502 how to wash off tips, 502 how to wash off

Cleaning method of 502 glue:

1. Glue in 502.

Wash quickly when it's not completely dry. When the glue is just dripping on your hands, quickly put your hands in cold water and soak for a few minutes, at which point you can see that the glue has become a solid and can be removed. If the area of the glue on the hand is relatively small, you can wait for the glue to dry before tearing it slowly, but you must be careful in the process of tearing to avoid tearing.

Glue can bond hard objects well, but some flexibility.

Larger ones often have no long-term effect. Therefore, when your two fingers are glued together, rub the glue between the two fingers vigorously, just click on it, mainly to loosen the dry glue.

3. Add a few drops of 502 glue to the wrong and cured parts to melt the original 502, and the cured 502 glue will slowly become soft, and then quickly wash off with water.

4. Use the cover to pour some insulating oil in the transformer, and then apply it to the glue part, the cured 502 glue will soon become soft, and then you can rub it off.

5. Bring a basin of hot water, stick it to the 502 glue you want to remove with a wet hot towel, and the cured 502 glue will become soft after ten minutes. Or soak in tolerable hot water for a while and allow the glue to soften.

Glue is a kind of resin glue, as long as an organic solvent that dissolves the resin, such as acetone, is used.

But acetone is toxic, so don't use it lightly.

7. If there is 771 degel, of course, it is good, use this degel for cleaning, environmental protection, do not hurt hands, and do not hurt the material material.

8. It is said that if you put it in the refrigerator and freeze it, the glue will also fall off. But with wind oil essence.

Nail polish and the like are good, just drop a few drops on the glue-stained area and you'll be done.

Remove the 502 method.

1. There is a hair dryer that can turn the hair dryer to the gear of the hot air, and the white glue marks on the plastic can be removed after blowing soft.

2. If the plastic is not big, you can put the plastic in the hot water basin and sell the beam, soak it at high temperature, and see that the glue traces absorb all the water, and then you can remove it.

3. You can use the method of re-dripping, on the traces of the original glue, re-drip with new glue, so as to cover the original position, and wait for the new glue to soak the traces of the old glue, and then you can remove it together.

4. Put it in the freezer, freeze it, and remove it after the glue hardens.

5. Soak it in Lingyuan white vinegar for about ten minutes to wipe it and remove it.