The network drops and the broadband connection disappears

Is this your cat downstairs? Or is it just the line going over the electric kettle?

We recommend that you do so!

This shouldn't be a problem with poisoning.

One. If boiling water can affect, 1Change the cat to a slot, which is caused by typical voltage instability.

2.If it's not in a slot, don't put the cat near the refrigerator, water heater, cell phone, TV, which all have an effect on it.

Two. Line problems, 1If it is a line at home, reproduce the roots, try not to get close, because the home is a single wire, not a cable, and the radiation ability is not so strong.

2.It is the outside of the line to the computer near the home inside, in the connection cat, call ** to the communication company to ask to check the line.

If none of the above works, it is recommended to call ** to the communication company to warrant.

Not poisoning. Caused by unstable voltage, it must be OK if the movie is stable

Or burn the computer and the cat.

Both are voltages.

It was very hot the other day.

That's the case in my area.

Problem 1 is because the voltage amplitude of the mod (which can't be played) is not enough.

Question 1: It's not poisonous.

Question 2: Is it burning that thing that affects the voltage, and the cat is also disconnected, you have to turn off the cat, and the computer will be broken if there is damage, and the cat is also very bad.

1. Check whether the network cable is loose.

For most broadband users, ADSL is the most common way to connect to the wireless router, and when the connection is dropped, the first thing we need to consider is the line problem.

Due to the fact that the first line is too long, there are too many connectors, or there are some interference sources, it is likely to cause the line to drop, and the network cable that is inferior and does not meet the standard often causes network instability, so when you find that the line is dropped, you must first check whether the network cable interface is loose.

If you find that the network cable interface is intact, you should check the problem with the power signal light.

Second, whether the power signal light is always on.

If the power signal light is not on, the first thing to check is the power supply. For example, whether the connection is disconnected due to the unstable power supply of the mains, whether there is a problem with the power supply of ADSLMODEM itself, etc.

Touching the ADSLMODEM shell with your hands, it feels very hot, at this time, you may wish to temporarily turn off the ADSLMODEM until it cools down before turning it on, or place it in a more ventilated position, which can also eliminate the disconnection fault.

3. Check whether the data signal is normal.

If the data signal light is not on, it is likely that the line is open, short circuit, etc., and then pass the ** test to see if the line is normal, if not, you can ask the technician of the ADSL service provider to solve this problem.

If the data signal light is flashing, it is likely to be caused by poor line contact, you must check whether the extension is used, whether the connector is firm, whether the ADSL connection line is too long, etc. If the data signal lamp still does not turn on after checking the above steps, the fault is not related to the line, and you can continue to look for other reasons.

1. The reasons that may cause broadband disconnection are: unstable power supply voltage, static electricity of computer network card chassis, computer poisoning, system software failure, etc., it is recommended that you give priority to self-inspection or ask computer maintenance personnel to assist you in troubleshooting.

2. You can first check whether the modem and splitter hardware are faulty, whether the splitter connection is correct, whether the modem is compatible with the network card, and it is recommended that you replace other modems to observe the usage.

3. If the disconnection is related to the application server while playing the game, it is recommended that you contact the game provider for verification.

4. If the above operations are invalid, you can choose the following methods to report the fault

1) Dial 10000 and select 4 to report broadband faults;

2) Feedback to China Telecom QQ customer service 800010000 through computer or mobile phone;

1. Eliminate the problem of network cable or the problem of contact between the crystal head and the connection.

2. It may be a problem of voltage that causes the broadband cat to be heavy and cause the connection to drop, find a multimeter to test the voltage to see if it is normal.

3. Excluding the above two reasons, it may be caused by the incompatibility of the speed configuration of the computer network card and the Ethernet port of the up-connected device, you can try to change it as follows:

Right-click Neighbor on the Net Attribute Right-click Local Connection Attribute General Configuration Advanced Connection Speed and Duplex Mode, change the original "Adaptive" to "10M Full Duplex", and the problem can be solved.

Here's how:

1. First of all, we should check whether there is a problem with our network cable, first detect whether the connection between the network cable and the chassis is loose, and then see if the network cable is damaged, such as aging the network cable or being bitten by rats.

2. After making sure that there is no problem with the network cable, go back to the computer desktop and find the "Computer" icon, and then right-click and select the "Manage" option.

3. After opening the "Manage" window, we click on the "Device Manager" option from the list below.

4. After opening the option, then find the "Network Adapter" option and turn it on.

5. Select the network card we use from the drop-down table opened by the "Network Adapter" option, and finally right-click on the properties, click "Advanced" navigation in the pop-up interface, and select "Connection Speed and Duplex Mode" in the attribute list below, and then select "10Mbps Half-Duplex" in the "Value".

6. Restart the computer and turn it on to see if the network will be disconnected.