-
Anonymous users2024-02-05Hehe, good Dongdong, learn it.
-
Anonymous users2024-02-04The blue screen of the computer ** is stop:0 0000f4 because of the problem of the memory module, and the specific steps to solve it are as follows:
1. Place the desktop flat on the console, and then use a Phillips screwdriver to remove the set screws of the case.
2. After removing all the fixing screws, put the screws in place, and then disassemble the lid of the case, and you will see the hardware inside the case.
3. The memory module is plugged into the motherboard, there are two slots on the motherboard, open the bayonet at both ends, pinch the upper part of the memory module with your hand, pull it out, take the memory module carefully, do not touch the wire and socket on the side.
4. Put a blank paper on the table, put the memory module on it, and then gently wipe the gold finger with an eraser, first wipe the front, then wipe the back, and then remove the dust. Description: The gold finger is the yellow metal part of the memory module, the memory module is afraid of water, greasy, dust, and static electricity, so you should be extra careful when operating.
5. After wiping the memory module, you have to reinstall it in the card slot, plug it in again, plug it in tightly, card the safety bolt, and then plug in the power supply of the computer. Then install the back shell and screw it.
-
Anonymous users2024-02-03The reasons and how to deal with the blue screen that cause your computer to always be blue are as follows:
First: If your computer often has a blue screen, whether you reinstall the system, or later reinstall the system, or the blue screen still appears, it means that the hardware is causing the problem. The one that directly affects the hardware of a computer is the memory module or graphics card.
The cause of the problem is the blue screen phenomenon caused by the oxidation of the gold finger of the memory module or graphics card or the poor contact of the slot. Solution: You can turn off the power first, open the computer case, dial out the memory module, use the eraser to wipe the part of the gold finger (that is, the place where there is a copper sheet) back and forth a few times, and then insert a memory slot back, and you're good to go.
If this is still a blue screen, you have to check the graphics card, explain that it is a problem with the graphics card, and also use the same method as above to do it, and you can do it. Generally, 80% of computers can solve the problem.
The second type: is the hard disk has a bad sector, when the computer reads the bad sector, it is stuck, the background is still running, the CPU occupancy is immediately very high, and then the blue screen, processing method: under normal circumstances, it is repaired with HDD, if it can't be repaired, which can only change the hard disk.
The third way: that is, the video memory chip of the video memory and graphics card appears virtual soldering, and the blue screen will continue to appear, the method is to add solder to the video memory.
Fourth: the computer is poisoned, causing the memory to enter the virus, destroying the operating system, causing the system to be unable to boot, it has been a blue screen, can only reinstall the system, or press f8 to boot up, enter safe mode, open the control panel, delete the latest updated patches and drivers.
Fifth: It's because of illegal shutdown, such as power outage, forced shutdown, or sudden crash, after turning on the machine, it will be self-checked, and it is also a blue screen, in the countdown, in general, let it read it by itself, it's fine. It may waste a little time, but it must read it by itself, because this is the process of checking the disk by the hard disk, and generally the first time it has been read, it will not appear next time.
Don't stop with ESC, or you'll have a blue screen next time, do it all over again. If you want to self-test every day, you have to start --- chkntfs t:
0", the general problem is solved.
Before doing the above, it is best to restore the BIOS of the motherboard to the factory value, or you can discharge the motherboard battery, that is, remove the battery, wait for 20 seconds and then install it back, or connect the jumper to two or three, which is conducive to eliminating strange phenomena caused by the disorder of the motherboard BIOS.
The second of these is the one with the highest probability of causing a blue screen, and if you don't try to use it, 80% of the computer will be fine.
-
Anonymous users2024-02-02Enter BIOS to set the hard disk mode to IDE, if it can't be solved, please explain the problem in detail.
First of all, I will teach you a way to quickly get out of the desktop icons. >>>More
You've already paid your rent for February, which means you can stay until February 28th. But you moved out on the 14th, according to the convention, the landlord needs to return your money, you don't want the money, the landlord will ask you for a month's rent compensation. >>>More
I found you some installation methods for windows7, you can try it. >>>More
Books can basically be bought, except for the books of (19-1)x, the specific method: >>>More
Your mother is protecting you, she is afraid that the man will touch you, and you will be there...What if I get pregnant...And in this society now, who can say well, in case you are separated in the future, what will other men think of you...Moreover, if your mother lets you go, the man will think that you are easy to get, and the man's family or others will think that your mother has not taught you well and that there is no tutor.