How should a jade tree be rooted?

Hydroponic rooting methods:

1. Choose high-quality branches.

To make hydroponic jade trees.

To quickly take root and survive, you must first remove a high-quality branch from the leafy jade tree and use it as a seedling before hydroponics.

2. Process the truncated branches.

It is recommended to cut every two or three sections as a section, and the cutting edge needs to be tilted so that the cut branches also have an inclined cross-section. As shown in the figure below, it is recommended to keep as few leaves as possible on each branch, and it is recommended that no more than 2 leaves be left, and the excess leaves should be removed decisively.

3. Place the shoots in a new container.

You can choose a new container, such as a plastic bottle.

Or you don't need a water cup, but you need to put the processed branches directly into the container for maintenance, and change the water every two or three days.

4. Regularly put rooting powder.

If you want the branches of the jade tree to take root quickly, you still have to prepare the rooting powder in advance, because only by adding a small amount of rooting powder can the plant take root quickly, and the rooting powder added must not be too much, otherwise it will affect the normal growth of the plant.

When hydroponics, choose a transparent container, which is convenient for observing the growth situation and can also better transmit light. Be careful not to add too much water and do not stick to the bottom. The water should be clean and clean, preferably mineral water.

Also change the water frequently to avoid the growth of bacteria. The water contains few nutrients, and if you want it to take root faster, it is recommended to add a nutrient solution dropwise.

It can replenish nutrients and grow roots quickly.

Cuttings of jade trees, add a little "it" to the soil, and take root and sprout in 15 days.

1. Hydroponic jade trees can be hydroponic, and hydroponic ones are more ornamental than soil-grown plants.

2. Hydroponic method 1, depotting: In the first 3 days of hydroponics, suspend watering to facilitate plant depotting. During hydroponics, shake the soil around the plant, then hold the plant with one hand and turn the pot upside down with the other hand to take the plant out.

Be careful not to hurt the roots of the plant.

2. Root pruning: Wash off all the soil at the roots of the plant with water, then check the roots and cut off the rotten, blackened, old and thin roots. If the root system is well developed, you can prune more, but make sure the taproot is intact.

3. Water intake: Prepare a hydroponic container, put the plants in it and then fill it with water. You don't need much water, just enough to allow the roots to fully immerse themselves in it.

After that, pebbles are placed inside or other methods are used to fix the plant. Finally, put it in a cool place for a few days of maintenance, and then transfer it to a sunny place to breed normally.

The leaves of the jade tree are thick and green, the branches are vigorous and simple, and the scenery is beautiful to make a bonsai, and the key to making the root system thicker is to do a good job of pruning. Usually give it some fermented organic fertilizer every month, such as sheep manure, chicken manure, etc., you can also use slow-release fertilizer, and you can shout that only if the nutrients are sufficient, the growth will be more powerful. , raise the jade tree to do these points, the new shoots and new branches grow quickly, and turn into old piles.

The leaves of the jade tree are thick and green, and the branches are vigorous and vigorous, making a bonsai landscape beautiful, and if you want the root system to be thicker, the key is to do a good job of pruning.

1. Prune

The first is spring pruning, at this time a large pruning is required, the top of the long branches and small buds of about 1cm should be cut off, and the dead branches, diseased branches, yellow leaves, etc. at the bottom should also be cut off, leaving enough nutrients to wait for the growth of new branches.

The second is to prune usually, it is best to prune once a month, because the growth rate of the jade tree is very fast, and new branches and new leaves will grow in half a month.

2. Change the pot

Of course, the two links of potting and fertilization can not be saved, change the pot once a year in spring or autumn, first cut off the capillary roots of the roots, and then prepare a larger pot, the pot soil should be loose and fertile and breathable, and after planting, put it in a cool place for two weeks, and then maintain it normally.

3. Fertilization

Usually give it some fermented organic fertilizer every month, such as sheep manure, chicken manure, etc., you can also use slow-release fertilizer, only if the nutrients are sufficient, the growth will be more powerful.

, raise the jade tree to do these points, the new shoots and new branches grow quickly, and turn into old piles.

Hydroculture techniques.

1. After depotting, wash the roots directly after water raising, do not prune the branches and water cuttings 2. The root system is underdeveloped, the aboveground part is wide, some are top-heavy, and the bottom of the vessel can be fixed with pebbles and colored stones.

3. Don't use nutrient solution in summer, just cultivate it with water, change it with water once every three to five days 4. It needs to be placed in a place with sufficient sunlight indoors, otherwise the leaves are easy to yellow and fall off.

The base of the stem of hydroponic succulent plants generally cannot be exposed to water, and they are generally hydroponics after the roots grow.

The landlord cut the rotten place until it could not be discolored, put it in a ventilated place to dry for a few days, and then plant it in the sand when the wound is dry. After planting in the soil, we can do hydroponics again.

It can be hydroponic, it is very easy, cut a branch and insert it into the water, the branches are preferably lignified, and the rooting is easy.

Now the season is not the time to cultivate, and the result is half the effort!

Even though it's summer, there are air conditioners now, so what are you afraid of, you can do it all year round.

After the jade tree is depotted, the roots are directly washed and watered. The root system is underdeveloped, the aboveground part is wide, some are top-heavy, and the bottom of the vessel can be fixed with pebbles and colored stones. Don't use nutrient solution in summer, just culture it with water, and change it once every three to five days (tap water needs to be dried for a day or two before use).

It should be placed in a well-lit place (scattered light is sufficient) in the room.

You can also try to cut off the stem of the jade tree and dry it for about a day, and put it directly in the water, maybe there will be a surprise. Generally, when I hydroponic plants, no matter what species (jasper, duck palm, skyflower, ivy, honeysuckle), the leaves of the bottom section are removed.

If you want the jade tree to take root quickly, you can do it in a variety of ways, such as applying some honey to the rooting area of the cuttings, putting the cuttings in the water soaked in wicker, using some materials as rooting water, or treating the cuttings with vinegar, all of which can promote the rapid rooting of the plant. If you want to root quickly in hydroponic jade trees, you need to put a small amount of rooting powder into the water regularly to promote rooting.

Rapid rooting method of jade tree.

If you want the jade tree to take root quickly, you can do it in a variety of ways, such as applying some honey to the rooting area of the cuttings, putting the cuttings in the water soaked in wicker, using some materials as rooting water, or treating the cuttings with vinegar, all of which can promote the rapid rooting of the plant.

The jade tree takes root and sprouts quickly.

If you want the jade tree to take root and sprout quickly, you need to choose a healthy leaf first, and keep the intact growth point, and then put the leaf ridge finger in a cool and ventilated place to dry for a day.

Hydroponic jade tree takes root.

In order to quickly take root in hydroponic jade trees, it is necessary to first choose a high-quality branch, cut off the branch every two or three sections, and tilt the knife edge when intercepting.

Put the treated branches into a transparent container for water culture protection, change the water every two or three days, and put a small amount of rooting powder regularly, so that the plants can take root quickly.

The jade tree takes root from cuttings.

1. Choose a sandy soil with more fertile soil and good soil permeability to cut jade trees, and keep the soil fully moist, which is conducive to the rooting of jade trees.

2. After preparing the cuttings substrate, choose the leaves of the jade tree that grow vigorously and have no disease, cut them, and dry the leaves in a cool place, and then you can take cuttings.

3. Leaf cuttings can be inserted into the substrate at an angle of 1 2 cm, and can also be placed directly on the moist substrate, placed in a cool place, and can be rooted after about 3 4 weeks.