How to make various storage boxes? How to make a storage box

The first 1-5 steps are mainly in the creases, and the later 6-12 start to stand up the box. The second fold is made to fold the corners inward. Note that the left side is only folded with the inner layer, and the outer layer is not folded.

Fold the top two corners down to get a broken line; The same goes for below. Now look at the paper in your hand and see that it should have the following creases, and the corners should be folded inward. Pick up the left inner layer and fold it in half to the right.

Pull the right half upwards into a dustpan shape. Now look to the left and merge the purple dotted lines together to fold out a fold, the green dotted line, to fold out a triangle.

This is my commonly used glove box, when I go on a business trip, I can fold a dismantling machine nail and gadgets, which are very convenient, and a wet paper towel can also be used as an ash box. Find a casual piece of paper, fold the opposite side of it like this, stuff the middle in, then stuff the sharp corners into the edges, fold the other side in the same way, pull up on both sides, fix the creases, and a sturdy little box will come out. Its advantages are that it is relatively firm, generally not loosely disconnected, the depth is also appropriate, and it will be folded at a glance, and the threshold for doing it is very low.

On the hard lining, also draw a hexagonal lining, and add a seam. The lining of the box should also be made to look better. The cards inside the box are covered with double-sided tape.

Glue the lining to the inside of the box. The hexagon at the bottom should also be glued with double-sided tape. Attach the hexagonal shape at the bottom to the inside of the box.

Cut out the remaining 2 cards and cut each card into 3 equal small cards.

Paste the hexagonal shape made from the first 6 small cards to the edge of the lid. Try it on the lid to see if it fits and is easy to modify. Then use the same lining to make a thin liner, preferably with an iron.

Stick it on the edge of the lid and you're done. Make a lining of the lid out of lining. Cut out a hexagon of the same size with a lid from cardboard and put it inside the lid.

After the vertical line of each side is drawn, cut out the excess, and that's it. Fold up the outermost edge. Wrap freshly cut wallpaper around a 6-sided card.

The perfect back comes out, and it's beautiful. The three-dimensional feeling is also good. Draw a hexagon on the cardboard according to the shape of the box, cut it out and place it at the bottom of the box to increase the hardness of the bottom of the box.

Note that the length of the cut red line should be greater than the width of its adjacent, so that it can be folded in later. In addition, after folding it in, I fixed it with a stapler, two on one side, a total of four, and it was very stable. Milk cartons are used for convenience, uniform size, and easy to cut.

The outside is wrapped with a pretty linen. After retiring, Wo Ma Ma wanted to make storage boxes to play, and finally recommended a book for her to make storage boxes with milk cartons, called "Transform Cute!" Handicraft milk cartons 42 points of ideas".

Familiarizing yourself with the steps is simple. However, the outer edges of the hexagon do not need to be too wide, they only need to be the same width as the small cards cut out at the back. Stick the lining inside the lid and you're done.

Then glue a row of beads on the bottom edge of the box, which can also be waterproof, and stick a few beads in the center of the lid as the handle of the lid.

First, glue 6 PVC cards into a hexagonal shape with transparent glue. Draw hexagons on the wallpaper, with each side the same length as a PVC card. Then use the PVC card on the outside of each edge to draw it, say the same width of the card, and after the drawing, add a side edge outside the outermost edge to use as a PVC card.

Draw a vertical line again.

I benefited a lot from the tutorial of the high ticket origami box, and on the basis of that, I added a little bit of my idea to make the carton bigger. There is a handmade leather goods base, but also a hobby, a long time ago idle to make some storage boxes, each height made a haha. The shorter two are used to put ornaments, and if anything is suitable for other heights, you can put it in

Here's how to make a storage box:

1. Use the shoebox to do the classification of the shoebox: according to the size of the shoebox and the way you want to classify, cut the whole shoebox, and transform the shoebox into a storage of children's clothes, underwear, socks, ties and other small items.

2. Use a shoebox to store wires: make a few small holes on the edge of the shoebox, separate several parts inside, install wires respectively, and the wires pass through each hole.

3. Use cardboard to make the frame of the storage box and the body part of the storage box. The drawer part of the storage box is designed with a notch to open open. Pick a wrapping paper with your favorite pattern, wrap the box (both the box and the drawer should be wrapped), and finally put the drawer into the box.

The box containing things is to collect things (mostly referring to small items, such as: office stationery, cosmetics, documents, gadgets, socks, pants, etc.), as the name suggests, called storage boxes.

The storage box, nicknamed the antique box, was used by the archaeological team to store the fragments of cultural relics unearthed and sorted out in the early days. These boxes are generally strictly numbered, ranging from large to small, but most of them are shoebox sizes (excavated artifacts are generally heavier, and the weight contained in the size of a shoebox is the most suitable for handling). In modern society, storage boxes have gradually evolved into boxes like "glove boxes", which contain things.

The steps to make a storage box are as follows: prepare three identical boxes, two inner boxes, a knife, and double-sided tape. Prepare three identical boxes, two inner boxes, a knife, and double-sided tape.

Attach the wrapping paper to the bottom. Attach the wrapping paper to the side. Wrapping paper is attached to the corner part.

Wrapping paper is attached to the inside of the box. Wrap the side facing you as well. The following materials are used in the production process:

Snacks or cooked food wrapping cartons, old clothes** buttons, wrapping paper, white latex, scissors, rulers, pencils, wool, watercolor pens, cake paper, heart-shaped paper patterns.

To make the storage box, step 1 uses scissors to disassemble the carton as shown in the figure, trim the two bottoms into a heart-shaped section, and then use glue to stand the two halves again. To make the storage box, step 2 cake paper is cut into wavy decorative lace as shown in the picture and glued to the small basket. Above.

To make the storage box, step 3 uses double-sided tape or glue to wrap a good-looking wrapping paper on the surface. For the production of storage boxes, step 4 Some useless colored buttons obtained from the transformation of old clothes are glued to the edge of the carton as lace.

To make the storage box, step 5 uses a screwdriver to drill holes in the side to make it easier to wear the handle. To make a storage box, step 6 puts on a handle woven with wool or ribbon to complete a cute and practical homemade small basket. It's very beautiful and beautiful.

First of all, we need to prepare the following materials: needlework, cloth, wrapping paper, cartons, cardboard sheets, scissors, scotch tape, double-sided tape.

Next, we started to make the underwear storage box, you must take a closer look.

First, we need to make a box without a lid from the cardboard and then glue the sticky area with scotch tape.

Second, the box is done, we have to make a cover, in fact, this cover can be done or not, if you are afraid of putting dust in there, then make a cover, the cover is made of two pieces of cloth sewn together, this is relatively simple, after sewing we need to fix the sewn cover on the carton.

The first rotten third, we need to package this carton, which is relatively clean and comfortable, hehe. Use the prepared wrapping paper and double-sided tape bar box to wrap it, and this is what it looks like when the packaging is finished.

Fourth, we should make the partition inside the box, cut it into a rectangle with the prepared piece of paper, and then paste it with wrapping paper.

Fifth, after the box is ready, fix it in the big box, so that the space is divided and the underwear storage box is completed.

The steps to make a storage box are as follows:

1. First of all, we must prepare the following tools: a ruler, a shoebox, a pencil, a piece of wrapping paper, a pair of scissors, a roll of double-sided tape, and the box is best to choose a shoebox.

2. Then we cut off the lid of the box; After that we use a ruler to find the centerline of the box; Then we select the center point at the bottom of the box as the vertex of the triangle and draw two lines so that the triangle becomes an isosceles triangle, and the same is true for the other side.

3. After it is determined, we use scissors to cut out the triangle; We flip the box over and stick a strip of double-sided tape at the bottom; After that, just tear off the double-sided tape and fold it back in half; Next, we cut off the edges of the lid that we just cut, leaving the middle part.

4. We cut the lid into two pieces of paper the same size as the notch of the semi-finished product; Now we need to fix the card, with double-sided tape first, simply fastened on both sides, so that we have a storage box like Figure 2, so that we are basically done.

5. But in order to be more beautiful, we need to pack the carton with the wrapping paper prepared before, and after wrapping, we can see that our storage box has become more beautiful; The last thing we need to do is to simply sort out the messy wrapping paper, which can be trimmed simply, and we can complete such a cute storage box.

Here's how to make your own storage box:

Step 1: Assemble the bag in the "Cover" section of the storage box. The cut cloth is reversed, and the four side facades and the four corners of the base are fixed with bead needles.

The cover is then placed upright on the table, and the size of the box is adjusted so that it can finally fit on the outside of the cardboard box.

Step 2: Sew the outer floral cloth and put it on the outside of the carton. Sew the fixed cover cloth one by one according to the stitches drawn before. Turn the sewn cover upside down, with the front side of the cloth facing outward, and cover it over the previously prepared cardboard box.

Step 3: Make the "lining" part of the storage box. Prepare a piece of cloth that is different from the outer cover, do the same operation method as above, measure the dimensions, and sew the four side facades and the base part together.

The sewn lining cloth is spread on the inside of the carton, and the four sides of the four-sided cloth and the outer cover part are temporarily fixed and connected together with bead needles, and the position is adjusted. Liang accompaniment.

Step 4: Stitch the lining and cover of the storage box. Sew the floral cloth at the junction between the lining of the storage box and the outer cover along the fixed position of the bead needle. After the lining and cover are sewn together, adjust the position to fit properly.

Step 5: That's it! A beautiful and practical storage box was put into use.

In a few simple steps, the original waste cardboard box will become a beautiful and practical storage box, which is the most suitable for storing some small sundries and folders in the storage room and writing desk at home!

Materials: cardboard, tape paper chips, colored pattern cloth, pens, needle and thread, scissors.

Method: 1. Prepare a tape paper core, draw two circles on the cardboard along the outer ring of the paper core, cut the two circles, one for the bottom and the other for the cover.

2. Cut the prepared fabric into two strips of cloth that are slightly larger than the height of the paper core and the circumference of the paper core is the length, and then cut out two cloth strips with the same size as the bottom circle for decorating the inside and outside of the jewelry storage box and the bottom cover.

3. Sew the top and bottom two strips of cloth cut in the previous step together, sew them into the shape of a cylinder, and then sew the other four strips of cloth on the bottom and cover.

4. It is necessary to put the sewn cloth tube sleeve on the paper core before the crack, and then sew the bottom of the jewelry storage box and the cloth tube sleeve that have been made.

5. Take out the round fabric that was cut before, sew the inside of the lid with the cotton, and then sew the cloth on the lid with the Tibetan needle method.

6. Sew a strip of about 2 cm wide strip bucket skin on the back of the jewelry storage box, and connect the upper cover and the box body.