If you add a battery of water, it will run out of power Can you add battery water when the dry batte

It may be that too much water is replenished, which dilutes the electrolytes. Or it is caused by the purity of the water is not enough, the charging is not well charged after replenishment, and the air outlet hole is blocked.

On the contrary, there is no electricity with the addition of battery water, which may be due to the fact that the water is replenished more and the electrolyte is diluted. Or it is caused by insufficient water purity, insufficient charging after water replenishment, blocked air outlets, etc. Battery water, also called electrolyte, is formed by the preparation of dilute water and sulfuric acid from dilute sulfuric acid.

It is used to react with the plates in the battery for charging and discharging.

Car batteriesStrictly speaking, you can't add water privately, and the current batteries are maintenance-free, and the storage capacity of the battery will be reduced after adding water. The decrease in the storage capacity after adding water to the battery is due to the lack of water purity, and the high liquid level makes the positive and negative electrodes form a discharge on the liquid level.

Notes:When the vehicle loses power and cannot start, when charging the battery with the charger, you do not need to wait until the battery is fully charged to turn off the charger, and when the battery has enough power, you can turn off the charger when you can start the engine.

After starting the engine, the engine will be driven by a belt, and the generated electricity will be rectified and stabilized, and the car battery will be directly charged. The owner only needs to drive for a while, and then the battery power will return to normal.

Not required and not allowed.

Car DU battery points.

Lead-acid batteries and zhi

For dry batteries and maintenance-free batteries, only lead-acid DAO batteries can be added with refiller in the case of less liquid, while dry batteries and maintenance-free batteries do not need to add refiller; The internal structure of the lead-acid battery is different from that of the maintenance-free battery, which is composed of positive and negative plates and dilute sulfuric acid; Dry charge battery: also called dry charge lead-acid battery, the main feature is that the negative plate has a high power storage capacity, in a completely dry state, can save the power obtained within two years, when using, only need to add electrolyte, after 20 minutes can be used, no need to add liquid maintenance in the future, maintenance-free battery due to the advantages of structure, the consumption of electrolyte is very small, and there is no need to supplement distilled water in the service life.

After the battery lacks electrolyte, the plates exposed to the air will oxidize, which will cause the plate vulcanization, and after a long time, the battery will lose its charging and discharging ability, causing the battery to be disconnected. Therefore, it is necessary to always check whether the battery is short of liquid, and add it in time after it is missing.

It is best to keep the battery in full charge frequently, and the battery in use should be charged once a month, and the storage period should not be too long to avoid long-term shelf. The charging state of the battery can be judged according to the electrolyte density and terminal voltage (single bar), and the battery in good general condition should be above the single cell voltage when measured with a high-rate discharge meter, and the electrolyte should remain stable within 5 seconds.

Precautions for the use of batteries:

1. Master the charging time. In general, the battery is charged at night, and the average charging time is about 8 hours. If it is shallow discharge, the battery will be fully charged soon, and if it continues to charge, it will be overcharged, resulting in water loss and heating of the battery, reducing the life of the battery.

Therefore, it is best to charge the battery once when the depth of discharge is 60%-70%.

2. Do not store at loss of electricity. The state of power loss refers to the fact that the battery is not charged in time after use, and the battery is prone to sulfation when the battery is lost, and the lead sulfate crystals are attached to the plate, blocking the ion channel, resulting in insufficient charging and a decrease in the capacity of the battery. The longer the idle time, the more serious the damage to the battery.

When the battery is not in use, it should be charged once a month to prolong the service life of the battery.

3. Regular inspection. In the process of use, if the driving range of the electric bicycle suddenly drops by more than ten kilometers in a short period of time, it is very likely that at least one battery in the battery group has a short circuit phenomenon such as broken grid, plate softening, and plate active material falling off. At this time, you should go to a professional battery repair institution for inspection, repair or matching.

Whether you are a car or a motorcycle, the battery is always short of water, there is only one reason, the charging voltage of the regulator charger on the car is too high, and the charging current is too large, resulting in a large amount of battery water evaporating, just like the water in a boiling pot, a large number of bubbles emerge, forming steam and dissipating it. There is only one solution, replace the qualified charger, the charging voltage is normal, and it will be higher if it goes up. The battery is used for a long time, and when it is aged, it will only appear that there is no electricity, and it will not cause the battery to be often short of water.

The main component of the so-called electric water is a mixed solution of lead sulfate and sulfuric acid, referred to as lead-acid.

The working process of ordinary batteries (batteries) is that the chemical energy in lead-acid converts the stored chemical energy into electrical energy through reaction, and if there is a lack of electricity and water, there is no doubt that the battery will lose its power supply capacity.

If other hardware is not damaged, it can be restored by artificially adding lead-acid.

Summary. Hello, this question can give you a perfect reply, wait for me to sort out the information, I'm typing, 2-3 minutes, don't finish.

Hello, this question can give you a perfect reply, wait for me to sort out the information, I'm typing, 2-3 minutes, don't finish.

Hello, I am your exclusive technician, attentive, careful, dedicated to answering your car questions, for you to find the corresponding problem solutions and solutions, will provide you with a satisfactory answer! I hope this service can help you, if it is helpful to you, I look forward to your praise and attention. Hello, this situation is generally caused by plate damage.

It is basically impossible to consume the current battery water normally. That is, it is not possible to power on normally and then recharge. This one must be replaced with a battery to solve the problem.

It can also be charged at a normal small current of 3 to 4 amps, about 4 to. After 5 hours, see if it can be charged normally. If you still can't, you have to replace the battery.

This is caused by internal damage. I hope mine is helpful to you and I wish you a pleasant ride.

Summary. My dear, I am glad for you: I added battery water but no power, because after adding battery water, because the water quality is not pure enough, the stored power is reduced.

When the battery has enough power to start the engine, you can turn off the charger. When the charger charges the battery, you don't have to wait until the battery is fully charged to turn off the charger. The owner only needs to drive for a while and the battery will return to normal.

Put the shovel in the gap, let it go slowly, and then shovel it away, and the seal will be removed smoothly and thoroughly. After the engine is started, it is driven through the housing, and the generated electricity is rectified and pressurized to charge the car battery directly.

What's the deal with the battery water running out of power? What should I do if I add a battery of water but it runs out of power, and it can't be charged?

My dear, I am glad for you: I added battery water but no power, because after adding battery water, because the water quality is not pure enough, the stored power is reduced. When the battery has enough power to start the engine, you can turn off the charger.

When the charger charges the battery, you don't have to wait until the battery is fully charged to turn off the charger. The owner only needs to drive for a while and the battery will return to normal. Put the shovel in the gap, let it go slowly, and then shovel it away, and the seal will be removed smoothly and thoroughly.

After the engine is started, it is driven through the housing, and the generated electricity is rectified and pressurized to charge the car battery directly.

When adding water to the battery, be sure to remove the sealing cap. Find a few small holes, open the hole cover, each hole is 32 batteries up to 20 ml, like 20 batteries plus 10 ml, insufficient more can be increased to 15 ml. To make a small iron bar, a small shovel can also be made, as long as the seal can be opened smoothly.

There is a small gap at one end of the battery. Remember to add water when adding water, no matter what type of battery it is, never fill it up with water, be sure to add it proportionally. It is better not to pry the seal open, so that it is not easy to operate.

If you can't shovel it directly by hand, you must use a small steamed bun, what hard objects are slowly knocked down, the shovel is diagonally face down, slowly smashed forward, and the cover is easy to remove. It's okay to see that you can't see the water from each hole after adding water, and if you see the water tilting a little or pumping it out with a syringe, it's even less. After adding water, use 502 or other glue dots, the lid is firm, let it stand for 2 or 3 hours and then charge, and it will be fine.

It may be due to the following two reasons: one is that the sealant of the battery or the battery shell is cracked and leaking. The second is that the charging voltage is too high, resulting in overcharging of the battery and consuming the battery water.

If it's the first cause, you can see white powder around the pole or traces of corrosion on the battery holder. Whether the second reason is that the battery water consumption is too fast, you need to find an experienced master in repairing the battery to test the charging voltage, you can judge.

No. In the early years, some people directly filled the battery with well water, boiling water, and evenRiver waterIn the end, none of the batteries survived, and the batteries were completely damaged and could not be repaired soon after refilling.

The main reason is that the water contains metal ions, which will cause the battery to self-discharge seriously, and the battery will be discharged when it is not used, so the battery life will be greatly reduced. Moreover, it is particularly easy to lose water when charging, and the water is also easier to evaporate, resulting in a vicious cycle that greatly shortens the life of the battery.

And distilled water. It contains almost no metal ions and has a particularly high electrical resistance. Therefore, adding it to a large battery will not cause the battery to self-discharge.

In fact, when added to the battery, the effect is the same whether it is medical or drinking distilled water. They all do not contain metal ions, and the purity and cleanliness of medical treatment are required to be higher, after all, they must enter the human body.

Note that there is also a large barrel of drinking water that is not distilled, but purified. The water is not distilled, but filtered through a reverse osmosis plant, and although pure, it contains metal ions.

Wahaha sold in the world.

Purified water is like this, and the resistance will be less than that of distilled water. In case of emergency, it can also be filled into the battery instead of distilled water. However, because the resistance value is small, the battery will have internal discharge, and there is no problem with charging it every day, if you want to place it for a period of time, you will find that the battery power drops too fast.

It needs to be replenished in time when storing.

Dear Kiss I am happy to serve you There is no way to treat the water in the battery: 1. Use a maintainable battery, that is, a water and electricity battery, plus distilled water or supplementary liquid; 2. The liquid cannot be seen in the tram battery, if the internal liquid shortage is detected by other means, a small amount of distilled water can be added; 3. If a large amount of electrolyte is missing, the battery capacity will be insufficient and the battery needs to be replaced. 4. Remove the battery from the car.

At this time, you should pay attention to the positive and negative poles, don't confuse them, and remember the location. 5. Use a syringe or pen barrel to absorb distilled water or purified water and inject it into six holes respectively. Pay attention to observe the water level when filling the water, and do not go higher than the water line.

Battery water, also known as electrolyte, is dilute sulfuric acid prepared from distilled water and sulfuric acid, which is used to react with the plates in the battery to charge and discharge. The battery water is prepared by special sulfuric acid and distilled water in a certain proportion, if the water is consumed during the use of the battery, pure water can be added to charge.