Consult how to clean the moss on the pavement bricks of the community

Moss lives in damp and shady places, and if you don't want moss to grow, you have to change its living conditions.

The first way to remove moss is to use a moss remover.

Moss recides are classified as biocides in water treatment chemistry, which use oxidation or toxicity to kill moss and algae spores, but at the same time, they will also kill microorganisms in water bodies, and when the dosage is too large, it will also kill aquatic weeds. The latest type of moss remover is to modify the water environment, so that the water body produces factors that are not conducive to the growth of moss, so that the moss is in a state of physiological starvation and dies. It is not only harmless to the growth of aquatic plants, but can make aquatic plants grow more vigorously.

The moss agent effectively inhibits attached algae and planktonic algae. For example: brush algae, barbel algae, filamentous algae, brown algae, membranous algae, red algae and planktonic green algae.

Usage: 1Shake well before use.

2.Add 10 ml per 100 liters of water every 72 hours for 2 consecutive uses3Remove the activated carbon and add oxygen when using.

4.After treatment, change to 1 3 new water and add activated carbon.

The second way to remove moss is to use lime to solve the problem.

Sprinkle a layer of lime and burn the moss. But the moss is likely to "come back from the dead" and grow again.

In order to eliminate this problem, it is recommended to prepare some paint or paint. After the moss is killed with lime, it is cleaned up, and then we brush it with the prepared paint or paint, which solves the problem of moss regeneration, otherwise it will grow.

The third way to remove moss is to splash it with copper sulfate, which also works.

The fourth way to remove moss is to sprinkle the moss on the road with a high-salt solution when the temperature is high, dry and then sprinkle and then sprinkle again, repeat many times, the highly alkaline solution can also be used, and the concrete can prevent moss from growing after being absorbed by the concrete many times.

Mossy on the road can be slippery, accelerate road weathering, and give off an unpleasant fishy odor. The rapid moss remover of Anzhixing can be removed, but in order to control moss, it is necessary to use the mineralized microbial inhibitor of Anzhixing, which can ensure that there is no moss for 3-5 years.

There is a cleaning agent, but there is pollution.

Removal Tips:

1. Buy a bottle of disinfectant from the supermarket, any brand will do, usually buy which one you think is easy to use, prepare a small basin, and finally find a small stick.

2. Unscrew the disinfectant water and pour it into the basin, which can be poured more or less according to the amount of moss on the ground.

3. Add some water to the basin and add it until you think it's about the same, don't add too much to avoid affecting the effect.

4. Stir it with a small wooden stick to make it mix evenly, so that the effect will be better.

5. After mixing, sprinkle some on the ground with moss, this is the moss on the ground, and it will be gone immediately.

6. After sprinkling, remember to wash your hands, and brush the used basin, it will be bad if the disinfectant water is stained.

Moss, also known as green moss, is more common on damp ground, rocks and ponds, and moss is very vigorous and tenacious, as long as there is water, it is easy to grow moss. So sometimes in places where it rains a lot, there will be a lot of moss on the ground.

Before carrying out protective treatment, it is necessary to ensure that the floor is clean. Rust, oil, pigment, and dust on the ground should be cleaned up before applying protective agents, and the construction site should be well ventilated.

The use of spraying equipment directly will be Anzhixing compound sterilization algaecide on the surface of the stone, the requirements of full brushing, can not be omitted, after brushing the surface of the stone to maintain a certain concentration for stone absorption, each liter of protective agent can treat 150-200 square meters of stone (depending on the stone absorption rate and stone surface conditions), the water absorption rate of the stone can be sprayed twice. The second application should be done after the previous drying. The algae removal cleaner is left in place for at least 48 hours and can kill the algae cells in the pores of the stone.

After spraying algae cleaner for at least 2 days, use a high-pressure washer to remove dirt from the floor thoroughly.

In the case that there is no open water on the ground, choose sunny weather and spray Anzhixing two-component antifouling and antialgae agent, each kilogram of antifouling and antialgae agent can treat 20-30 square meters of ground according to the instructions, and the interval between multiple brushing is at least 3 hours.

Sprinkle a layer of lime to burn the moss, and then brush it with paint or paint to prevent the moss from regrowing. Third, use copper sulfate to splash. Fourth, use a high-salt or high-alkaline solution to sprinkle on the moss, dry it and then sprinkle it, repeat it many times, which can effectively remove the moss on the road.

If there is moss on the road, it is particularly unsafe for passers-by to walk and drive, and it is necessary to clean it up in time, the moss is generated by some fungi in a humid and shady environment, and it rises in the spring season, and it is also the period when the moss begins to multiply and grow, and it is epiphytic on the ground and wall like hair in the morning. It is non-toxic, because the humid environment is suitable for the growth of fungi, so they settle there, and the moss is suitable for growing in cold and damp places.

Do you still have any doubts, if you think it helps you, can you use your noble little hand to click on the lower left corner of the I want to rate, reward a like, thank you very much for this 3

Remove moss from the road.

In fact, the best way to do this is to clean up the mossy area after the rain.

If there is sun, the moss will die after a day or two, and the dry moss can be cleaned up directly;

If there is no sun, let the wind dry for a few more days, and the most important thing is to cut off its contact with the water!

To inhibit the growth of moss for a long time, copper sulfate can be used, about 1 kg per cubic meter of water is OK.

Various ways to remove moss from red floor tiles:

1. Soil method: If it is not very serious, scrub it with vinegar several times.

Second, the way to spend money: use special floor cleaners, such as "Mr. Vermeer" and "Blue Moon", which are generally sold in supermarkets.

Note: 1. Do not use corrosive chemicals, which will hurt the glaze on the surface.

2. Pay attention to paint buckets, glue buckets, rusty tools and other ironware, and do not put them directly on tiles, vitrified tiles, and kitchen countertops, especially when the ground is wet. Put some cardboard underneath when you put it down.

In addition, you can: use more than 800 water sandpaper to polish the mark with water, and then wipe it clean with a soft cloth, which will not hurt the bricks.

Removing the moss on the red floor tiles with water or vinegar can not be cleaned, only to wipe with oxalic acid first, then wipe with water after cleaning, and wipe it with a dry cloth after that.

Soil method: If it is not very serious, scrub it with vinegar several times. Ways to spend money:

Use special floor cleaners, such as "Mr. Mighty" and "Blue Moon", which are generally sold in supermarkets. Note: Do not use corrosive chemicals, which will damage the glaze on the surface.

Sprinkle some quicklime, spread out the mossy bricks when the sun is shining, and then they will be gone after a few days.

I saw cleaning staff in our community rinse the moss off the red bricks with water and brushes.

I would like to ask you one thing: How can I get rid of moss on red floor tiles? I would like to ask if anybody knows about this, is there anybody who knows about this?

If so, could you please tell me about it? I thank you for telling me about this.

1. If the moss on the tiles is not very serious, you can choose to scrub it with vinegar several times.

2. Use special floor cleaners, such as "Mr. Vermeer" and "Blue Moon", which are generally sold in supermarkets. Note: Do not use corrosive chemicals, which will damage the glaze on the surface.

3. Moss is a generic name for bryophytes, which attach to the surface of objects and spread and grow, so it is also called moss. The moss is emerald green in color, the stem is as thin as silk, and it can be attached to the dark and damp and inaccessible places such as mountain rocks, pools, roof tiles, decaying walls, and wetlands like hair, and it is a very inconspicuous but very interesting plant.

<> "How to remove moss from red bricks."

1. There is moss growing on the red bricks, and I can sprinkle some quicklime evenly on the brick moss. Then we pour water on the quicklime, and the quicklime and water will react against the cherry blossoms, which can effectively kill the moss. Finally, we use a stiff brush to scrub the moss off the red bricks.

2. You can also use a high-pressure water gun to rinse the moss off the red bricks. After cleaning, we can sprinkle a high-salt solution on the red bricks several times, which can prevent the red bricks from growing moss again.

3. You can buy moss remover, sprinkle the remover on the red brick moss according to the product instructions, then use a brush and other tools to clean the moss on the red bricks, and finally spray stabilizer and other products on the red bricks to avoid the red bricks from growing moss again. If there are flowers planted near the red bricks, you can choose a remover product that does not harm other plants.

4. If there is a small amount of moss on the red bricks, we can also use a brush dipped in white vinegar to clean the moss on the red bricks.

5. We can direct the boiled water to the red brick moss, scald the moss to death, and then use a brush and water to scrub it clean. When using this method to remove moss, you should avoid hot water burning your hands and feet.

6. You can also dilute the disinfectant with water, and then put the disinfectant into the watering can and spray them on the red brick moss, which can also effectively kill the moss. Finally, we use a brush to clean the red bricks.

I used to be the head of the unit.

Bai Moss has used a rapid moss killer DAO and long-acting inhibitor called Du "An Zhixing" Zhi, and it has not been long since more than two years have passed.

1. Dilute [Anzhixing Quick Moss Remover Stock Solution] 3-5 times and evenly brush (spray) on the road surface, and the moss will turn from green to yellow-brown about an hour after brushing, and then use a machine (manual) to brush off the rot (the moss is easy to remove when it dies), clean the ground and dry, and the surface can be dry. This step is critical, as a clean surface treatment allows for better penetration of the inhibitor mineralization.

2. Dilute [Anzhixing long-acting moss removal penetrant stock solution] 5 times, evenly brush (spray) on the ground and wall, and fully moisten. The surface stem can proceed to the next step;

3. Dilute [Anzhixing Long-acting Moss Stabilizer Stock Solution] 5 times, evenly brush (spray) on the ground and wall, fully moisten, and dry naturally. Do not get caught in the rain for 8 hours. During the spraying process, it is necessary to ensure that the construction base surface is fully wet.

It is suitable for the removal of moss, lichen and mold of wall and floor masonry materials to prevent regeneration.