What to do if the computer host is flooded What to do if the desktop computer is flooded

If the computer host is flooded, as long as it is not powered on, it will not break!

If you get into the water, you have to find a way to get the water out right away, right?

1. First of all, unplug all power cords immediately;

2. Secondly, find some alcohol - wipe the motherboard again;

3. Finally, use a hair dryer to dry or dry automatically, if you are not in a hurry, it is recommended to dry it naturally!

4. In addition, if the monitor is also in the water, take it to the sun to dry. (Be careful not to show the front of the display).

5. In addition, the power-on test, in case it can't be turned on - go to a professional for maintenance, and through the above rescue, there is no major problem!

Step 1: Shut down.

If your computer gets water while it's turned on, the first step is to shut it down and cut off the power.

If water enters the power off state, then be sure not to try to turn it on. Many friends instinctively want to try whether they can turn on the computer after the computer gets into the water, at this time there is water in the hard disk, once the power is turned on, it may cause the circuit board to be burned out.

Step 2: Remove the hard drive from your computer and clean it.

Use a screwdriver.

Disassemble the computer case and remove the hard drive. If the data is important, then you need to be very careful with the hard drive.

First, use a soft and absorbent paper towel to wipe the water on the surface of the hard drive, and then use a hair dryer to dry the water stains on the surface and crevices of the hard drive.

function, otherwise the high temperature will cause damage to the circuit board and the data will not be recoverable.

Step 3: Clean the circuit board.

Note: It is best to let an experienced person operate or guide the operation of the circuit board to disassemble the circuit board.

Use a screwdriver to remove the circuit board of the hard disk, wipe the front and back of the circuit board, dry it in cold air and put it back on the hard disk.

Because soaking in water for a long time or impurities in the water will corrode the computer hard drive.

The parts need to be opened in a dust-free environment, and the water stains on the platter or the magnetic head should be replaced.

Friends should not open the hard disk in an environment that does not have the conditions for opening the disk, and do not hand the hard disk to someone who does not know the opening technology to open the disk (I once encountered a customer who opened the disk in an ordinary environment and wiped the disk with a paper towel caused the hard disk to be scrapped).

How to deal with water ingress in this computer:

1. Unplug the power and battery immediately, and the speed of power off directly determines the severity of the damage to the notebook.

2. Pour out the water immediately according to the direction of the water intake, and quickly dry the water with a dry towel or paper towel.

3. If the laptop keyboard gets into the water, remove the keyboard and observe whether the water has entered the motherboard. Carefully dry the front and back of the keyboard with a paper towel. It is best to dry it with a cold air with a hair dryer, and be careful not to use hot air, because the keyboard keys and so on are plastic, which is not resistant to high temperatures and avoids blowing damage.

4. Completely disassemble the motherboard, observe whether the motherboard has water stains, if there is a new clean with pure alcohol, be sure to use pure alcohol, not watery alcohol. Then dry the motherboard, or the hair dryer is not too high hot air drying, if you will not disassemble the motherboard, it is recommended to find a professional maintenance personnel to deal with it.

5. Before the processing is completed, it must not be powered on and turned on, and it is necessary to let many accessories dry thoroughly for as long as possible.

After the desktop host is flooded, it is basically the same, which may cause problems such as short circuit in the power supply and burning out the hardware.

Desktop Host Workaround:

If there is water, do not turn on the computer, the easiest way is to put it in a cool place, let it dry for a day or two, and make sure that the computer is 100% dry before turning it on.

What to do if the desktop computer host is flooded, as follows:

Tools Ingredients: desktop computer, hair dryer.

1. Turn off the power first, and wipe the water with a rag. Then in the direction of the water flow, let the water pour out, and make sure that the inner Xiangdong is dry.

2. Wait for a while, use a hair dryer, and dry the wet place with a weak air to reduce the occurrence of short circuit.

3. Observe the computer, connect directly with the graphics card, and see if you can turn on the computer. If not, look at the others.

Because the notebook has a battery, even if it is not powered on, it may lead to the probability of the circuit board burning out, put it in a ventilated and dry place and wait for it to dry, at least four or five days, if you have strong hands-on ability, you can also disassemble it and dry it with a hair dryer, pay attention to the cold air mode.

Pay attention to the place of use:

It should be noted that electrical appliances that have been flooded are easy to short-circuit and cause heating or disaster, and it is not dangerous to use high yards, even if the voltage is not particularly high for computers or laptops, it is basically irreversible. <>

Unplug the power supply. <>

After cutting off the power supply, if it is water that goes in, we can take out the shell of the computer and dry the water with a hair dryer.

If it's not water but other liquids, it's a problem, especially drinks, because drinks are acidic and will corrode the motherboard's wiring. At this time, we don't have to use a hair dryer to solve the problem.

To clean up the corrosion on the motherboard, we first need to prepare a toothbrush and alcohol, and use the toothbrush mixed with alcohol to clean the motherboard until the corrosion on the motherboard is removed, and try not to use too much force in this process.

After making sure that the laptop has been cleaned, we can put the machine on and test it. It is recommended to turn on the power supply first, and then hang the battery after no problem.

After the computer host is flooded, it usually causes varying degrees of damage to the hardware and software of the computer, and the following are the possible effects and solutions:

First of all, water ingress can damage the circuit boards and components of the computer host. Moisture can cause rust or corrosion of circuit boards and components, which can cause the main unit to fail to start or even burn. This usually requires the main unit to be sent to a professional repair center for cleaning and repair.

It is important to note that if a low-quality water source is used, such as sewage or a water source containing corrosive substances, the damage may be greater.

Secondly, water ingress can also cause damage to the host's hard drive or other storage devices. Moisture may affect the hard drive platter and read/write head, resulting in the inability to read the data wheel keys on the storage device. This situation requires a professional data recovery service to recover the data, or to replace the storage device.

In addition, water ingress can cause damage to the power supply and other electronics of the main unit. This situation often requires the replacement of the power supply and other damaged components, or the main unit being sent to a professional repair center for repair.

In short, water ingress into the computer host usually causes varying degrees of damage to the computer's hardware and software, which may cause the host computer to fail to boot or burn. The main unit needs to be sent to a professional repair center for cleaning and repair. In addition, storage devices, etc., can be damaged and require professional services to restore or replace.

Therefore, in the process of using the computer, you need to pay attention to protect the computer from moisture, dust or high temperature, etc., so as to prolong the life of the computer.

If the water is ingress, it must be sent to a professional place for maintenance, so that the effect can be more significant, and it is not too expensive.