If you had to put an egg in a plastic bucket, what would you do about it?

Cut a hole in the upper part of the bucket with a blade, so that you can put your hand in it and put the eggs, because the material of the bucket is elastic, so it can basically be restored to its original shape to cover the opening, and after loading the eggs, it is enough to stick it with tape.

It is on the side of the plastic bucket, that is, where the yellow label paper is pasted, cut the plastic, it is best not to cut it all, leave a sticky edge, and then glue the cut plastic and label paper after the eggs are put in.

The method is to open a hole in the upper part of the plastic bucket with a blade, which is larger than a fist, you can put your hand in, the opening is facing up, its material is elastic, as long as it is not damaged (within the degree of elastic deformation), it can basically recover to cover the opening, and after it is full, it is OK to paste it with tape.

Cut an egg-sized hole on the plastic bucket, be sure to cut it vertically, put the egg in it, and then glue it with transparent tape, if you want to be more hidden, open the outer wrapper cut, and then glue the wrapping paper well.

Generally, it is to draw a tuck-shaped opening at the top of the barrel, and the size of the cut is to reach into the hand for the benefit, and cross out the left and right directions. After loading the eggs and other items, glue the scratches with tape.

Wash the bucket, when washing, you can cut a cut at the bottom of the bucket, cut it directly to lift it up and put eggs, after cutting the opening, wash the bucket with dish soap, and then dry the water with paper. Then put the prepared eggs into the bucket one by one, from the mouth of the bucket upwards, until the oil drum is full, then cover, and then seal the bottom of the bucket with tape.

This method is very simple, only three steps: 1. Cut a small window on the side of the plastic bucket with a knife. 2. Put the eggs in and fill the bottle. 3. Then, tie this small window with transparent glue, and that's it. So that the eggs are packed.

In fact, as long as you put it yourself, find a suitable place on the top of the bucket, cut a hole, and put it in just enough by hand, but don't interrupt it all, and then put it in one by one, and put it full.

Cut the bucket from the side, don't cut it all off, then put it on the side, put the eggs into the bucket one by one until the bucket is full, then cover and seal it with tape.

In fact, it is very simple, first wash the empty bucket, then cut a hole horizontally in the upper middle until the bucket can be opened at 90 degrees to put the eggs in, and finally use transparent glue to make the cut glue firm. All in all, cut a cross on the side, and you're good to go.

<> eggs are not stored in the refrigerator without plastic bags. If you use a plastic bag, there are water droplets accumulated in the plastic bag, which gives the eggs a moist environment, and the eggs are more likely to spoil. You can buy a box specifically for storing eggs and put it in the refrigerator to avoid food contact with eggs and keep the eggs well.

This answer applies to most brands of refrigerator models.

Use a plastic bag for eggs in the refrigerator because the surface of the eggs is likely to be contaminated with dust, bacteria or other impurities, and placing them directly in the refrigerator may contaminate other foods. And the impurities on the eggs cannot be washed with water, otherwise the moisture will enter the inside of the eggs through the pores on the surface of the eggshell, which may accelerate the deterioration of the eggs.

Put the eggs in the refrigerator with a plastic bag

Eggs are placed in plastic bags in the refrigerator, and the reason why eggs are packed in plastic bags is because most eggs will be contaminated with dust, bacteria or other impurities on the surface, and wrapping eggs can avoid contaminating other foods in the refrigerator.

It is necessary to be careful not to clean the dirt on the surface of the egg with clean water, because there are many tiny pores on the surface of the egg shell, and washing the egg with clean water will cause the moisture to penetrate into the inside of the egg, and the protective film inside the egg shell will be destroyed, and the egg will become easily damaged.

When storing eggs in the refrigerator, you also need to be careful not to put the eggs with their big heads down, the correct way to place them is to put the big heads up, so that the yolks can float up and stick under the air chamber, so as to prevent microbial invasion.

1. Materials required for the experiment: tape, scissors, plastic stool greeting bottles, raw chickens and eggs. See the image below:

2. Cut the plastic bottle from the middle. See the image below:

3. Take one end close to the bottle cap and set aside. See the image below:

4. Hang the eggs in half of the plastic bottle with tape, the center of gravity should be as low as possible, and the tape should not be tightened, so that the eggs can swing slightly but do not touch the bottle. See the image below:

5. Throw the egg from a height of 3 meters. See the image below:

6. The eggs in the plastic bottle fell to the ground from the same height, but the eggs were intact. See the picture below: Jujube Pie.

On the side of the plastic bucket, which is the place where the yellow label paper is pasted, cut the plastic, it is best not to cut it all, leave a sticky edge, and after the egg is put in, then glue the cut plastic and the label paper.

This container for eggs is really creative, simple and safe. The method is to open a hole with a blade on the upper part of the bottle, which is larger than a fist, you can put your hand in, the opening is facing up, the material of the bottle is elastic, as long as it is not damaged (within the degree of elastic deformation), it can basically recover to cover the opening, and after it is full, it is OK to stick it with tape.

Open a window on the side and place the bucket flat when placing the eggs.

This is a good idea, but it's just as troublesome to take out, and it's easier to break the egg than if you put it in.

There are two ways to put eggs in plastic oil drums:

The first method is to cut a hole in the upper side of the oil drum, so that your hand can reach into it to put the eggs, and the opening should not be too close to the handle of the oil drum, and then seal it with scotch tape.

The second method is to cut an opening at the bottom of the oil drum, put the bottom of the egg upward, seal it with scotch tape after the egg is full, and feel that the oil drum is unscathed from the top after the oil drum is lifted. Cut a round hole in the middle so that you can reach into your hand, and the eggs will not fall out after sealing the scotch tape.

I think the method you said is too cumbersome, and I have a better way to do it.

You can put the bottles on your side, put them one by one, and then gently stand up when they are full.

How to put eggs in plastic oil drums:

Tools: plastic oil drums, scissors, scotch tape.

Steps: Destroy the middle and vertical.

1. Find a plastic oil drum to wash and dry, and prepare a pair of scissors and a roll of scotch tape.

2. Cut a small hole on the side of the plastic oil drum first, which can be put into the egg, that is, Peizhouke.

3. Carefully put the large eggs into the oil drum one by one, and then wrap the tape around the small opening just cut.

In order to prevent the small mouth from cracking during transportation if it cannot bear the weight of so many eggs, you can wrap several more loops of tape.