How does the sea rod look at the drifting phase, and does the sea rod have to float

There are several drifting phases of silver carp casting. 1. Black drifting is the most common and easiest to catch fish. It doesn't matter if the timing is slower.

2. Drift is overturned, this I have also encountered, generally the bait just hit down soon after this situation, will fish. After a long time, you may go out again, and the bait may be gone. 3. Float on the water and move slowly...

The silver carp on the sea rod is hooked to the mouth of the fish first, and the fish runs and pulls the float to produce drifting. This is the opposite of silver carp fishing with a hand pole. Just say a little detail.

After the rod is struck, do not tighten the string very tightly. Tightened, the line will sink with bait and drift. It's best to use a rock rod line that floats on the water.

Since the thread is not very tight, the pole can be placed on the ground at will, and there is no need to add a bell. But not too close to the water's edge, to prevent the big fish from pulling the rod into the water, I touched it once, fortunately I reacted quickly...

The principle of the fish in the sea rod deep water float fishing for silver carp should be similar to the **hook, the hook group used for sea rod floating fishing for silver carp should be a water monster, and the hook on it is also dense, and it should also rely on bait to atomize the silver carp to drink the bait when accidentally drinking the hook, and then. It is estimated that there should be a black ticket at this time, this conclusion is purely personal conjecture, and if there is any similarity, it is purely coincidental. Because I haven't fished like this before.

Big things directly black drift, less than 2 catties, the drifter will shake on the water surface, forming an obvious water circle!

Hehe, use less sea rods. However, according to the reasoning, it is safer to fish for silver carp on the float with a black standard rod. If it is a water monster with a spherical standard, it should be more secure to lift the rod when the standard is moved by a large scale. :handshake

The legendary sofa Hehe, I use a sea rod, and I generally don't need a ticket to hang a bell to watch the master downstairs explain.

If it's bottom fishing, don't float; If you are hanging fishing, you must use a float. Generally, the float used for sea rods is much larger than that used for hand rods, and most of them are made of plastic. The float is like the "eye" of the angler, it can show the situation underwater, and only through it can you know whether the fish has bitten the hook or not.

There are two types of floats: spherical and spindle-shaped. These two types of floats have their own characteristics: the spherical float is large, eye-catching, and buoyant; However, because of its large size and large area in contact with water, it is easy for the bait to shift due to fluctuations in the waves.

In order to avoid the displacement of the bait, you can use the method of adding a macaroni sinker.

After falling into the water, the bait sinks to the bottom, and the bait is suspended in the water under the drive of the float, even if there are waves, because there is a lead sinker at the bottom of the water, the bait will not be displaced. The size of the sinker depends on the size of the wave, and when the wind and waves are large, a 150-200 gram sinker should be applied. If the wind and waves are small, a 100-gram weight plumb sinker will do.

When fishing, pay attention to the selection of floats, if you are fishing in the rivers and rivers, you should choose jujube kernel floats. Because the wind and waves of the river are relatively large, if you do not use the jujube core float, the stability is too poor.

If you choose from the material of the float, it is better to choose the reed material or feather material for winter fishing. The feather float has the advantages of light weight, high buoyancy and sensitive response. The stability of the reed material will be better than that of the feather material, and it is more suitable for complex wild fishing environments.

If you use a sea rod to float within 10 meters of fishing, the method can completely imitate the fishing method of hand rod drifting, which can be used to fish both bottom and float. If you are using a short sea rod within meters, the way to get out of the line must be to swing the rod and throw it, so the pendant should be slightly larger before it can be thrown.

The sinker of the sea rod must be enlarged enough to drive the hook, drift and line to be cast out together. Therefore, the weight of the pendant can be selected according to the length of the sea rod and the thickness of the fishing line, and then the appropriate large float is used. After throwing it into the distance.

The target of the big drift is obvious, which is easy to observe.

Using a sea rod to drift, there is a key problem that is the "matching" of the drift. When assembling, the sinker should be suspended in the water even if it is fished for the bottom, and the hook will fall right on the bottom of the water after adding bait. The fishing tackle assembled in this way will not drift with the current, and the main thing is that when the fish bites the hook, it reacts sensitively, as long as the fish touches the bait slightly; The float reacted immediately.

If the drift is small and heavy, or the float is too high, it will not achieve the expected effect due to the slow response. Therefore, it is required that the angler must be repeatedly adjusted in advance, and it must be constantly adjusted and corrected when using it.

The sea rod and floating fishing float are suitable for fishing for pelagic fish such as silver carp and grass carp. The combination of sea rod fishing float is relatively simple, as long as the drifter can make the hook and sink not sink to the bottom. However, the drifter should not be too large, such as too large float in addition to low sensitivity, in the throwing is also very laborious.

Some people use the foam block for packaging as floating, which is a convenient move to take local materials, but the resistance of the foam block is too great, it is very difficult to throw, and the reaction of the fish is also very slow when biting the hook.

There are many ways to load and float the sea rod, and here are two ways to load and float. The first is the sea rod plus drift close fishing: you can use the vertical drift used by the ordinary hand rod.

Add a 2 cm long valve core or hose to the main line of the sea rod, insert the vertical drifting connecting rod into the valve center, and connect it completely according to the hand rod. Because of the short distance, the sea rod has little force when throwing, and this small drift connected with a single leg will not fall off.

If you cast a long distance or use a large float to float, you will not be able to use the above method. It is best to choose a large drift with a hole in the drift head, tie out a soft wire in the hole of the drift head, find a 5 cm long, centimeter thick wire, bend a small circle in the middle of the wire, the soft line of the drift head is connected with this small circle, and this connecting line can be left 2 cm long.

The ends of the wire are still in a straight line (see attached picture).

Add two valve cores on the main line of the sea rod, and insert the two valve cores at both ends of the wire, so that it becomes a two-point connection of the legs, which can move up and down freely on the main line, and it is very convenient to adjust the depth.

It is best to use a longer rod to drift with a sea rod, if the sea rod is too short and fishing in deep water, the line dragged outside after adding the drift exceeds the length of the sea rod, and it is very inconvenient to cast. There are many anglers who use a rod that is more than a meter long, or a longer hand rod and drift fishing is very convenient.

No, it is completely by feel, sea fish are fiercer than freshwater fish, and generally rarely eat bait, usually swallowed violently, at this time you will feel the line tight, and you can lift the rod.

The sea rod is usually only used when fishing for silver carp, and the float is the size of an egg, and the water monster cage is filled with bait that is easy to atomize, and the bottom of the fishing is a bell. Fishing with a sea rod catches fish that bite the hook, unlike a hand rod that drifts and is difficult to hit the fish without lifting the rod.

The sea rod with fish drift should be a hand sea rod, first of all, the drift should choose the kind of drift with a metal ring, when fishing, the space beans below the drift sit in the drift about 400mm position, so that when throwing the rod, you can drop the hook to the position you want, and then float along the fishing line to the position of a space bean above to stop.

The sea rod with drift and the rock rod with drift are the same, the fishing group is basically the same as the ordinary hand rod fishing group, and the larger freshwater with the rough purpose can be used to drift. However, this method of drift fishing is generally used in late autumn after the water is cool, and is used to catch crucian carp that swim into deep water to avoid the cold. This kind of fishing method is more suitable for using a rock rod, one is that the rod is relatively long, easy to throw, and the other is light weight.

The sea rod is drifting, and it will only be used when there is no rock rod.

How to tie the bottom line of the box hook.

The sea rod uses floating, generally using an unfixed drift, this drift begins to hit out when it is underwater, after a slight shake of the line, the float slowly rises until it is exposed to the surface, and it will no longer rise after its own balance, at this time it can reflect the fish news.

The rod has ample storage lines, lead stones, and bait, which can easily be thrown into the water tens of meters away, and experienced anglers can be thrown up to 100 meters away. All kinds of large fish mostly inhabit the deep water area of the far shore, and rarely swim in the shallow water area near the shore.

Therefore, throwing far creates conditions for catching big fish.

There are several ways to look at the drifting rod.

1. Master the way of eating the hook of the fish (1) Crucian carp (bottom fish): bow down and the tail when feeding, suck the mouth and raise the head upstream, and the drifting reaction is slight agitation, obviously floating. When fishing for crucian carp, it is advisable to lift the rod while floating slowly.

2) Carp (bottom fish): love to arch mud to find food, eat cautiously, taste it before eating, feel the same, then ingest it into the mouth, then swim away, the drifting reaction is first shaken a few times, and then sink sharply. Fishing carp should be lifted when the top is not (black drifting), and the rod can be hit.

3) Herring (middle and lower pelagic fish): Feeding fiercely, swallowing when you see bait, inhaling it into your mouth, holding it and leaving, drifting against the emergency to promote a large amount of shaking and sinking obliquely. Fishing herring (grass carp) should be in the drift of the rapid downward rod to catch the fish.

4) Tilapia (middle and lower pelagic fish): gluttony, sucking to the mouth without loosening the mouth, drifting back to promote shaking up and down. When fishing tilapia, it is advisable to lift the rod when drifting up, tilting or slanting black drifting.

5) Silver carp (middle and lower pelagic fish): Feed on Sven when the water temperature is 17-20 degrees, and run away in midsummer. When fishing for silver carp, it is advisable to lift the rod when drifting shaking (water temperature 17-20 degrees) or black drifting.

6) bream (middle and lower fish): eating the hook action is like a crucian carp drifting reaction shaking up and down, quickly rising, fishing bream should be in the drift when shaking up and down or rising when lifting the rod. Second, master the seasons.

1) In early spring, the fish swims slowly, and when feeding, the mouth is small, the food is light, and the drifting and shaking are also slow, which is not obvious. Drifting shakes that lift the rod.

2) Summer and autumn fish are active, swim quickly, feed fiercely, drift and shake at a large speed, obliquely, sink or send up. Drift and move, sink or send up to lift the rod.

3) In winter, fish feed less and move slowly. Drift slightly to lift the rod.

Third, master the depth of the water.

1) Fishing in shallow waters within 1 meter, the distance between the drift and the hook and the drop is short (the water line is short), and the fish eats the hook and floats immediately to send it up or sink immediately, and the rod should be lifted earlier.

2) Fishing in deep water above 2 meters, the distance between the drift and the hook and the sink is longer (the water line is long), and the fish eats the hook and floats up or sinks slowly, and the rod should be lifted earlier.

Fourth, master the bait.

1) Vegetarian bait, small in quality, easy to inhale in the mouth, shake a few times, and pick up in time. (2) Meat bait, bite resistant, after drifting and shaking, you can lift the rod a little later.

Fifth, master the length of the brainline.

1) Long brain line, the time for the fish to swallow the hook to be reflected on the float should be longer, and the rod should be lifted earlier. (2) Short brain line, the time for the fish to swallow the hook to be reflected on the float should be shorter, and the rod should be lifted later.

Sixth, grasp the weight of the fall.

Generally, the horizontal hook is used for heavy falling, the vertical hook is used for light falling, still water is used for light falling, flowing water is used for heavy falling, shallow water is used for low falling, and deep water is used for high falling.

1) Heavy fall, the fish consumes more force on the fall, floats up and sends low, and the rod is relatively early.

2) Light fall, the fish consumes less force on the fall, floats up and sends high, and the rod is relatively late.

3) High fall, the force of the fish to eat the hook, first consumed part of the brain, reflected to the force on the drift is small, the degree of delivery is low, and the rod should be lifted early.

4) Low fall, the power of the fish to eat the hook, through the waterline quickly transmitted to the drift, the degree of delivery is higher, and the rod should be lifted later.

It's hard to say that generally crucian carp eat hooks and slowly flush upwards to lift the rod, sometimes it is rapid down, usually at night.