Old fashioned set top boxes can t receive Zhongjiu satellite programs?

You are the first generation of set-top box** device turned off, you can't receive the program, change the set-top box and high-frequency head to watch the program.

1. The second-generation Zhongjiu satellite receiver can receive part of it, and the first-generation receiver cannot be used.

2. The third-generation machine can watch normally, and 3. The fourth-generation Zhongjiu satellite receiver is Beidou positioning. In the future, this will be the main one.

Then you can only change to a new set-top box, and the old one will not work.

The fake machine in Zhongjiu has been off the air since February 16, 2017, and it can't be watched, and the real machine needs to be inserted into the card to watch. Or the Asia-Pacific 5 and Zhongxing-6B satellites.

The set-top box of Zhongjiu Satellite has not been able to receive the set-top box recently, and the possible causes and solutions are:

1. The plug of the signal cable connecting the set-top box is loose or has fallen off.

Solution: Reconnect the signal cable to restore the signal.

2. The direction of the lid is shifted or the high-frequency head is broken, and there is an obstacle in the direction of the satellite.

Solution: It is necessary to adjust the position of the lid of the small pot accurately, remove the obstacles, and replace the high-frequency head.

3. There is an obstacle in the direction of the satellite antenna.

Solution: Remove the obstacle so that the lid is empty.

4. The signal demodulator of the set-top box is broken.

Solution: Ask a professional to replace the signal demodulator.

If the high-frequency head is broken, there will be no signal quality.

No, a total of 60 programs can be received.

Mine too, can only be retracted right-handed,

1. When purchasing, you must connect with the seller on the spot, and find the star, and you will seriously reply if you don't pay attention to it at that time.

2. According to the orientation and elevation angle of the local seller, find a place where you can install your own pot, and there must be a certain adjustable range.

3. Install the pot according to the seller's appearance, connect the wire, and estimate a large receiving range.

4. Input the parameters on the receiver, if it is Zhongxing No. 9, you will directly enter the star search, ** signal strength and quality, the strength can be 50% to indicate that the wiring is correct, and the equipment is basically normal.

5. When searching, remember that the elevation angle is slowly adjusted from low to high or slowly lowered from high, one time to adjust a little, about 2 degrees at a time. Adjust it once and slowly turn the direction once, but also slowly. If the quality appears, it is basically OK.

6. Repeat the fine adjustment to make the highest quality.

Note: If you are not sure whether your home receiving location can have a signal, don't sell it, otherwise it can't be used, it can't be returned, it costs money, your wife scolds you for being useless, and the child blames you for not asking me to install it.

Summary. The signal strength is the connection between the receiver and the F head of the satellite pot, when the signal strength reaches about 95. Looking at the signal quality is a data indicator of whether the satellite pot is accurate to the star.

In the case of good signal strength, if the signal quality does not reach 80 and there is still no station, in this case, we can try to adjust the position of the pot lid against the signal source until the signal quality reaches about 80. Carefully adjust the angle of the satellite pot to the star. There are three major angles of the opposite star, namely azimuth, elevation, and polarization.

The main azimuth angle, Yangon angle and polarization angle are set by the satellite pot at the factory, be patient, adjust it slowly, and it will definitely succeed.

In this case, the signal is normal, and the program can not be searched, are you slow to readjust the lid of the pot, it may be aimed at the Zhongxing 9A satellite, this satellite has not uploaded the program for the time being, it is the backup satellite of Zhongxing 9, and the life of Zhongxing 9 has reached the point of regret and then transferred to this Bina key satellite for broadcasting, and you need to find the Zhongxing 9 satellite again.

I'm sorry I don't understand, but can you elaborate on that?

The signal strength is the connection between the receiver and the F head of the satellite pot, and the signal strength can reach about 95 when the front is defeated. Looking at the signal quality is a data indicator of whether the satellite pot is accurate to the star. In the case of good signal strength, if the signal quality does not reach 80 and there is still no station, in this case, we can try to adjust the position of the lid facing the signal source until the signal core quality reaches about 80.

Carefully adjust the angle of the satellite pot to the star. There are three major angles of the opposite star, namely azimuth, elevation, and polarization. The main azimuth angle, Yangon angle and polarization angle are set when the satellite pot leaves the factory, be patient, adjust slowly, and it will be successful.

Hello! We're glad to answer your questions! <>

There is no signal in the middle nine satellite cauldron, and there is no station, you can try the following solutions:1Adjust the antenna orientation:

Make sure that the antenna of the satellite pot is facing the correct satellite and is not blocked by obstructions. You can try to adjust the orientation of the antenna slowly until you find a signal. <>

2.Check the antenna connection: Make sure that the connection between the antenna of the satellite pot and the receiving device, such as a TV or receiver, is secure. Check if the cable is damaged and try to plug the cable again. <>

3.Check Device Settings: Make sure your receiving device is set up correctly.

You can check your device's settings menu to make sure the correct satellite and channel are selected. 4.Check the satellite signal:

You can check the strength and quality of the satellite signal by using the signal detection function that comes with the satellite semaphore or receiving device. If the signal is weak or of poor quality, you may need to adjust the antenna position or upgrade the antenna equipment. <>

If you still can't solve the problem after trying the above methods, it is recommended that you contact your satellite TV service provider or technical support team, who may provide more detailed guidance and technical support. If my answer is helpful to you<>

Please also give a thumbs up (comment in the lower left corner), look forward to your like, your efforts are very important to me, and your support is also the motivation for my progress. If you feel that my answer is still satisfactory, you can click on my avatar for one-on-one consultation. I wish you good health and a happy mood! <>

Summary. 1. The plug of the signal cable connecting the set-top box is loose or has fallen off. Workaround:

Reconnect the signal cable to restore the signal. 2. The lid of the pot is shifted in the direction of the satellite. Workaround:

It is necessary to adjust the position of the lid of the small pot accurately. 3. There is an obstacle in the direction of the satellite where the lid of the pot is aligned. Workaround:

Remove the obstacle so that the lid is left open and there should be no obstruction. 4. The signal demodulator of the set-top box is broken. Workaround:

Let the professional master replace the signal demodulator. 5. The high-frequency head connected to the antenna is broken. Workaround:

Replace the normal high-frequency head.

I'm still a little confused, can you be more detailed?

1. The plug of the signal cable connecting the set-top box is loose or has fallen off. Solution: Reconnect the signal cable to restore the signal.

2. The lid of the pot is shifted in the direction of the satellite. How to solve the collapse: you need to adjust the position of the lid of the small pot accurately.

3. The lid of the pot is aimed at the satellite, and there is an obstacle in the direction. Solution: Remove the obstacle so that the direction of the lid is kept open, and there should be no obstruction.

4. The signal demodulator of the set-top box is broken. Solution: Ask a professional to replace the signal demodulator.

5. The high-frequency head connecting the high round wire of the antenna mold is broken. Solution: Replace the normal high-frequency head.