So how to cool down the water law snake, what is good for disinfection of the water law snake room

Although indoor breeding of water law snakes can avoid the direct sunlight in summer, it is also necessary to do a good job of heat stroke prevention and cooling to ensure the normal growth of water law snakes. When the temperature exceeds 35 in summer, it is necessary to cool the water law snake, which can be cooled by an electric fan or watering; The climate is cold in winter, and if it is a water law snake, release the water law snake into the wintering room to hibernate. If it is a breeding meat snake, it is necessary to heat the snake room at this time, and the stability is controlled at 23-28.

Pay attention to the hygiene of the snake box and remove the residual material in time. Add 5 tablets of trichlorfon to the feed and feed it 2 times, but you can use it for 1 year without insect control. As long as the food is kept clean and hygienic, snakes rarely get sick inside the box.

At the same time, it is best to drink cool boiled water for snakes, and well water and mountain spring water can also be fed directly to snakes, but snakes can never be fed directly due to chemicals in tap water.

Tang Poetry and Song Words Atlas V Encyclopedia Past Review.

The toad must be installed in the right position. It is best to put it before heavy rain.

I have a flower wave snake here, I have also caught, but I don't know if it is poisonous or not, it feels a bit like a close relative of a pheasant's neck,

During the temperature incubation, the temperature in the three-dimensional incubator is 37 C, the temperature of the hatcher is 37, the temperature of the hatching room is 24 27, when the incubation temperature is high, the embryo develops quickly, but the young blue peacock is weak, if the temperature exceeds 42, the embryo will die after 2 hours and 3 hours, the incubation temperature is high, and the normal absorption of the contents of the egg will be prevented; On the contrary, when the temperature is low, the growth and development of embryos are stunted, hatching is delayed, the hatching rate is reduced, and if the temperature is lower than 24, all die after about 30 hours. In the early stage of incubation, the relative humidity is 65% to 70% to prevent excessive evaporation of water in the egg, and in the middle and late stages of incubation, the relative humidity drops to 55% to 60%: when the young blue peacock breaks the shell and hatches, in order to prevent the fluff from sticking to the egg membrane, causing the difficulty of rubber feathers and hatching, the relative humidity can be increased to 65% 75%.

Sufficient humidity and carbon dioxide in the air are good for hatching. During the incubation process, the humidity of the incubation can not be too high or too low, when the humidity is too high, add 45 50 water to the water pan, and sprinkle more water on the indoor ground; When the humidity is too high, reduce the water tray or add less water, sprinkle less water on the ground, and strengthen indoor ventilation. The relative humidity of the hatchery and hatcher rooms is maintained at around 75%.

The purpose of ventilation is to make the incubation environment fresh and discharge carbon dioxide, so as to ensure that there is enough oxygen for the growth and development of the embryo, which is very necessary for the development of the embryo. The embryo's need for oxygen is less in the early stage, more in the later stage, less in winter and more in summer, 8 days before incubation, 2 times a day, 3 hours each time, after 8 days, without affecting the humidity and humidity, it is advisable to ventilate frequently, especially when there is a hatch out of the shell in the machine, it should continue to ventilate. For the first 7 days after the egg is flipped and incubated, the egg is turned every half hour to 1 hour, and the egg is turned every 3 hours thereafter, and the flipping angle is 90 degrees.

In order to make all parts of the embryo evenly heated, to prevent the embryo from sticking to the shell. The upper and lower eggs should be reversed, and the egg tray should be reversed with the eggs of **. Stop turning eggs after tray 4 days before hatching.

When the sand hatches the eggs of the water snake, the eggs should be placed horizontally. Arrange the eggs in a single layer, do not overlap, do not separate the eggs that are connected together, and do not cover the sand too thickly, as long as the eggs can be covered. The water content of the sand must be controlled, the water content of the sand in the early stage of the king egg is slightly higher, the eye snake egg is slightly lower, the other snake eggs are moderate, the relative humidity of the air should be about 90 percent, and the temperature should be 28 to 30 degrees.

When the young snake comes out of the shell, it is necessary to deliver the baby artificially.

Ingredients: 750 grams of snake meat.

Excipients: 10 grams of refined salt, 5 grams of monosodium glutamate, 15 grams of green onion, 20 grams of rice wine, 4 grams of ginger.

Method: 1. Chop the snake meat into about 3 cm long segments, blanch it in a pot of boiling water, remove it and wash it with water, and put it in the soup pot.

2. Put the soup pot on the fire, add 1500 grams of water, rice wine, ginger, green onions, bring to a boil over a strong fire, skim off the foam, and transfer to a low heat to cook until crispy. Then, pick off the green onion and ginger pieces, put in refined salt and monosodium glutamate, and put it in the soup bowl to drink the soup and eat meat.