The bear children at home put stickers everywhere, how to quickly remove the stickers from the wall

There are a lot of children's stickers on the clean walls of the house, some sticky, relatively strong stickers, when you remove them, they will leave unsightly marks on the walls, you can use a hair dryer to blow the wallpaper hot, so that it is easier to remove without leaving a trace. One more thing is that even if you uncover the stickers, children will often put new ones on the wall when you are not paying attention. In other words, the matter is repetitive, unless the children lose interest in the matter one day.

The first step is to set the hair dryer to low temperature, and the first thing we need to do is dry the stickers with a hair dryer. There's no need for a high-end hair dryer, any regular hair dryer can do just that, set the hair dryer to the minimum setting, and point the sticker at the wall about 6 to 8 inches. Also, if you have a heat gun, you can use it instead of a hair dryer.

Just set it low and move it 6 to 8 inches from the front and back of the wall.

You can use our hair dryer to blow wall stickers with a hair dryer. This is very good to remove our wall stickers, the use of the hair dryer is really quite a lot, as long as you use it well, it will be very clear about the stickers on the wall, so that our walls are as clean as new, without leaving a trace, this kind of trick you can try.

Once touched, it can be peeled off the wall. Start in one corner and slowly move to another. The whole process is slow, or you risk peeling off the stickers or sticking the paint to the wall.

It should be noted that if it is not easy to peel the label off the wall, you will need to use the hair dryer for a few more seconds. Then try a corner. If it can be opened, pull it down slowly.

You can soak the sticker first, then scrape it with a knife, and you can quickly remove it from the wall cabinet.

You can use a hair dryer to blow it, this is easy to remove after heating, do not buckle hard, and you must be patient.

Is there a better way, in the end, they said that they used that heating method to let it dry out and it would fall off on its own.

If you blow it with that hair dryer, it will be easy to tear off after being heated, so don't scrape it with a razor.

There is a hair dryer to blow for a while, and rub it with baking soda and white vinegar and white wine.

You can wait for the sticker seal to dry, and then buckle it off, you can't scrape it with a knife, it will scratch the cabinet.

As long as you want to get it off with glue, you can basically use a hair dryer to blow it down.

It can be moistened with water and scraped off with an iron ruler.