How to remove the green skin of the small peach pit of the bracelet

How to remove fresh walnut green (green) skin:

1. The natural shade drying of walnuts.

Choose walnuts that are healthy, disease-free, pest-free, and have intact skin, and put them in a ventilated place to dry naturally after getting off the tree. After a few days, the skin of the walnut appears wrinkled and shriveled, and the green skin will naturally separate from the walnut. However, it should be noted that the injured walnut will be blackened locally, so this method is not suitable because it will cause pubic skin.

2. Manually remove the green skin of walnuts.

Tools, rubber gloves, hammers, knives, iron brushes, etc. are required. Use a small hammer to tap the walnut green skin or use a knife to peel off the large green skin first, then use an iron brush dipped in water to continue to brush the remaining green skin, and finally use a fine needle and toothbrush to carefully clean it. It is best to wear rubber gloves throughout the process, otherwise the ** on your hands will be stained black.

3. Artificial ripening.

Spray the green skin evenly with 200 times the "ethephon" solution, and the green skin will automatically separate after a whole day.

4. Rotten method.

Cover the green walnuts with straw mats, straws and other things, and let the fermented green skin rot and peel off naturally.

5. Mechanical method.

Use a specialized walnut degreening machine.

6. Soak fresh walnuts in water, and then cover them for a few days to be easy to cut off. Or bury the walnuts in the soil and peel them. Put the walnuts in a cool place for 4-6 days, and when the green skin is a little wrinkled, wear rubber gloves and gently peel it, and the green skin of the walnuts will fall off by itself.

This one is very difficult, you have to break it, the walnut skin is very difficult to get off, and when you get rid of it, your hands will be black.

Steps of the cleaning method of the peach pit bracelet:

It is okay to use a brush dipped in a detergent or a cotton swab dipped in detergent, and then you can rinse it with water, and then wipe the water on the walnuts in time. Wipe dry, never blow dry or bake dry with a hair dryer. Put it in a ventilated place for another two or three days.

Do not wash it often. Just use a brush to remove the surface floats and sinks. If you don't dry it in time after washing, black mildew will appear on the walnuts.

When it comes to washing walnuts, some people never wash them, while others wash them diligently.

Method 2: Soak in warm water for 5-10 minutes, and then use a supermarket-bought stiff brush to brush off the attachments on the walnuts. The black mud on it, as well as some untreated pubic skin, can be brushed off.

Dip a toothbrush in body soap or shampoo, brush again, and rinse with water. Some old walnuts have no umbilicus under them, and water may enter the water after washing, so you can seal the umbilicus with candle oil and then brush it. After brushing, dry with a towel, and plate it in your hand until you can't see water in the recess.

Suggestion: The peach pit bracelet should not be cleaned directly with water, because washing the peach pit bracelet with water may have serious consequences of cracking. Cracking is a phenomenon that peach pit bracelets are prone to, and the principle of cracking lies in the fact that the humidity inside and outside the core is not uniform.

The air humidity inside the peach pit bracelet and the humidity outside the nucleus should be balanced, if the inside is high and the outside is low, the difference is huge, then the moisture inside the nucleus expands outward, and the surface of the nucleus is dry and shrinks inward, and it will crack. Nuclear carving handicrafts can not be directly dried, soaked in water and blown by the wind for a long time.

The method of cleaning peach pit bracelets is actually very simple, first dip the brush in water and gently rub the hand skewers. So that each walnut has moisture on it. Evenly scrub each walnut for about 10 minutes to soften the dirt on the walnut.

Use a pinnacle to remove the dirt on it, and if you have bad eyes, you can use a magnifying glass. Then scrub the walnuts with a water-soaked brush to remove dirt and dust from them. Then use a soft brush moistened with water to remove the dust inside the groove.

Use a paper towel to wipe the moisture on the walnut bracelet to ensure that there is no moisture, and place it in a ventilated place to dry.

Summary. Bracelet peach pits can be peeled using the following steps:1

First, prepare a sharp knife and a bowl of warm water. 2.Place the skewer peach pits in a bowl and soak them for a few minutes, which will make their skin soft and easier to remove.

3.Take out a soaked bracelet peach pit and use a knife to gently make a small cut in the outer skin. 4.

Next, gently peel the outer skin from the incision with the back of your fingers or knife, slowly following the arc of the nucleus. 5.If you come across some skin that is difficult to remove, you can carefully scrape it off with the tip of your fingernail or knife.

6.Repeat the above steps to remove the outer skin of all the peach pits from the bracelet. Be careful when handling the peach pits on the bracelet so as not to hurt your fingers.

Bracelet peach pits can be peeled using the following steps:1First, prepare a sharp knife and a bowl of warm water.

2.Place the skewer peach pits in a bowl and soak them for a few minutes, which will make their skin soft and easier to remove. 3.

Take out a soaked bracelet peach pit and use a knife to gently make a small cut in the outer skin. 4.Next, gently peel off the outer skin from the incision with your fingers or the back of a knife, slowly following the arc of the nucleus.

5.If you come across some skin that is difficult to remove, you can carefully scrape it off with the tip of your fingernail or knife. 6.

Repeat the above steps to remove the outer skin of all the peach pits from the bracelet. Be careful when handling the peach pits on the bracelet so as not to hurt your fingers. At the same time, choosing a larger bracelet of peach peachers will make it easier to peel.

Remove the skin of the peach pit with the following steps:1Prepare a sharp knife and warm water.

2.Soak the peach pits for a few minutes to soften the skin. 3.

Gently make small incisions in the outer skin. 4.Peel off the outer skin with your fingers or the back of a small front macro knife and proceed in the direction of the arc of the nucleus.

5.Hard-to-remove skin can be scraped off with a fingernail or the tip of a knife. 6.

Repeat the above step to remove the skin of all the peach pits from the bracelet. Take care to protect your fingers and choose larger peach pits. Good luck!

After piling up walnut fruits in a cool place, the surface is covered with a thick layer of hay or dry leaves, and the peel of the fruit will gradually crack, and when the peel is cracked by more than 50%, the peel can be knocked off. In addition, you can peel off the peel with a knife and crochet needle, or dry the fruit in the shade and rub the peel off.

1. Pile peeling method.

The peeling of walnuts can be done using the stacking peeling method, which specifically refers to collecting walnut fruits and piling them in a cool place, and laying a layer of 10 cm thick hay or dry leaves on the surface of the fruit to promote fruit ripening in turn, and the speed of fruit peeling will be accelerated, and when the peel of the green-skinned walnut cracks to more than 50%, the peel can be knocked off.

2. Manual peeling.

You can also use the method of manual peeling, which specifically refers to gently tapping the green peel walnuts with a small hammer, or peeling off most of the green peel with a knife, and then brushing off the remaining green peel with an iron brush, and finally carefully cleaning and cleaning the walnuts with a crochet needle and toothbrush.

3. Natural shade drying.

The peeling of green-skinned walnuts can also be done using the natural shade drying method. After selecting walnuts with intact skin and no pests, the walnuts are placed in a ventilated place to dry naturally, and after the walnut skin is wrinkled and shriveled, the skin of the walnut will be naturally separated from the walnut, and the peel can be rubbed off directly.

The best way to clean up is to clean it by hand, which is the most tedious and laborious, but the walnuts are the cleanest and the skin color is beautiful.

Steps: 1. Peel off the outer skin of the walnut with a knife, pay attention to the strength, angle and depth of the knife, and master the strength of the hand so as not to hurt the walnut with a knife;

2. Use a stiff brush to brush off the remaining green skin residues, if you use a steel brush, don't use too much force, otherwise it will leave scratches on the surface of the walnut, so try to use a plastic brush;

3. Use a needle to clean off the fine residues in the lines of various parts of the walnut.

To remove the green skin of the peach pit, you can choose to peel it manually, and use a knife and a steel brush to remove the green skin from the walnut. You can also take the natural shade drying method to peel the green skin, which is more labor-saving and convenient, but it is not suitable for walnuts with surface injuries. Diluting ethephon potion and spraying it on walnuts can also remove the green skin, but the potion may not be good for your health, so you need to pay attention to the amount used.

When peeling the green skin, you need to wear non-slip gloves on your hands, use a knife to peel off the large green skin, and you can choose to use an iron brush to brush off the small pieces of green skin that are difficult to clean, and be careful not to get the juice on your hands, which is difficult to clean.

After a large number of walnuts are ripe, the manual thin skin needs to spend a long time slippery time, you can take the natural shade drying method to fully dry the walnuts, and the skin can fall off naturally after the folds and drying, which is more labor-saving and burning, but the injured walnuts are not suitable for using this method, otherwise the walnuts will be blackened and the pubic skin will appear.

Spray the green skin of the walnut with a 200-fold diluted ethephon solution, and the green skin of the walnut can fall off in about a day. However, ethephon contains a small amount of toxicity, and it can be sold after consumption, which will pose a threat to human health, so it is necessary to reasonably control the amount used.