Desktop hard drive problem, desktop hard drive problem

No! Buy a good box with stable voltage.

It is recommended to back up important data immediately, and then find another computer, remove your hard drive, connect it to the slave disk, and use MHDD under DOS to detect bad sectors on your hard drive. If your hard drive is under warranty, go to the warranty; If the warranty period is exceeded, use the MHHDD's built-in repair function to repair the bad sectors of the hard disk, which is generally not very serious and can be repaired, if the bad sectors are serious and cannot continue to operate, you can find 51recovery.

Now for a brief introduction to how to use MHDD:

1.Run MHDD to enter the main screen.

2.Enter Port (hotkey shift+F3) and select the number of the hard drive that needs to be detected or repaired.

3.Enter scan (hotkey F4), and the default parameter is the detection of non-destruction of hard disk data.

4.Click F4 to start the test. On the right, there is a note explaining what status each block color indicates in the scan screen.

key to interrupt detection.

You can search for other commands on the Internet, recommend MHDD, because this software is the most accurate test, and has a powerful bad sector repair function, but if there are many red blocks, it is recommended to give up, even if it is repaired, it is very unstable, it is recommended to buy a new hard disk, the current hard disk is very low.

The general XP system disc will come with some DOS tools, and there is an MHDD detection software in it, which is very professional in the bad sector detection of hard disks. The operation is also relatively simple. If the bad sector is not in 0% and 1% and still has usable value, isolate the bad sector part and continue to use it, but don't store important information.

In addition, the night that prompts "0x000001d, the location is 0x0103ecd7" or something is not necessarily a problem with the hard disk, and sometimes memory failures will also produce the same kind of prompts, use an eraser to erase the gold finger part, and try to change the slot.

If there is a problem with the data cable, check the data cable.

If conditions permit, you can get an external optical drive. Then install an exclusive notebook system. No, take it to the computer city. Tell them to deal with you.

Go into the BIOS to take a look, or see if the portable cable is plugged in, both wires should be looked, especially the small line!

This is caused by the difference in data transfer speed between the motherboard and the hard disk of desktop and notebook computers. This will not work.