If the ground is potholed, can the wooden floor be laid directly?

A variety of materials are used for the decoration, including floor decoration materials, wooden floors. According to the subject's description, before the installation of the wooden floor, the ground has been leveled, and later for various reasons, there are some small potholes on the ground, and the wooden floor is about to be laidIn home decoration, wood flooring is still a more important one, floor laying materials. Usually, the collocation method with a relatively high usage rate is to use floor tiles in the living and dining area; Wooden floors are used in the bedrooms.

After all, wooden flooring is a combination of warmth and comfort.

There are pits on the ground must not be paved, otherwise there will be a sound, there are several conditions before laying the wooden floor, to determine whether the whole house is paved or only the bedroom, if the whole house is paved and the water and electricity go to the ground, the water and electricity need to be grooved on the ground to avoid the height of the floor being greatly affected. According to the information provided by the subject, Qianfanjun's suggestion is that the wooden floor cannot be laid for the time being, and it must be leveled again, and after the cement floor is dried and solidified, then use a horizontal caliper to detect whether there are potholes, if there are no potholes, the wooden floor can be laid.

<> we usually use a two-meter ruler to measure in a carpet style. That is, if there is a gap greater than 3 mm or even 5 mm below the ruler, it means that the ground is uneven and has exceeded the paving requirements of the wooden floor. It is best to find a flat wooden floor again, the ground is potholed, and the wooden floor will creak after stepping on it, and the wooden floor is easy to deform and is very troublesome.

First of all, there are pits in the ground that can cause damage to the wooden floor, and holes may appear over time. Secondly, if there are gaps in the wooden floor, water will flow into the pier, and the house will be damp for a long time, increasing the risk of bacteria, and the specific construction method of cement mortar leveling is to lay cement mortar according to the leveling level, and then close the surface with cement slurry on it. Self-leveling is based on the leveling of cement mortar with polymerized self-leveling cement for ground treatment, and the thickness is generally 3 millimeters.

The ground is potholes and cannot be directly laid wooden floors, and the laying will be uneven, and the ground needs to be leveled, otherwise the effect will not be too good.

Of course not. I think you should do DC leveling first, and after leveling the ground, then the floor will be more beautiful and will increase the service life of the floor.

No, the ground is too potholed to be directly laid on the wooden floor, so the floor should be smoothed before the floor is laid.

Of course. I think you should do DC leveling first. After leveling the floor, this will make the floor more beautiful and increase the service life of the floor.

No, at this time, you must find a professional decorator to smooth the ground and then lay this kind of floor.

Of course, it can't be paved directly, so you must find a way to lay the ground and then lay the wooden floor.

It is not possible to lay wooden floors directly, so there will be empty space. The floor can be leveled and then floored.

No, you need to take care of the whole floor so that the whole floor is very flat and dry before you can lay the wooden floor.

Of course not, you must smooth it out before laying the wooden floor, otherwise you will be laid in vain.

There are some small pits in the ground. Generally, it will not affect the installation of wooden flooring. Because there are some potholes in the ground, which is normal.

When plastering the cement mortar floor, the mixing time of the cement mortar and auxiliary materials is shorter. When plastering floors, there may be a small amount of air. After curing and drying, there will be some small pits.

As long as the dust on the concrete floor is removed, the wooden floor can be installed directly on it.

The installation of wooden floors mainly requires a flat floor. If the ground is uneven, the installation of the wooden floor will affect the service life, and there will be noise when stepping on it. The ground has been leveled, with a small number of small pits, which does not affect the installation effect of the wooden floor.

Even small pits can have a small amount of powder coming off after curing and drying, stepping on and wearing. Wipe the floor several times with a towel. When there is no dust, wooden flooring can be installed.

According to the installation standard of wooden flooring, the ground is free of unevenness, potholes, small holes, peeling, cracks, ash and other phenomena. It is not allowed to install wooden floors on the ground. The installation of wooden floors places high demands on the floor.

In this way, the wooden floor must be flat, smooth, and dust-free before it can be installed. Wooden floors are different from tiles. Before installation, the wood was relatively soft and the ground was flat and smooth.

The ground is leveled, and there are still small holes. It is recommended to brush 1 or 2 times to fix the ground, fill in small pits, and install wooden floors after shrinkage and drying. The stress of the wooden floor is transmitted by installing a keel on the ground.

The wooden keel installed on our floor is in direct contact with the bottom layer, and the installed wooden floor is located above the wooden keel.

If there are pits on the ground, as long as the contact between the wooden keel and the ground can be satisfied, the installation of the wooden floor can be basically realized. Therefore, even if there are pits in the ground, it is possible to install a wooden floor with a wooden keel. The deformation resistance of a wooden keel is much higher than that of a wooden floor.

Because we first installed the wooden keel on the ground. As the keel of the wooden floor, the keel used is a wooden square. After we installed the keel on the ground, we installed the wooden floor, and we had no problem stepping on it.

No, because this will form some holes, and it is easy to step on the floor when using it, and the home is not particularly good-looking.

It is not possible to lay wooden floors directly. Because the floor needs to be leveled, the wooden floor can only be laid after leveling.

I don't think so, because the ground has to be leveled before the keel of the wooden floor can be placed.

For many second-hand houses, some owners hope to be able to lay wooden floors to make the whole space cleaner and tidier after moving in, but because second-hand houses will more or less have pits on the ground, is this situation suitable for laying wooden floors?

Let's take a closer look at this situation.

Because the ground flatness of the new house is sufficient when laying the wooden floor, it adopts the method of direct paving, but in fact, there is a wooden floor installation method is keel installation, if there is a pit on the ground, then there is a keel installation when the wooden floor can actually be paved, but if there is no keel installation, it is not recommended to lay the wooden floor.

First of all, if there is a keel installation on the ground, that is, we are treated on the ground base layer before paving the wooden floor, so that the flatness of the entire ground meets the conditions of the wooden floor, then the installation can be carried out, and at the same time, the pit situation on the ground is also avoided, because the ground is installed with a wooden keel, then in terms of the force mode, the force is first transmitted on the keel, which avoids the uneven force of the wooden floor, resulting in damage, etc.

In addition, compared with the wooden floor, the deformation resistance of the wooden keel is much higher than that of the wooden floor, which avoids the damage to the wooden floor, but it should be noted that even if the wooden keel installation method is adopted, the original flatness of the ground should be carefully checked before installation, so as to avoid the large ground error of the wooden keel after installation, resulting in the inability to install the wooden floor.

If you find that the flatness of the base layer does not meet the installation conditions of the wooden floor, and you want to adjust it through the wooden keel, you must design the corresponding size in advance, so as to avoid the appearance of different specifications of the wooden keel in the whole installation process, resulting in the installation process is too complicated.

If it is a keelless installation method, then it is necessary to consider whether the size and depth of the pit can meet the installation conditions of the wooden floor, but it is recommended not to install it for long-term use, after all, whether it is empty or protruding under the wooden floor, long-term use will cause damage and deformation of the wooden floor, etc., in addition, due to the unevenness, the problem of staggered joints at the interface of the wooden floor will also occur, resulting in the problem of staggered joints on the entire ground is becoming more and more serious.

That's definitely not possible, the floor has hardness, then it will form a gap with the pit, then the floor will be turned over, the pit on the ground should be flattened, and then the floor is paved, so that it is safer to walk.

No, you should fill the pit before you can lay the wooden floor, so that it will be very solid to walk on. Otherwise, it will be redone later.

There is a keel installation on the ground, which is the keel of the solid wood floor that we install on the ground base layer before laying the wood floor. The keels used in common wooden floors are basically wooden keels made of wood squares. The installation method of installing the wooden floor on the wooden keel avoids the problem of pits in the ground.

There are two reasons for this. The force on the wooden floor is transmitted by installing a keel on the ground. In other words, the wooden keel installed on the ground is in direct contact with the base floor, and the wooden floor is installed on top of the wooden keel.

Therefore, if there is a pit on the ground, as long as the contact between the wooden keel and the ground can be satisfied, the installation of the wooden floor can basically be realized. So, even if there are pits in the ground, it is possible to install wooden floors using wooden keels.

There are pits on the ground, of course, you can't directly lay the wooden floor, and it is easy to trample the wooden floor.

For many second-hand houses, some community owners expect to be able to lay flat wooden floors to make the overall indoor space clean and tidy after moving in, but because second-hand houses will more or less have pits on the ground, is it suitable to lay wooden floors in such a situation?

Let's conduct an in-depth analysis of this situation.

Because the new house has sufficient ground flatness when laying wooden floors, it is necessary to choose the method of immediate paving, but in fact there is also a wooden floor installation method of keel installation, if there are pits on the ground, then when there are keels installed, it can actually be paved with wooden floors, but if there is no keel installation, it is not recommended to lay wooden floors.

First of all, if there is a keel installation on the ground, that is, we carry out the solution on the ground floor before paving the wooden floor, so that all the ground flatness reaches the standard of the wooden floor, then the installation can be carried out, in addition, it also prevents the ground from having pits, because the ground is installed with a wooden keel, then in terms of bearing force method, the force is first transmitted on the keel, which prevents the uneven bearing force of the wooden floor, causing damage and other conditions.

In addition, compared with the wooden keel, the anti-deformation working ability is far higher than that of the wooden floor, which prevents damage to the wooden floor, but special attention should be paid to the fact that even if the wooden keel installation method is selected, the initial flatness of the ground needs to be carefully and carefully before installation, so as to prevent the wooden keel from having a large deviation on the ground after installation, resulting in the situation that the wooden floor cannot be installed.

If you find that the flatness of the bottom layer does not meet the installation standards of the wooden floor, and you want to adjust it according to the wooden keel, you must formulate the matching specifications in advance, so as to prevent the appearance of different specifications and models of wooden keels in the whole installation process, resulting in excessive complexity in the whole installation process.

If it is a keelless installation method, then it is necessary to consider whether the size of the pit and its depth can meet the installation standard of the wooden floor, but in order to better long-term application, it is also proposed not to install, after all, whether the bottom of the wooden floor is empty or prominent, the long-term application will lead to the destruction of the wooden floor and its deformation.

I don't think you can directly lay the wooden floor, you must smooth it so that you can lay the wooden floor.

I don't think so, because if you make a wooden floor without paving, it will make the floor unstable.

I don't think so, you have to make the plane flat before you can lay the floor, otherwise the ground is uneven and people will slip.