Can the apple 4s be turned on and charged, the apple 4s has not been used for a long time, can it be

Of course, you can plug in the cable and charge it when you turn it on.

Apple 4s has not been used for a long time, can it be turned on by recharging.

Hello, dear, I'm glad to answer for you, the Apple phone can't be turned on for a long time. Some users buy a new iPhone and use their old phone no longer necessary. If the old phone runs out of battery and is left on hold for a long time, it is likely that it will not turn on or even continue to use it when you take it out again.

This is mostly due to issues caused by an over-draining iPhone battery. At this point, you need to plug your iPhone into a power source, charge it for 20 minutes or more, and reach more than 5% battery level for it to turn on properly. 1.

Do not fully charge or fully discharge, the device should be charged at around 50%. If you store an aluminized liquid discharge device while the battery is completely depleted, the battery may fall into a deep discharge state, resulting in the consequence that it cannot be recharged. On the other hand, if you store a fully charged device for a long time, you may lose part of the battery capacity, thus shortening the battery life.

2.Power off the device to avoid additional battery usage. Liang Wu 3

Keep the device in a cool, not humid environment with a temperature below 32°C. 4.If you plan to store your device for more than six months, you should charge it to 50% every six months.

I hope mine can help you and I wish you a happy work and life!

When the Apple 4S is charging, pressing the power button will not automatically turn on, you need to wait for some time before trying to turn it on.

If your Apple 4s has been charged and has enough power, but won't turn on, here are some possible ways to fix the problem:

1.Press and hold the power button and the home button at the same time and hold it for about 10 seconds until the apple icon appears. This usually fixes most boot issues.

2.If the above methods don't work, you can try to reset it with iTunes. Connect your iPhone to the computer, launch iTunes, press and hold the Power button and the Home button at the same time until the reset mode appears.

3.If the above method cannot resume booting, it may be caused by hardware problems, such as excessive battery wear or other failures. At this time, you need to take the device to an Apple authorized service center for a professional technician to check and repair it.

In a word, when the Apple 4S is charging, you should first try to press and hold the power button and the home button at the same time to restart, if it still won't turn on, you can try to use iTunes to fix it, or send the device to an Apple service center for professional help.

Hello, when the Apple 4S is charging, you can press and hold the power button on the side of the phone until the Apple logo appears, and the phone will turn on. If it still doesn't turn on after charging for a long time, you can try to use a different charger or replace the battery, or contact Apple customer service for repair. In addition, it is recommended to use original chargers and data cables, avoid using non-original accessories, and avoid damage to the phone.

At the same time, you should also pay attention to the power of the mobile phone to avoid the power being too low or too high, which will have a bad impact on the mobile phone.

Hello, when the Apple Beard Fruit 4S is charged, it will usually turn on automatically. If it still won't turn on after charging, you can try the following methods:

1.To confirm that the charger is working properly, it is recommended to use the original charger or a certified charger.

2.Check that the charging cable is firmly connected, and you can try to replace the charging cable.

3.Try using a finger hard reset method by holding down the Home button and the Power button at the same time until the Apple logo appears, then release the key.

4.If none of the above methods work, you can try to connect your phone to your computer and use iTunes to restore or upgrade.

If the above methods still do not solve the problem, it is recommended to contact Apple after-sales service or go to an Apple authorized repair store for repair.

Boot steps for Apple 4S charging:

1. Connect the power cord to the Apple 4S charging port first, and check whether the charging voltage is correct;

2. Press and hold the power button and wait for 5 seconds;

3. When the Apple logo appears on the screen, it means that the Apple 4S has been turned on;

4. Take the power cord out of the mobile phone, and the Apple 4S can be judged to be used normally.

The correct way to open a comm on an Apple 4S mobile phone should be to directly click the power button on the top of the iPhone4S and press it short. However, if your mobile phone can't be turned on, you can first connect the original charger to charge for half a few cores, and then press and hold the power button for 10 seconds to check whether it is turned on.

First of all, charge the mobile phone Hail Land and charge the power source.

Then plug one end of the data cable into the interface of the mobile phone, and the other end of the data cable is not connected to the computer first.

After connecting the phone to a port with the data cable, press and hold the home button at this time.

Press and hold the home button, then connect the other port of the cable to the computer.

Hello, because the equipment is different, the cause of the failure is also different locks, it is recommended to eliminate them one by one according to the following methods, if not, it is a hardware problem, not to be able to solve it yourself, it is recommended to send it to the maintenance point for testing.

Poor contact:

If the interface of the mobile phone and the charging cable are not connected, the mobile phone may not be charged, check it;

First see if there is any foreign object blocking in the bottom interface of the mobile phone, if not, look down;

Computer Charging:

If the above method does not work, you can connect the mobile phone with a data cable to the computer to see if it can be charged, if it is sure that there is a problem with the mobile phone charger;

Replace the power or data cable:

If none of the above methods work, we can use the replacement method to change the data cable to try it, this can be a problem with the data cable;

Turn off and on:

If you still can't solve other problems, turn off your phone and take a look, it may be a common problem with smartphones;

Reasons for temperature:

The battery is very sensitive to temperature, so if your phone feels very hot, let's put it aside to cool down and see if it can be charged.

Hardware failure:

If the battery is broken or the charger is broken, it can only be replaced or sent for repair.

1. After the iPhone is depleted, you need to wait for the charger to be charged with a certain amount of power, and the phone will automatically turn on.

2. If the data cable connection to iTunes logo appears on boot, it means that the system is damaged and you need to restore the system by flashing the firmware through iTunes.

1.Install iTunes. Launch iTunes.

2.Plug in your iPhone, press and hold Power (power button) and Home (circle button below) for 10 seconds, wait for your iPhone to go black (as a rule of thumb, probably after a second after the black screen), release the Power button, and keep holding it until iTunes recognizes your iPhone.

3.At this time, Windows will first discover some new hardware and drive it by itself, and a prompt box will pop up after iTunes automatically recognizes the iPhone. "iTunes has detected an iPhone stuck in recovery mode, you have to restore this iPhone and then use it with iTunes.

At this point, click OK.

4.Open iTunes, display the cross-section of iPhone capacity and information, click Recover, and start the recovery process.

5.Until a cable connection screen is displayed on your iPhone, iTunes prompts that the firmware restoration is complete.

Your Apple 4s is not the battery runs out and automatically shuts down, if so, please wait patiently for a while.

This is because the voltage is not enough, which can be solved as follows:

1. It is recommended to change the charging socket, if it was originally plugged into the computer to charge, change the mobile phone to the socket to charge.

2. Turn the screen brightness of your phone to the darkest, turn off the background running program, or turn on the airplane mode, and then plug in the charger again to charge.

3. The charging head is aging after a long time or the interface is dirty: this situation will also cause the output to be too low, and you can change the charging head. Take a thin piece of metallographic sandpaper and cut it out of the appropriate size, fold it in half a few times, gently rub it in the interface a few times, and then replug it into the charge.

Maybe it's a fake, **I've never heard of this situation, and**the battery pattern on the shutdown charging screen is solid.