The time after booting is long The boot time is long

Updated on number 2024-02-09
7 answers
  1. Anonymous users2024-02-05

    Because there are so many programs to run.

    Just clean it up with an online assistant software.

  2. Anonymous users2024-02-04

    There are too many programs and services loaded when you boot up.

  3. Anonymous users2024-02-03

    If the screen is black, there are many situations, so you have to check them one by one.

    1: The black screen is likely to be a problem with the graphics card driver, or it is possible that the graphics card is not in normal contact. This needs to be taken to a special computer repair area.

    2: It may be that the system starts slowly, because there are many startup items to be closed at boot, and it takes time for the system to start. Therefore, it is recommended to use Kingsoft Guardian to prohibit unnecessary startup items.

    3: It may be the failure of the system itself, this depends on whether the problem is serious or not, there is a master of reloading in the Jinshan Guard, if it doesn't work, reinstall it

  4. Anonymous users2024-02-02

    I think it should be a problem with the hard disk I took a look at the side The SATA port of this technology blocking Li Jia's motherboard is 6GB s speed Your hard disk is 3GB s speed Change the SATA in Bois to the same transfer speed as your hard disk It should be normal to boot Xiangheng Oak.

  5. Anonymous users2024-02-01

    Install Optimizer, open it, select "Automatic Optimization", and select it according to the situation.

  6. Anonymous users2024-01-31

    Let's reinstall the system.

    This configuration should be powered on within 1 minute.

  7. Anonymous users2024-01-30

    Hello, if it gets stuck when you turn it on, it's basically caused by the hard disk reading disk scanning too card! If you confirm that there are not too many programs that are excluded from boot startup items and running, that the computer is not hot or hot, and that you usually optimize and clean up the system frequently, then it is estimated that there is a problem with the mechanical hard disk. If the hard disk is fragmented or the bad sector is exceeded, it will cause self-test and disk reading and scanning difficulties during startup and runtime, and the machine will be seriously stuck!

    It is recommended to use Master Lu to do a deep defragmentation of the C disk, and after doing it, detect the bad sector of the hard disk (open the hardware physical examination --- the lower right corner of the "disk physical examination" check by ---Master Lu), if it still does not work normally, you have to reinstall the system, (note that if you reinstall the system, you must reformat the partition to avoid the bad sector, which is very important!!) In this way, the hard disk space will be slightly reduced, but it will not affect the use, and then you will have to replace the hard disk with a new one. Hope it helps!

    If you know a lot about computers, you don't need to look at it, so as not to waste your precious time! )

    The problems caused by slow computer boot, running card, frequent crash, reboot and other problems are mainly caused by relatively low configuration and lack of attention to cleaning and optimizing the system. If there are too many boot items, too much garbage, small memory, low graphics card performance, poor heat dissipation, virus attack, malicious program running, and hardware overage performance degradation, you need to investigate and deal with them one by one.

    1. Commonly use [360 Antivirus] and [360 Guard] and upgrade the virus database to the latest to optimize cleaning and antivirus;

    2. Reduce the startup items (except for the input method. Anti-virus software can be closed), uninstall C drive infrequently used programs;

    3. If the memory is small, the virtual memory should be set to a larger size, expand the space for data processing, and upgrade the memory module if necessary;

    4. Regularly defragment the hard disk (mainly C disk) to shorten the hard disk reading time and improve the scanning speed;

    5. Do not install the application software on the C drive, and try to classify and package the icons and files on the desktop to shorten the scanning time;

    6. Regularly use professional software such as [Optimizer] or [Super Rabbit] to optimize the operating system and network connection;

    7. It is recommended to install only one anti-virus software, as installing more will occupy computer resources and make the computer slower, and may also cause conflicts;

    8. The machine should be dismantled regularly to clear the ash, if you need to force heat dissipation, you can consider installing an auxiliary cooling fan, and add a heat dissipation pad for the pen and large loose notebook;

    9. The C disk will become slower and slower due to the larger and larger the computer for a long time, and it is recommended to restore the rolling system or reinstall it every 2 years; "

Related questions
11 answers2024-02-09

Here are a few things you can do to get started:

1. Is the power supply properly and securely connected? >>>More

15 answers2024-02-09

The motherboard battery is dead. It's that coin cell battery on the motherboard. It seems to be c2032 >>>More

16 answers2024-02-09

First of all, let's correct it: the CPU rotation is wrong, to say that the CPU fan is rotating. If the CPU is transferred, it will be troublesome, and the following questions are: >>>More

9 answers2024-02-09

Floppy disk error. CMOS Checksum Error - Loading default settings. >>>More

18 answers2024-02-09

1.As an administrator, log in to the Control Panel - User Accounts - select Remove Password. >>>More