Is the inner and outer screen of Sony Z3 integrated?

Of course, it's one, 800 yuan of maintenance**, it shouldn't be after-sales maintenance, 800 yuan is still acceptable.

Of course, it's one, and it's a lot of money to repair and change the screen within 800 is acceptable. More than 800 for iPhones.

Of course it's one. SonyZ3It has a one-piece glass material body,The beautiful appearance is exciting,But this appearance is also relatively weak,Scratches on the surface of the fuselage may be inevitable,And the screen is even more annoying if it is accidentally broken。

Well, it's one! If you change the screen, the cost should be 800---1k!

It's a three-layer composite screen, but you have to change it together.

No, if you can't be sure, ask for his parameters!

As far as I know, the Z3 should not be an integrated internal and external screen.

There is no way, the Z3 touch screen and the display screen are combined, and they can only be changed inside and outside together.

If your machine is licensed, it is recommended that you take the official warranty route.

If your machine is a parallel import, or the official ** is high, you can go directly to the nearest electronic city to replace, your inner screen is good, you can deduct part of the money of the new screen.

Z3 is waterproof, you repair this time, it means that it can't be waterproof in the future, use it carefully!

The original internal and external screens are about 800, and the other is the screen that is pressed after the change, which is about 300.

After pressing the screen, it is only the outer screen that is damaged and then packaged to a professional factory for the second pressure touch screen).

If you refer to the edging that is part of the bezel then the z3 has.

If you refer to the black edge of the screen within the bezel in a general sense, but the black edge of the image cannot be displayed, then the black edge of the Z3 is basically not visible, the width of the black edge of this screen is determined by the cost of purchasing the display screen, the cheap black bar is wide, the higher the cost, the narrower the black edge Including Z3, the screen of all Sony flagship models in recent years is almost invisible Ultra-narrow black edge, and you look at the cheaper models, such as T2 C3, the black edge of the screen is very wide.

I suggest you change your phone, it's a common problem, it's not sure when it will appear again.

Hello. It must be that the capacitive screen itself is broken.

Because the crack is on Gorilla Glass.

A set of original screens + bezels is 900 1100 satisfied.

It should be the screen that consumes power, and the screen has always been a big power consumer, which is normal.

Sony Z3 phone disconnected.

There are basically two reasons.

Either the machine is immersed in liquid and the screen is broken.

Either the LCD screen is partially damaged and the contact is broken.

The workaround is to replace the screen.