Does the water and electricity part of the rough house have to be changed? How to change the most ec

The water and electricity part of the rough house on my side must be changed, because if it is not changed, it will have a bad impact on the subsequent decoration plan; I think if you want to be the most economical, you should first determine the renovation plan, and you can modify the water and electricity parts yourself, and then you can make changes by yourself.

Yes, the water and electricity of the rough house must be changed accordingly, so that it can fully conform to the style of decoration, in order to achieve the best use efficiency, in the modification as far as possible in accordance with the original reserved line design, shorten the change of direction and distance.

It is necessary to change, according to the finishing of the water and electricity part, as well as the overall decoration effect, and the reasonable modification of the process, so that it is economical.

Crude hydropower projects only achieve the role of simple application. For example, the waterway in the wool is generally reserved for a water point in the cupboard and bathroom, and a water point is obviously unlikely to meet the needs of people, so it must be renovated at this time. The same is true for the power circuit in family life, most of each room is reserved for a lamp, and then reserved for several power outlets, which is also difficult to meet the needs of the application.

Renovation of waterway interruption points. For the renovation of the waterway interruption point measurement, it is to start with the water point reserved in the kitchen or toilet of the restaurant, and then gradually lay out all the waterways in the kitchen and toilet of the restaurant. The original waterways in the kitchen and bathroom will not be modified.

Therefore, the cost caused by this group is the water point that everyone improves in the middle and later stages, and the pipe fittings in the middle of the water point. Product quality problems, different real estate developers, different stages, different buildings, there will be differences.

At this point, you can listen to the views of the neighbors and their property management staff between the floors. In fact, there is generally no problem with water pipes and wires, gate valves, and tap faucets with poor quality and cheap sources, and many low-end socket switches. Considering whether the pre-water filter, garbage disposal machine, stove, etc. should be modified in the middle and later stages, the hotel must reserve power sockets for eating Malatang, smart toilets, etc.; If the large living room is large and the layout of the room is loose and there are elderly people in the family, it is necessary to consider reserving decorative lights at night.

If the house is large, it is necessary to take into account the reasonable layout of the network cable, so as to prevent some data signal blind spots after moving in. If the pursuit of artificial intelligence technology is perfect, the switching power supply of smart curtains must be taken into account, and the automatic drying rack does not need to reserve the switching power supply (generally the light switching power supply of the living balcony will be used). Check the route design and wire quality of the real estate developer's delivery at this stage, the size of the wire, and the output power.

Subsequently, it integrates its own application requirements to achieve effective and unoverloaded lifting and adjustment.

Many renovation companies have their own design ideas, including changing the water and electricity lines. Personally, it is recommended that the indoor space arrangement should be considered before decoration, as long as the water and electricity interfaces are reasonably convenient and sufficient. It is not advisable to change.

As long as it is a qualified developer, the important parts are still safe and reliable, and the design is in place. Changing the route at will can also be a safety hazard. I myself do decoration, often deal with water and electricity, the developer's wires, water pipes are up to standard, the circuit is either not enough, or the location is high.

<> waterway is still recommended to replace the whole house water pipe, after all, the developer will purchase the worst standard water pipe in order to save money, which is not suitable for long-term use, and the general waterway is greatly changed. We generally have to renovate the original water and electricity. Especially for some of the newly built commercial houses are rough houses, so do we have to carry out hydropower transformation?

What's more, now many families have changed to wooden kang, electric kang, and tatami mats, and the location of the electric socket needs to be changed. ......

The main thing is that the person has to be a plumber. Give a reasonable price. The premise must be to know the market price, and the family must not lose the cost of work.

After completion. Invite someone to rub it off. This not only saves money, but also deepens the relationship between friends.

Why not? It must be changed, especially the water pipes, the electricity is still a little better, and it can still be used if it is not changed, but it is very inconvenient to use. The transformation of water pipes is divided into the ground, the middle, and the sky, and the cost of going to the ground is high, and the electricity change is of course the most affordable point-to-point.

A power strip is not enough. In the study, one wall should be made a bookcase, and the socket could not be kept, so it had to be changed to the wall next to it, and the opposite one was blocked behind the sofa and so on. In other places, such as the weak current box, there is no socket, and you must connect one yourself to supply power to the optical modem.

It doesn't necessarily need to be changed. As long as it does not affect the normal life is not necessary, so that the decoration is the most economical and cost-effective, if you have to change, it is best to two points and one line, do not take a long detour.

Yes. Because the water and electricity laying of the rough house is not very reasonable. When you change it, you should find a professional master to modify it, and it will not be reworked.

The water and electricity of the rough house does not necessarily have to be changed, but the water and electricity layout of most of the network black room is different from their own living habits, if the layout is more reasonable when changing, you only need to change some of the circuits that you need to add, and you don't need to change the layout of the wires in a horizontal and vertical way, which is more wasteful.

Hydropower must be changed. Because there are very few lights and sockets in the blank room, how to change it depends on the living habits of your own home.

Most of my friends are buying a house for the first time and have no experience in retrofitting water and electricity. Developers arrange water and electricity when furnishing homes to meet the basic needs of the family. The amount of hydropower renovation work is still large, and it may need to be rearranged, resulting in unnecessary waste and economic burden, and this basic hydropower facility is inconvenient to use.

Hydropower renovation does not mean that the water and electricity of the whole house need to be rearranged, and should be adjusted according to your actual needs. During the renovation process, some renovation companies may advise the owner to redecorate. This action could fall into the trap of a decoration company.

Don't believe it easily. Pay attention to the presence of modules in the socket and network cable socket, as well as the space for the mirror and coat hooks, and consider the lighting near the mirror; When the circuit is rebuilt, the surround sound cable should be buried in the ground.

The living room, master bedroom, and bathroom should be set up according to personal living habits and convenience; There is no need to set up too many outlets behind the TV. In the future, it is best to attach the patch panel to the side of the TV. Strong and weak wires cannot be in the same pipe, which can cause interference.

If the living room, kitchen and bathroom are tiled, some locations can be properly considered without the need for slotted wiring. Exhaust fan switches and ** sockets should be installed near the toilet, not near the wall of the toilet door; The yuba should be installed near the shower or bathtub, not in the center of the toilet.

Many renovation teams do not have a pressing test, and after determining the location of the washing machine, it can be considered that the drainage pipe of the washing machine is within the wall, which is beautiful and convenient; It is best not to use deep water to seal the floor drain for the floor drain of the washing machine. The washing machine drains quickly and has a large amount of drainage. The drainage rate of the deep water seal floor drain simply cannot be satisfied, which will directly lead to water overflow.

When closing the house, take care to check that each drain in the kitchen and bathroom is unblocked. It should be dredged in time, and when decorating, the drain should be protected, especially when the tiles in the kitchen and bathroom are laid, which is most likely to cause the cement to fall into the drain, resulting in blockage.

The water and electricity part of the rough house must be changed, that is because it is just a simple line arrangement, and you must buy some thicker and thicker pipes when you renovate, so that there is a guarantee for long-term use.

It has to be changed; Because if the water and electricity parts are not changed, there may be a series of problems, and there will be frequent failures, resulting in increasing costs.

It must be changed; Because if Mao Peifang does not change the water and electricity part, there may be a series of achievements, and there will often be problems, resulting in an inexhaustible increase in the old capital.

There is no need for all changes, because all changes cost a lot of money, and the layout of the water and electricity in the rough house is enough to meet the basic needs of the family.

1. It is best to change the water and electricity of the blank house.

2. When installing water and electricity in the rough house, it is necessary to pay attention to whether the quality of the water pipes and wires installed by the developer meets the needs of the room. For example, in the kitchen part, household appliances will be used more, and the quality of the wires should be seen to see whether they meet the use standards of high-power electrical circuits; In terms of water mill touching pipes, it is necessary to see whether the aluminum-plastic pipes or PPR pipes are qualified products that have been inspected and shipped out of the factory.

3. There are also whether the hot and cold water pipes use different colors to divide the Hu and so on. If these are not qualified, then they should be replaced, but not the water and electricity in the blank room should be replaced, but according to the demand.

In the process of blocking the work of the blank house, the unnecessary joints of the pipe body in the wall should be minimized, the direction and layout of the water supply pipeline should be reasonable, the water pipes should be arranged neatly, the horizontal and vertical should not be obliquely walked, and the intersection part should be connected by a bridge bend.

<> "1. Does the rough house need to be changed to water and electricity?

If there is a problem with the quality of the previous water and electricity, or the water and electricity wiring does not meet the needs of the owner, there is a deviation, then the water and electricity need to be changed again; If the quality and layout meet the needs of your own stool, there is no need to change the water and electricity again.

Second, what should be paid attention to in the water reform of new houses.

1. When designing the waterway, it is necessary to think about all the equipment about the open burial of water, such as water heaters, water purifiers, toilets, etc., determine their location and installation, and think about whether they need to use gas or electricity in advance, so as to avoid temporary replacement and repeated transformation of the waterway.

2. When the waterway is transformed, the pressure test should be carried out, and the pressure pump "return valve" can be opened when pressurized, so that the loop can be formed, although the pressure pump seems to be working, there is not much pressure in the pipe, especially for the electric pressure pump, more attention should be paid to, if you don't understand, you can ask professionals to help solve it.

3. If you need to close the excess floor drain, you can block the gap in the drainage pipe to avoid overflowing, and the bathroom should be reserved for wash basins, toilets and other water outlets, but also to take one out, so that it will be more convenient to mop the floor in the future.

4. Pay attention to determine the location of the washing machine, the washing machine should consider the noisy ant drain, and try not to use the deep water seal floor drain for the washing machine floor drain, because the launching speed of the deep water seal floor drain cannot meet the demand, which will lead to water overflow.

Now most of the houses that people buy belong to the rough house, and the water and electricity have been installed when the rough house is handed over to us, but in most of the decorations, the water and electricity will be renovated late, so that it is safer to use. Let's introduce to you whether the rough house can not be changed to water and electricity?

It is recommended that the owner still make changes to the water and electricity when decorating the rough house. Generally speaking, we buy a bad house just to do a simple water and electricity design, this kind of construction is also difficult to meet people's usual living needs, to know that after the reasonable arrangement of water and electricity, we will be more convenient to use in our future life, the safety is also relatively high, it can be said that this process is also more important.

Precautions for waterway reconstruction.

1. First of all, when we are in the construction process, we should also pay special attention, try to design some unnecessary joints in the wall, if the pipes on the ground have some crossing, remember to install the main pipe below, but also let the water pipe distribution reach the horizontal line.

2. After the pipeline is distributed in place, for example, the pipe is stuck at the turn or there is a standing faucet, so that it will not loosen, and a special pipe clamp must be used to achieve this effect.

3. The sewer pipe and floor drain must be installed in the place where the water is passed, and the special PVC glue must be used when connecting the PVC pipe to coat it evenly on it. Moreover, it should be noted that the horizontal connection should also be paid attention to when the blank room is buried, and it is necessary to keep it static and solidified for a certain time.

4. It is best to use a light keel for the water pipe, and the cement board is also prone to problems, so it must be of good quality cement.

Precautions for circuit modification.

1. Special attention should be paid to the electrical reform, and it is necessary to ensure that the line is a live wire, so that it will be more convenient to maintain.

2. Here is a reminder that the distance between the wall and the horizontal groove is not allowed (for example, the distance of the load-bearing wall is 30cm, and the distance of the non-load-bearing wall is about 50cm).

3. The best way to fix the line pipe is to use a metal pipe clamp, and the spacing should be paid special attention to, not greater than 60cm. Where the ground cannot be punched, cement should be used to fix it. Dan Wang.

4. Strong wires and weak wires should be used separately, and their adjacent distance should be controlled, not less than 50 cm, if there is a crossing, the angle should also be controlled to keep 90 degrees.