anglers who like to use the hook tying device, thinking that it is more convenient, in fact, the best way is to tie it by hand, although it is a little difficult, as long as you practice it carefully.

Twelve hook methods.

Twelve ways to tie a fishhook.

The best way to tie the hook.

13 ways to tie the hook** Daquan.

Trumpet hook tie method.

How to tie a fish hook and how to tie a strand line.

The hooked brain wire (also called strand wire) can be nylon thread or nylon thread. There are several ways to tie the hook, the most commonly used is the inner double.

There are two kinds of strand knotting method and inner single-strand knotting method, especially the latter (also called single-strand knotting method). Regardless of the method of leashing, the main ones are two. First, it is tightly tied, and the knots do not fall apart, and the tighter they are; The second is that the "knot" can not be reversed, it should be tied on the inside of the hook handle, not on the outside, and it is easy to run fish on the outside.

The hook method is shown in Figure 1 and Figure 2, and the connection method of the fishing line is the basic skill that every angler must master, and the joint is required to be firm and can not be loosened and opened.

Inner double-strand knotting method (Fig. 1).

Inner single-strand tie method (Fig. 2).

Among the several attachment methods of fishing line, the most used is the one shown in Figure 3. (see Figure 3<>).

The method of tying the fishing line is to buckle the knot and the horseshoe buckle.

1. Livebuckle knot

Step 1: Tie the end of the fishing line into a dead knot to form a fishing coil, and the knotted fishing coil cannot be moved to become larger or smaller.

Step 2: Insert your thumb and forefinger into the fishing coil.

Step 3: Press a section of line with your thumb and index finger, then kick back and pull out the line to form a slipknot.

Step 4: Insert the tip of the rod into the slipknot so that the slipknot is attached to the tip of the rod.

Step 5: Tighten the fishing line, the live buckle is tightly fastened on the snake knot at the tip of the rod, so that the fishing line is connected to the tip of the rod, and only need to loosen the live buckle and take off and wrap it around the foam board when the fishing line is finished.

2. Horseshoe buckle

Step 1: Parallel the two lines, wrap them into such a circle, and after the circle is completed, then wrap the circle into this circle, and make a figure-eight, such a figure-eight shape.

Step 2: Insert this thread into this figure-of-eight, it will form a positive and negative figure-of-eight, and then slowly and evenly tighten, the knot of your main line will be tied, and the horseshoe buckle will be tied.

Precautions. Before tying the knot, it is first necessary to put some moisture on it to avoid a certain degree of wear and tear on the strands. When attaching a hook or lure to the line, be careful not to get your fingers pricked by the tip of the hook.

It is also necessary to complete all the trap tips to prevent them from getting tangled in the rig.

The binding method is as follows:Preparation tools Ingredients: fishing line, hook, figure-eight ring.

The first is the first circle and then the knot method.

This method is the first method that many anglers learn to tie the hook, and it is very simple to operate, and it takes a total of three steps to complete the tieing.

1. Along the hook handle, wrap the fishing line on the hook handle, the small hook is wound 4 times, the big hook is wound 6 times, and the linear forest head at the bottom of the hook is about 4 cm.

2. Close to the fishing line at the hook handle, hit a coil pressed in half, put it into it from the hook tip, so operate, through the two coils, be sure to press the end of the hook bottom.

3. Pull the thread at the bottom of the hook with pliers, pull the fishing line at the hook handle by hand, pull it tightly, cut off the excess thread at the bottom of the hook, and the other hook is also operated in the same way, and the two hooks are tied to completion.

The second is the two-finger winding method.

This method is known as the fastest way to tie the hook, there have been merchants in Tianjin fishing tackle exhibition, with this method, a total of 36 pay threads tied in 1 minute, it is simply amazing, and its operation steps are not complicated.

1. Tie a coil, press the hook handle with two fishing lines in parallel, leave 3 4 cm of fishing line towards the bottom of the hook, and pinch the two sections of fishing line and the hook handle with your hands.

2. Stretch out the index finger and middle finger with the other hand, stretch the coil open, bypass the hook from the hook tip from the bottom of the hook and the hook handle, press down with two fingers and continue to wrap around the hook handle, after winding 4 or 6 times, continue to pinch the fishing line and hook handle with your fingers.

3. Pull the thread at the bottom of the hook with pliers, pull it down hard, and then pull the fishing line at the hook handle and pull it up gently, make sure that the fishing line is tied tightly together, cut off the excess thread at the bottom of the hook, and tie a fishing hook according to the above method, and the double hook is tied.

To use a string hook, generally use 3 or 5 fishing hooks to tie to the main line, mostly used for sea rod throwing.

Because each hook is separated by a certain distance, it is in different levels of the water body after falling into the water, and it can catch pure fish in different water layers, which improves the hooking rate.

After the hook enters the water, each hook is required to stretch the pants and match, do not wrap the fingers with the main line, therefore, the brain line should be slightly harder, that is, use a nylon wire with a thicker diameter. The brain line of the hook should not be too long, generally 5 8 cm is appropriate, the diameter of the wire is millimeters, and the distance between the hook and the hook should be greater than the length of the two wires, so as not to be entangled.

As the saying goes, it's better to ask for others than to ask for yourself, and you don't have to trouble others if you learn it Summarize some very practical ways to tie fishing lines and hooks, which are simple and easy to learn, and you can understand them at a glance. Amateur fishing is enough to learn one for a lifetime.

Tying method 1: <>

Binding method 2: <>

Tying method 3: <>

Tying method four: <>

Tying method five: <>

Binding method six: <>

Binding method 7: <>

Tying method eight: <>

Binding method nine: <>

Binding method 10: <>

Binding Law 11: <>

Binding Law 12: <>

The above twelve kinds are very easy to learn when you look closely, and each of them is very strong, not slippery, and many fishing friends around me are using it.

Fourth, six ways to tie, these two ways of tying are very simple

In fact, the hook and line play the role of "connecting the upper and lower levels" in the whole fishing group, one end is connected to the fish, and the other end is connected to the fishing rod, especially the fishing line, it can be said that the fish can be safely landed, it plays a decisive role. However, there are many kinds of Mori grip fishing lines on the market, which can even be described as dazzling, which makes many leather anglers have a headache.

1. First fold the fishing line in half and leave a circle, as shown in the figure below.

2. Then take a fish hook and press the line on the hook inside, as shown in the figure below.

3. Next, wrap around the hook, that is, the short line left around, generally a few circles, as shown in the figure below.

4. Next, after winding, pass the short line through the circle left before, and then press and hold the thread through it, and tighten the long line, as shown in the figure below.

5. Finally, cut off the extra part of the short line with scissors to complete, as shown in the figure below.

Answer: The fishing hook binding method is as follows:

1. Double rope single knot method: first overlap the fishing line into a double line and wrap it into a circle, then thread it into the fishing hook, and finally wear it back into the fishing line and tighten it.

2. Single-line single-knot method: the single fishing line is wound into the fishing hook, and the fishing line can be tightened.

3. Roundabout three-cut method: after the double line of the cover is inserted into the hook, it is made to tie the bow tie and rotate, and the line is tightened after circling on the hook three times.

4. Single line and two knot method: thread the fishing line into the fishing hook and wrap the circle, and wrap the line three times above the fishing line to tighten it.

5. Single-line four-cut method: the fishing line is threaded into the fishing hook to form a circle, and the tail end is wound back into the first circle by winding the line four times.

6. Single line one four method: the fishing line is threaded into the hook, once wound upward, four times down and tightened.

7. Auxiliary winding method: the use of a medium object that is not easy to slip out of the envy of the object for stability, the fishing line, the intermediate object and the hook three reverse four circles.

8. Direct four-winding method: the fishing line cover is rolled and tied to the hook four times and then tightened around the intersection.

9. Double-line butterfly winding method: It is mainly used for processing after the fishing line is broken, and the new line and the old line are knotted in two circles.