The interface of the mouse motherboard is broken, how much does it cost to replace it with a new one

Eldest brother. A matter of a few dozen dollars.

What is the interface of your mouse? Change the interface of the mouse.

Looking at your description, I think your problem should not be a short circuit inside the PS2 interface, it is likely that there is a problem with the peripheral circuit of the PS2, take it to a professional motherboard repair shop to repair it, a small problem, at most change an IC chip, you will not be asked to change the PS2 interface, unless it is the PS2 interface due to physical damage caused by human factors, you need to change the interface, which can be seen on the surface. In fact, even if you change the PS 2 interface for professional maintenance personnel, it is a piece of cake, you can get it in 5 minutes, this problem is also a common fault for you, and it doesn't cost much to repair, generally about 30 yuan, you don't need to change the motherboard to make it so exaggerated.

You can find a computer repair company to repair it, there is no need to change the motherboard, if you do, it will not be a big loss. Is it ???

Take it to the repair point! It's usually repairable!

The mouse interface is broken, you are **, I'll help you get it, come to me.

Although the production standards (the material of the wire, that is, the wire color, the number of cores) are the same, but because the mouse chips of different manufacturers are different, the output circuit is also the same, so the work you do is equal to useless work (unless you understand what the program written by each chip is like), if it has been connected for a long time, be careful not to burn the mouse port on your motherboard.

Hehe, brother, 30 yuan for a photoelectric one, the money is not enough, I'll give it to you.

...You can take it all by being fierce.

Pick it up and notify me to get down.

As long as you press the color pair, it should work.

Depending on your supplement, there may be a problem with the internal wiring of the mouse.

Since the line closest to the mouse often swings, it is easy to break.

You can open it and take a look, or cut it from the inside, leave a little, and connect the plug that can be used, paying attention to the insulation between the wires.

I've done this before.

It can be connected, but it cannot be connected according to the color of the thread.

It should be possible, the lights are on, you may have bought a defective product, the laser head of the mouse, see if there is anything in the way, or hang the flowers, it really can't be done, just go and buy another one, it's not very expensive.

Physical failures go buy a new one and it's gone.

It can't be used. It is very troublesome to weld wires like this one by one.

Are you in front or behind. If it is the front, it is estimated that it can be changed, and if it is the back, there is no need to change it. It's not worth it.

Changing the motherboard is not so serious. How much is a dozen.