How to clean the earwax of Apple headphones, how to clean the Apple headphone jack

It is recommended to use ordinary facial tissues to add water, ventilate and dry If you are afraid that it will not be clean, you can wipe it several times.

Different earphone cables are made of different raw materials, including ordinary rubber and natural rubber. Remember not to use wet wipes and alkaline detergents, and it is best not to use alcohol, these things can accelerate the aging of the earphone cable, 1. Laundry soap: come back and cut off a small piece and melt it with warm water, then wipe the ear line and data cable with a small amount of solution dipped in a cotton cloth, and finally dry it with a dry towel.

Of course, dish soap, shower gel, etc. are OK, so I won't give examples one by one, and the interface can't be cleaned).

2. Toothpaste: Squeeze out a little toothpaste and mix a small amount of water, then wipe a small amount with a cotton cloth, and finally dry it with a dry towel. (This is washed and a little fragrant, and the interface can't be cleaned).

3. Liquor: Drop alcohol with cotton, wipe along the ear line and data cable, and finally dry naturally. (This can clean the interface, disadvantages: alcohol is easy to age the line, but it has little effect.) )

4. White vinegar: Use cotton to drip white vinegar, wipe along the ear line and data cable, the taste is a bit heavy, and finally wipe the smell with cotton cloth and water. (It's better not to wash the interface).

5. Eraser: I won't explain much about this, but the effect is not bad. (This interface can't be erased).

Take the kind of paper that is not easy to break, dip it with a little water, first buckle most of the paper through the paper with your fingernails, and use a needle or compass or mechanical pencil tip on the edge to pick up the wet paper. Finally, you can wipe the strainer again with dry paper.

I use the kind of paper that is very hard for hand wipes, and it doesn't rot when I scratch it with the tip of a pen.

Ten minutes later, your headphones are a good guy again, and they work in person.

The dust in the headphone jack and charger hole of the iPhone can be cleaned with the help of some small things used daily, such as: toothpicks, transparent glue, and chewing gum.

toothbrushes, etc. Here's how to clean up the dust from the headphone jack and charger hole of your iPhone:

1.Remove the pointed part of the toothpick with double-sided tape.

Wrap compacted, pinch the flat head when cleaning the charging port.

There is no need to pinch the earphone port to clear the earphone mouth, and the double-sided tape can stick out a lot of dust.

2.Fine-bristled toothbrushes, must be fine-bristled toothbrushes can not use hard bristles, gently brush at the headphone jack and charging port, and then use a hair dryer or breath to blow it. This method is often used by many second-hand mobile phones and refurbished mobile phones, and it is also very simple.

3. Some friends will use a cotton swab dipped in alcohol to wipe it, and the alcohol will not leave traces after volatilization, so pay attention to deal with it when the machine is turned off. And don't wipe it with water, as it may cause the phone to get into the water and rust.

4.Use chewing gum, when it is not sweet, pinch it with your hands until the water is almost gone, and cover it on the headphone jack and charger hole to eliminate dust.

It can be cleaned with a small brush.