How to connect the reversing image line when it is cut? 30

This wiring is simple. The line that transmits the best signal is the coaxial cable, which we simply understand and is the same as the cable of the CCTV at home. After this kind of wire is opened, there will be two layers of sheath, and the outer sheath protects a circle of copper wire (shield, which can be understood as a negative electrode).

Looking inside, there is a white sheath wrapped in a copper core (which can be understood as a positive electrode).

You just dial the disconnected wires and connect them accordingly, and that's it. Please note: If possible, it is best to solder the copper wire (shield) on the outside and the copper wire on the inside of the white sheath with a soldering iron.

If you don't have a soldering iron, use a knife to scrape the two layers of copper wire respectively, because the outer diameter of some cables contains a protective insulation layer, the purpose of scraping is to make the reconnected wire better contact, and then tie the insulating tape on the line, no trouble! Hope my opinion for you to give it a try, absolutely no problem!

Isn't the color of the thread very pretty.

Hello, you can pick it up, if you don't know how to pick it up, it's best to drive to the repair shop to the master to help you pick it up.

It shouldn't be able to be connected, and this kind of wire is generally anti-interference.

You can just match the color of the thread! Conditionally weld it!

It's hard to pick up, so buy another thread!

There are five threads. Wiring method:

3.Connect the red cable with the brown wire, which is the power cord for the reversing camera.

4.Connect the two red connectors, which are the power cables for the camera on the back.

Wiring diagram of the reversing camera camera.

There are five threads.

Wiring method: 3. Connect the red wire with the brown wire, which is the power cord of the reversing image.

4. Connect the two red connectors, which are the power cords of the rear cameras.

How should you install the reversing camera by yourself, Brother Meow said that the car scene teaches you how to install the reversing camera by yourself, you must pay attention to these details when wiring, the joint is handled in accordance with this method to prevent loosening, after installation, pay attention to debugging the central control screen, the signal input is selected wrong, and the effect is greatly reduced.

There are several of these wires, but it's a plug, just plug it in, it's not a wire.

Just two wires, power cord, and ground wire connected to the reversing light.