Why does it take a long time to boot into the desktop to run the program properly

Manually setting the IP address for the local connection in the network connection can solve the problem that the power is stuck in tens of seconds due to automatic IP acquisition.

Does your computer run automatically when it is turned on, such as QQ, Feixin.

If there are too many, set it off.

Click Start: Run msconfig Select Start Select Disable All. Only one ctfmon in the startup item remains

This is an input method. Click OK and it's OK. Restart your computer.

Let's see if it will be a little better.

Maybe you have too many startup items. It will take a long time to load those programs at first.

Are there a lot of boot items? Do a disk check to clean up the IE cache and system junk.

360The display itself is not very accurate, don't pay too much attention to the 360 boot time display, you can do a system optimization, such as using Master Lu, or Windows Optimizer, there is also a possibility that there is a bad sector on the hard disk may also cause this phenomenon of super slow boot speed.

See the change system. It's that the system you use doesn't work, the boot bar rolls for too long, and the driver he scans and loads doesn't fit the hardware. It's okay to change it, the pirated ones have been changed, so let's change it again.

Are you a single computer? Or join the LAN, if you join the LAN, it may be because of group policy or resolution problems! If it's a single computer, see if there is any service software installed!

Isn't there a worry in 360 miles?

Turn off any extra startup items.

It takes 10 minutes to enter the desktop when the Windows is booting screen is displayed, and the computer is slow to respond for the following reasons

1. It may be that there is a problem with the program that starts automatically when the computer is started, including anti-virus software, etc.;

2. Medium virus;

3. System failure, or drive problem;

4. Hardware problems.

Here's how to fix it:

After entering the system - my computer - properties - hardware - device manager - ide ATA ATAPI controller in the secondary IDE channel, the main IDE channel in the properties - the device type in the advanced settings is selected as none, pay attention to set the device 0 and device 1 to none (some of the display is gray so you don't need to change it) after changing it, restart it is not very fast to go in!

Generally speaking, this situation is likely to come from the hardware, especially the hard disk, after your boot screen, the system will assign a drive letter to your hard disk, if there is a problem with the hard disk (not necessarily the disk bad sector), it is possible to get stuck there and cannot enter the next step, of course, there are other reasons that will cause this to happen, you need to carefully observe and check one by one to determine which cause it.

Your machine is very old, and my boss's old machine will take a minute. It took more than 3 minutes just to boot up the necessary files of the system. It's getting slower and slower, and it's only getting better when I unloaded Norton recently.

Clean up the startup items and install a 360 to clean up.